In situ aerosol measurements taken during the 2007 COPS field campaign at the Hornisgrinde ground site

Copyright @ 2011 Royal Meteorological Society.The Convective and Orographically-induced Precipitation Study (COPS) campaign was conducted during the summer of 2007. A suite of instruments housed at the top of the Hornisgrinde Mountain (1156 m) in the Black Forest region of south-west Germany provided datasets that allow an investigation into the physical, chemical and hygroscopic properties of the aerosol particles sampled during COPS. Organic mass loadings were found to dominate the aerosol composition for the majority of the project, exceeding 8 µg m−3 during a period of high pressure, high temperature, and low wind speed. The ratio of organic:sulphate sub-micron mass concentration exceeds 10:1 during the same time period. Back trajectories show air from this time-frame passing slowly over the local forest and not passing over any local anthropogenic sources. Occasional peaks in nitrate mass loadings were associated with changes in the typical wind direction from south-westerly to north-westerly where air had passed over the Stuttgart region. Size distribution data shows a dominant accumulation-mode when the measurement site was free from precipitation events. A sharp increase in ultrafine particle number concentration was seen during most days commencing around noon. The apparent growth of these particles is associated with an increase in organic mass loading, suggesting condensational growth. For the most part, with the exception of the high pressure period, the aerosol properties recorded during COPS were comparable to previous studies of continental aerosol properties.NER

Long-term trends in rain and cloud chemistry in a region of complex topography

Rain and cloud water from a high-elevation site and an adjacent lower-level site in the northern Pennines of England were sampled and analysed between 1994 and 2008. The comparison of wet deposition and rainfall depth at the high and low-level sites has been used to estimate the additional deposition of pollutants arising from ‘seeder–feeder’ enhancement by washout of the orographic cap cloud that forms over the high-level site. The derived ‘orographic scavenging ratio’ for different ions is used to map the orographic enhancement of wet deposition across the U.K. The ratio of ion concentrations in cloud and in rain at the high-level site is also important for estimating the input of pollutants through the direct capture of cloud water droplets at high elevation sites. Long-term trends in ion concentrations in cloud and rain showed significant downward trends in non-sea sulphate, and a weaker downward trend in nitrate, but no trend in other ions. There was also no trend in the orographic scavenging ratios, implying that the methods used to estimate orographic enhancement across the U.K. are robust over time

Evaluating the effects of microphysical complexity in idealised simulations of trade wind cumulus using the Factorial Method

The effect of microphysical and environmental factors on the development of precipitation in warm idealised cloud is explored using a kinematic modelling framework. A simple one-dimensional column model is used to drive a suite of microphysics schemes including a flexible multi-moment bulk scheme (including both single and dual moment cloud liquid water) and a state-of-the-art bin-resolved scheme with explicit treatments of liquid and aerosol. The Factorial Method is employed to quantify and compare the sensitivities of each scheme under a set of controlled conditions, in order to isolate the effect of additional microphysical complexity in terms of the impact on surface precipitation. At relatively low updraught speeds, the sensitivity of the bulk schemes was found to depend on the assumptions made with regards the treatment of droplet activation. It was possible to achieve a much closer agreement between the single and dual moment bulk schemes by tuning the specified droplet number concentration in the single moment scheme, suggesting that a diagnostic representation of droplet number may be an acceptable alternative to the more expensive prognostic option. However the effect of changes in CCN concentration were found to produce a relatively stronger effect on precipitation in the bulk schemes compared to the bin scheme; this is believed to be a consequence of differences in the treatment of drop growth by collision and coalescence. Collectively, these results demonstrate the usefulness of the Factorial Method as a model development tool for quantitatively comparing and contrasting the behaviour of microphysics schemes of differing levels of complexity within a specified parameter space

Factors influencing ice formation and growth in simulations of a mixed-phase wave cloud

In this paper, numerical simulations of an orographically induced wave cloud sampled in-situ during the ICE-L (Ice in Clouds Experiment - Layer clouds) field campaign are performed and compared directly against the available observations along various straight and level flight paths. The simulations are based on a detailed mixed-phase bin microphysics model embedded within a 1-D column framework with the latest parameterizations for heterogeneous ice nucleation and an adaptive treatment of ice crystal growth based on the evolution of crystal habit. The study focuses on the second of two clouds sampled on 16th November 2007, the in-situ data from which exhibits some interesting and more complex microphysics than other flights from the campaign. The model is used to demonstrate the importance of both heterogeneous and homogeneous nucleation in explaining the in-situ observations of ice crystal concentration and habit, and how the ability to isolate the influence of both nucleation mechanisms helps when quantifying active IN concentrations. The aspect ratio and density of the simulated ice crystals is shown to evolve in a manner consistent with the in-situ observations along the flight track, particularly during the transition from the mixed-phase region of the cloud to the ice tail dominated by homogeneous nucleation. Some additional model runs are also performed to explore how changes in IN concentration and the value of the deposition coefficient for ice affect the competition between heterogeneous and homogeneous ice formation in the wave cloud, where the Factorial Method is used to isolate and quantify the effect of such non-linear interactions. The findings from this analysis show that the effect on homogeneous freezing rates is small, suggesting that any competition between the microphysical variables is largely overshadowed by the strong dynamical forcing of the cloud in the early stages of ice formation

Anatomy of Cirrus Clouds: Results from the Emerald Airborne Campaigns

2000 FLORIDA AVE NW, WASHINGTON, USA, DC, 2000

The role of droplet sedimentation in the evolution of low-level clouds over southern West Africa

Large-eddy simulations are performed to investigate the influence of cloud microphysics on the evolution of low-level clouds that form over southern West Africa during the monsoon season. We find that, even in clouds that are not precipitating, the size of cloud droplets has a non-negligible effect on liquid water path. This is explained through the effects of droplet sedimentation, which acts to remove liquid water from the entrainment zone close to cloud top, increasing the liquid water path. Sedimentation also produces a more heterogeneous cloud structure and lowers cloud base height. Our results imply that an appropriate parameterization of the effects of sedimentation is required to improve the representation of the diurnal cycle of the atmospheric boundary layer over southern West Africa in large-scale models

Observations and comparisons of cloud microphysical properties in spring and summertime Arctic stratocumulus clouds during the ACCACIA campaign

Measurements from four case studies in spring and summer-time Arctic stratocumulus clouds during the Aerosol-Cloud Coupling And Climate Interactions in the Arctic (ACCACIA) campaign are presented. We compare microphysics observations between cases and with previous measurements made in the Arctic and Antarctic. During ACCACIA, stratocumulus clouds were observed to consist of liquid at cloud tops, often at distinct temperature inversions. The cloud top regions precipitated low concentrations of ice into the cloud below. During the spring cases median ice number concentrations (~ 0.5 L−1) were found to be lower by about a factor of 5 than observations from the summer campaign (~ 3 L−1). Cloud layers in the summer spanned a warmer temperature regime than in the spring and enhancement of ice concentrations in these cases was found to be due to secondary ice production through the Hallett–Mossop (H–M) process. Aerosol concentrations during spring ranged from ~ 300–400 cm−3 in one case to lower values of ~ 50–100 cm−3 in the other. The concentration of aerosol with sizes Dp > 0.5 μm was used in a primary ice nucleus (IN) prediction scheme (DeMott et al., 2010). Predicted IN values varied depending on aerosol measurement periods but were generally greater than maximum observed median values of ice crystal concentrations in the spring cases, and less than the observed ice concentrations in the summer due to the influence of secondary ice production. Comparison with recent cloud observations in the Antarctic summer (Grosvenor et al., 2012), reveals lower ice concentrations in Antarctic clouds in comparable seasons. An enhancement of ice crystal number concentrations (when compared with predicted IN numbers) was also found in Antarctic stratocumulus clouds spanning the H–M temperature zone; however, concentrations were about an order of magnitude lower than those observed in the Arctic summer cases but were similar to the peak values observed in the colder Arctic spring cases, where the H–M mechanism did not operate

The origins of ice crystals measured in mixed-phase clouds at the high-alpine site Jungfraujoch

During the winter of 2013 and 2014 measurements of cloud microphysical properties over a 5-week period at the high-alpine site Jungfraujoch, Switzerland, were carried out as part of the Cloud Aerosol Characterisation Experiments (CLACE) and the Ice Nucleation Process Investigation and Quantification project (INUPIAQ). Measurements of aerosol properties at a second, lower site, Schilthorn, Switzerland, were used as input for a primary ice nucleation scheme to predict ice nuclei concentrations at Jungfraujoch. Frequent, rapid transitions in the ice and liquid properties of the clouds at Jungfraujoch were identified that led to large fluctuations in ice mass fractions over temporal scales of seconds to hours. During the measurement period we observed high concentrations of ice particles that exceeded 1000 L-1 at temperatures around -15 degrees C, verified by multiple instruments. These concentrations could not be explained using the usual primary ice nucleation schemes, which predicted ice nucleus concentrations several orders of magnitude smaller than the peak ice crystal number concentrations. Secondary ice production through the Hallett-Mossop process as a possible explanation was ruled out, as the cloud was rarely within the active temperature range for this process. It is shown that other mechanisms of secondary ice particle production cannot explain the highest ice particle concentrations. We describe four possible mechanisms that could lead to high cloud ice concentrations generated from the snow-covered surfaces surrounding the measurement site. Of these we show that hoar frost crystals generated at the cloud enveloped snow surface could be the most important source of cloud ice concentrations. Blowing snow was also observed to make significant contributions at higher wind speeds when ice crystal concentrations were < 100 L-1

Observations and modelling of microphysical variability, aggregation and sedimentation in tropical anvil cirrus outflow regions

Aircraft measurements of the microphysics of a tropical convective anvil (at temperatures ~&minus;60 °C) forming above the Hector storm, over the Tiwi Islands, Northern Australia, have been conducted with a view to determining ice crystal aggregation efficiencies from in situ measurements. The observed microphysics have been compared to an explicit bin-microphysical model of the anvil region, which includes crystal growth by vapour diffusion and aggregation and the process of differential sedimentation. It has been found in flights made using straight and level runs perpendicular to the storm that the number of ice crystals initially decreased with distance from the storm as aggregation took place resulting in larger crystals, followed by their loss from the cloud layer due to sedimentation. The net result was that the mass (i.e. Ice Water Content) in the anvil Ci cloud decreased, but also that the average particle size (weighted by number) remained relatively constant along the length of the anvil outflow. Comparisons with the explicit microphysics model showed that the changes in the shapes of the ice crystal spectra as a function of distance from the storm could be explained by the model if the aggregation efficiency was set to values of Eagg~0.5 and higher. This result is supported by recent literature on aggregation efficiencies for complex ice particles and suggests that either the mechanism of particle interlocking is important to the aggregation process, or that other effects are occuring, such as enhancement of ice-aggregation by high electric fields that arise as a consequence of charge separation within the storm. It is noteworthy that this value of the ice crystal aggregation efficiency is much larger than values used in cloud resolving models at these temperatures, which typically use E~0.0016. These results are important to understanding how cold clouds evolve in time and for the treatment of the evolution of tropical Ci in numerical models

Relating large-scale subsidence to convection development in Arctic mixed-phase marine stratocumulus

Large-scale subsidence, associated with high-pressure systems, is often imposed in large-eddy simulation (LES) models to maintain the height of boundary layer (BL) clouds. Previous studies have considered the influence of subsidence on warm liquid clouds in subtropical regions; however, the relationship between subsidence and mixed-phase cloud microphysics has not specifically been studied. For the first time, we investigate how widespread subsidence associated with synoptic-scale meteorological features can affect the microphysics of Arctic mixed-phase marine stratocumulus (Sc) clouds. Modelled with LES, four idealised scenarios – a stable Sc, varied droplet (Ndrop) or ice (Nice) number concentrations, and a warming surface (representing motion southwards) – were subjected to different levels of subsidence to investigate the cloud microphysical response. We find strong sensitivities to large-scale subsidence, indicating that high-pressure systems in the ocean-exposed Arctic regions have the potential to generate turbulence and changes in cloud microphysics in any resident BL mixed-phase clouds. Increased cloud convection is modelled with increased subsidence, driven by longwave radiative cooling at cloud top and rain evaporative cooling and latent heating from snow growth below cloud. Subsidence strengthens the BL temperature inversion, thus reducing entrainment and allowing the liquid- and ice-water paths (LWPs, IWPs) to increase. Through increased cloud-top radiative cooling and subsequent convective overturning, precipitation production is enhanced: rain particle number concentrations (Nrain), in-cloud rain mass production rates, and below-cloud evaporation rates increase with increased subsidence. Ice number concentrations (Nice) play an important role, as greater concentrations suppress the liquid phase; therefore, Nice acts to mediate the strength of turbulent overturning promoted by increased subsidence. With a warming surface, a lack of – or low – subsidence allows for rapid BL turbulent kinetic energy (TKE) coupling, leading to a heterogeneous cloud layer, cloud-top ascent, and cumuli formation below the Sc cloud. In these scenarios, higher levels of subsidence act to stabilise the Sc layer, where the combination of these two forcings counteract one another to produce a stable, yet dynamic, cloud layer