273 research outputs found
Use of tunable nanopore blockade rates to investigate colloidal dispersions
Tunable nanopores in elastomeric membranes have been used to study the
dependence of ionic current blockade rate on the concentration and
electrophoretic mobility of particles in aqueous suspensions. A range of
nanoparticle sizes, materials and surface functionalities has been tested.
Using pressure-driven flow through a pore, the blockade rate for 100 nm
carboxylated polystyrene particles was found to be linearly proportional to
both transmembrane pressure (controlled between 0 and 1.8 kPa) and particle
concentration (between 7 x 10^8 and 4.5 x 10^10 mL^-1). This result can be
accurately modelled using Nernst-Planck transport theory. Using only an applied
potential across a pore, the blockade rates for carboxylic acid and amine
coated 500 nm and 200 nm silica particles were found to correspond to changes
in their mobility as a function of the solution pH. Scanning electron
microscopy and confocal microscopy have been used to visualise changes in the
tunable nanopore geometry in three dimensions as a function of applied
mechanical strain. The pores observed were conical in shape, and changes in
pore size were consistent with ionic current measurements. A zone of inelastic
deformation adjacent to the pore has been identified as critical in the tuning
process
Gold colloidal nanoparticle electrodeposition on a silicon surface in a uniform electric field
The electrodeposition of gold colloidal nanoparticles on a silicon wafer in a uniform electric field is investigated using scanning electron microscopy and homemade electrochemical cells. Dense and uniform distributions of particles are obtained with no aggregation. The evolution of surface particle density is analyzed in relation to several parameters: applied voltage, electric field, exchanged charge. Electrical, chemical, and electrohydrodynamical parameters are taken into account in describing the electromigration process
Electrochemically controlled growth and positioning of suspended collagen membranes
Two independently recognized in vitro polymer aggregation variables, electric field and pH, can be used in concert to produce suspended membranes from solutions of type I collagen monomers, without need of a supporting substrate. A collagen network film can form at the alkalineacidic pH interface created during the normal course of water electrolysis with parallel plate electrodes, and the anchoring location can be controlled by adjusting the bulk electrolyte pH. Electrosynthesized films remain intact upon drying and rehydration and function as ion separation membranes even in submillimeter channels. This approach could benefit lab-on-a-chip technologies for rational placement of
membranes in microfluidic devices
Modified critical correlations close to modulated and rough surfaces
Correlation functions are sensitive to the presence of a boundary. Surface
modulations give rise to modified near surface correlations, which can be
measured by scattering probes. To determine these correlations, we develop a
perturbative calculation in deformations in height from a flat surface. The
results, combined with a renormalization group around four dimensions, are also
used to predict critical behavior near a self-affinely rough surface. We find
that a large enough roughness exponent can modify surface critical behavior.Comment: 4 pages, 1 figure. Revised version as published in Phys. Rev. Lett.
86, 4596 (2001
Correlation functions near Modulated and Rough Surfaces
In a system with long-ranged correlations, the behavior of correlation
functions is sensitive to the presence of a boundary. We show that surface
deformations strongly modify this behavior as compared to a flat surface. The
modified near surface correlations can be measured by scattering probes. To
determine these correlations, we develop a perturbative calculation in the
deformations in height from a flat surface. Detailed results are given for a
regularly patterned surface, as well as for a self-affinely rough surface with
roughness exponent . By combining this perturbative calculation in
height deformations with the field-theoretic renormalization group approach, we
also estimate the values of critical exponents governing the behavior of the
decay of correlation functions near a self-affinely rough surface. We find that
for the interacting theory, a large enough can lead to novel surface
critical behavior. We also provide scaling relations between roughness induced
critical exponents for thermodynamic surface quantities.Comment: 31 pages, 2 figure
C5b-9 membrane attack complex formation and extracellular vesicle shedding in Barrett's esophagus and esophageal adenocarcinoma
The early complement components have emerged as mediators of pro-oncogenic inflammation, classically inferred to cause terminal complement activation, but there are limited data on the activity of terminal complement in cancer. We previously reported elevated serum and tissue C9, the terminal complement component, in esophageal adenocarcinoma (EAC) compared to the precursor condition Barrett’s Esophagus (BE) and healthy controls. Here, we investigate the level and cellular fates of the terminal complement complex C5b-9, also known as the membrane attack complex. Punctate C5b-9 staining and diffuse C9 staining was detected in BE and EAC by multiplex immunohistofluorescence without corresponding increase of C9 mRNA transcript. Increased C9 and C5b-9 staining were observed in the sequence normal squamous epithelium, BE, low- and high-grade dysplasia, EAC. C5b-9 positive esophageal cells were morphologically intact, indicative of sublytic or complement-evasion mechanisms. To investigate this at a cellular level, we exposed non-dysplastic BE (BAR-T and CP-A), high-grade dysplastic BE (CP-B and CP-D) and EAC (FLO-1 and OE-33) cell lines to the same sublytic dose of immunopurified human C9 (3 µg/ml) in the presence of C9-depleted human serum. Cellular C5b-9 was visualized by immunofluorescence confocal microscopy. Shed C5b-9 in the form of extracellular vesicles (EV) was measured in collected conditioned medium using recently described microfluidic immunoassay with capture by a mixture of three tetraspanin antibodies (CD9/CD63/CD81) and detection by surface-enhanced Raman scattering (SERS) after EV labelling with C5b-9 or C9 antibody conjugated SERS nanotags. Following C9 exposure, all examined cell lines formed C5b-9, internalized C5b-9, and shed C5b-9+ and C9+ EVs, albeit at varying levels despite receiving the same C9 dose. In conclusion, these results confirm increased esophageal C5b-9 formation during EAC development and demonstrate capability and heterogeneity in C5b-9 formation and shedding in BE and EAC cell lines following sublytic C9 exposure. Future work may explore the molecular mechanisms and pathogenic implications of the shed C5b-9+ EV
Traveling-Wave Electrokinetic Micropumps: Velocity, Electrical Current, and Impedance Measurements
MethPat: a tool for the analysis and visualisation of complex methylation patterns obtained by massively parallel sequencing
Ectopic pregnancy risk factors for ART patients undergoing the GnRH antagonist protocol: a retrospective study
Encapsulation of glucose oxidase microparticles within a nanoscale layer-by-layer film: immobilization and biosensor applications
We report on an immobilization strategy utilizing layer-by-layer encapsulated microparticles of enzymes within a nanoscale polyelectrolyte film. Encapsulation of glucose oxidase (GOD) microparticles was achieved by the sequential adsorption of oppositely charged polyelectrolytes onto the GOD biocrystal surface. The polyelectrolyte system polyallylamine/polystyrene sulfonate was used under high salt conditions to preserve the solid state of the highly water soluble GOD biocrystals during the encapsulation process. The resulting polymer multilayer capsule of about 15 nm wall thickness is permeable for small molecules (glucose), but non-permeable for macromolecules thus preventing the enzyme from leakage and at the same time shielding it from the outer environment e.g., from protease or microbial activity. Decrease of the buffer salt concentration leads to the dissolution of the enzyme under formation of mu-bioreactors. The spherical mu-bioreactors are hearing an extremely high loading of biocompound per volume. Encapsulated GOD was subsequently used to construct a biosensor by nanoengineered immobilisation of mu-bioreactor capsules onto an electrode surface. The presented approach demonstrates a general method to encapsulate highly soluble solid biomaterials and an immobilization strategy with the potential to create highly active thin and stable Films of biomaterial. (C) 2003 Elsevier Science B.V. All rights reserved
- …