15,868 research outputs found
Impeller-Induced Rotor-Dynamic Forces
The flow through and around the rotor of a turbomachine exerts a force on the rotor and, hence, rotor shaft and bearing system. In some circumstances this force may lead to excitation of shaft whirl in the direction of impeller rotation. Recent international research of this phenomenon is briefly reviewed; these findings suggest that turbomachines intended to operate well above the first critical speed should take the effect into account
Spitzer Observations of Black Hole Low-mass X-ray Binaries: Assessing the Non-stellar Infrared Component
We have combined ground-based optical and near-infrared data with Spitzer Space Telescope mid-infrared data for five black hole (BH) soft X-ray transients (SXTs) in order to determine the levels of near- and mid-infrared emission from sources other than the secondary star. Mid-infrared emission from an accretion disk, circumbinary dust, and/or a jet could act as sources of near-infrared contamination, thereby diluting ellipsoidal variations of the secondary star and affecting determined BH mass estimates. Based on optical to mid-infrared spectral energy distribution modeling of the five SXTs along with the prototype, V616 Mon, we detected mid-infrared excesses in half of the systems, and suggest that the excesses detected from these systems arise from non-thermal synchrotron jets rather than circumbinary dust disks
Forces on Centrifugal Pump Impellers
Forces are exerted on a centrifugal pump impeller, due to the asymmetry of the flow caused by the volute of diffuser, and to the motion of the center of the impeller whenever the shaft whirls. Recent work in the measurement of these forces as a function of the whirl speed to shaft speed ratio, and the influence of the volute, is reviewed. These forces may be decomposed into a steady force, a static stiffness matrix, a damping matrix and an inertia matrix. It is shown that for centrifugal pumps of the moderate specific speed typical of boiler feed stages, there is a region of potential shaft vibration excitation from the hydrodynamic forces if the operating speed is well above the first flexural critical speed
The thermodynamics of computational copying in biochemical systems
Living cells use readout molecules to record the state of receptor proteins,
similar to measurements or copies in typical computational devices. But is this
analogy rigorous? Can cells be optimally efficient, and if not, why? We show
that, as in computation, a canonical biochemical readout network generates
correlations; extracting no work from these correlations sets a lower bound on
dissipation. For general input, the biochemical network cannot reach this
bound, even with arbitrarily slow reactions or weak thermodynamic driving. It
faces an accuracy-dissipation trade-off that is qualitatively distinct from and
worse than implied by the bound, and more complex steady-state copy processes
cannot perform better. Nonetheless, the cost remains close to the thermodynamic
bound unless accuracy is extremely high. Additionally, we show that
biomolecular reactions could be used in thermodynamically optimal devices under
exogenous manipulation of chemical fuels, suggesting an experimental system for
testing computational thermodynamics.Comment: Accepted versio
CONJOINT ANALYSIS OF GROUNDWATER PROTECTION PROGRAMS
Three conjoint models-a traditional ratings model, a ratings difference specification, and a binary response model-were used to value groundwater protection program alternatives. The last, which is virtually identical to a dichotomous choice contingent valuation specification, produced the smallest value estimates. This suggests that the conjoint model is very sensitive to model specifications and that traditional conjoint models may overestimate economic value because many respondents are not in the market for the commodity being valued.Resource /Energy Economics and Policy,
Stellar or Non-Stellar Light? Determining Near-Infrared Contamination in Low Mass X-ray Binaries
Low-mass X-ray binary (LMXB) systems are comprised of a low-mass, K or M dwarflike star orbiting a compact object. Stellar black hole masses and their distributions are important inputs for binary evolution and supernova models. Currently, the main limiting factor in determining accurate black hole masses in LMXBs is the uncertainty of the orbital inclination angle due to an unknown amount of contaminating light in the near infrared. If present, this light dilutes the ellipsoidal variations of the low-mass secondary star, and thus gives the appearance of a lower orbital inclination system. It has been generally thought that the near infrared ellipsoidal light curves of these systems were relatively uncontaminated and represented primarily the light from the low-mass secondary star; however, recent disk and jet models have thrust this thinking into question. We combine our data from the Spitzer Space Telescope with our ground-based optical and near infrared data for several LMXBs to characterize and derive the amount of light contaminating the near-infrared ellipsoidal variations of the low-mass secondary star
- …