Scattering of Bunched Fractionally Charged Quasiparticles

The charge of fractionally charged quasiparticles, proposed by Laughlin to explain the fractional quantum Hall effect (FQHE), was recently verified by measurements. Charge q=e/3 and e/5 (e is the electron charge), at filling factors nu=1/3 and 2/5, respectively, were measured. Here we report the unexpected bunching of fractional charges, induced by an extremely weak backscattering potential at exceptionally low electron temperatures (T<10 mK) - deduced from shot noise measurements. Backscattered charges q=nu e, specifically, q=e/3, q=2e/5, and q<3e/7, in the respective filling factors, were measured. For the same settings but at an only slightly higher electron temperature, the measured backscattered charges were q=e/3, q=e/5, and q=e/7. In other words, bunching of backscattered quasiparticles is taking place at sufficiently low temperatures. Moreover, the backscattered current exhibited distinct temperature dependence that was correlated to the backscattered charge and the filling factor. This observation suggests the existence of 'low' and 'high' temperature backscattering states, each with its characteristic charge and characteristic energy.Comment: 4 pages, 3 figure

Compressed Air Energy Storage-Part I: An Accurate Bi-linear Cavern Model

Compressed air energy storage (CAES) is suitable for large-scale energy storage and can help to increase the penetration of wind power in power systems. A CAES plant consists of compressors, expanders, caverns, and a motor/generator set. Currently used cavern models for CAES are either accurate but highly non-linear or linear but inaccurate. Highly non-linear cavern models cannot be directly utilized in power system optimization problems. In this regard, an accurate bi-linear cavern model for CAES is proposed in this first paper of a two-part series. The charging and discharging processes in a cavern are divided into several virtual states and then the first law of thermodynamics and ideal gas law are used to derive a cavern model, i.e., model for the variation of temperature and pressure in these processes. Thereafter, the heat transfer between the air in the cavern and the cavern wall is considered and integrated into the cavern model. By subsequently eliminating several negligible terms, the cavern model reduces to a bi-linear (linear) model for CAES with multiple (single) time steps. The accuracy of the proposed cavern model is verified via comparison with an accurate non-linear model.Comment: 8 page

Reliability assessment of microgrid with renewable generation and prioritized loads

With the increase in awareness about the climate change, there has been a tremendous shift towards utilizing renewable energy sources (RES). In this regard, smart grid technologies have been presented to facilitate higher penetration of RES. Microgrids are the key components of the smart grids. Microgrids allow integration of various distributed energy resources (DER) such as the distributed generation (DGs) and energy storage systems (ESSs) into the distribution system and hence remove or delay the need for distribution expansion. One of the crucial requirements for utilities is to ensure that the system reliability is maintained with the inclusion of microgrid topology. Therefore, this paper evaluates the reliability of a microgrid containing prioritized loads and distributed RES through a hybrid analytical-simulation method. The stochasticity of RES introduces complexity to the reliability evaluation. The method takes into account the variability of RES through Monte- Carlo state sampling simulation. The results indicate the reliability enhancement of the overall system in the presence of the microgrid topology. In particular, the highest priority load has the largest improvement in the reliability indices. Furthermore, sensitivity analysis is performed to understand the effects of the failure of microgrid islanding in the case of a fault in the upstream network

Compressed Air Energy Storage-Part II: Application to Power System Unit Commitment

Unit commitment (UC) is one of the most important power system operation problems. To integrate higher penetration of wind power into power systems, more compressed air energy storage (CAES) plants are being built. Existing cavern models for the CAES used in power system optimization problems are not accurate, which may lead to infeasible solutions, e.g., the air pressure in the cavern is outside its operating range. In this regard, an accurate CAES model is proposed for the UC problem based on the accurate bi-linear cavern model proposed in the first paper of this two-part series. The minimum switch time between the charging and discharging processes of CAES is considered. The whole model, i.e., the UC model with an accurate CAES model, is a large-scale mixed integer bi-linear programming problem. To reduce the complexity of the whole model, three strategies are proposed to reduce the number of bi-linear terms without sacrificing accuracy. McCormick relaxation and piecewise linearization are then used to linearize the whole model. To decrease the solution time, a method to obtain an initial solution of the linearized model is proposed. A modified RTS-79 system is used to verify the effectiveness of the whole model and the solution methodology.Comment: 8 page

Impact of edge-removal on the centrality betweenness of the best spreaders

The control of epidemic spreading is essential to avoid potential fatal consequences and also, to lessen unforeseen socio-economic impact. The need for effective control is exemplified during the severe acute respiratory syndrome (SARS) in 2003, which has inflicted near to a thousand deaths as well as bankruptcies of airlines and related businesses. In this article, we examine the efficacy of control strategies on the propagation of infectious diseases based on removing connections within real world airline network with the associated economic and social costs taken into account through defining appropriate quantitative measures. We uncover the surprising results that removing less busy connections can be far more effective in hindering the spread of the disease than removing the more popular connections. Since disconnecting the less popular routes tend to incur less socio-economic cost, our finding suggests the possibility of trading minimal reduction in connectivity of an important hub with efficiencies in epidemic control. In particular, we demonstrate the performance of various local epidemic control strategies, and show how our approach can predict their cost effectiveness through the spreading control characteristics.Comment: 11 pages, 4 figure

Designing Geotextile Support for Submarine Power Cables

Six 36 cm diameter submarine pipe-cables were buried in a 1.2 km long, fabric-lined trench in the soft river mud under 17 m average water head across the Hudson River about 4.8 km north of the Newburgh Bridge, New York. This paper describes the design considerations based on geotechnical point of view of using geotextile to support submarine power cables