Effect of injection strategies on a single-fuel RCCI combustion fueled with isobutanol/isobutanol + DTBP blends

© 2020 Elsevier Ltd. All rights reserved. This manuscript is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International Licence (http://creativecommons.org/licenses/by-nc-nd/4.0/).In recent years, improved combustion controllability through in-cylinder reactivity stratification by using two different fuels have led to introduction of dual-fuel reactivity controlled compression ignition (RCCI) strategy. In conventional RCCI, gasoline or natural gas can be used as the low-reactivity fuel, and diesel or biodiesel can be used as the high-reactivity fuel. This strategy has the potential to operate with a single low-reactivity fuel and direct injection (DI) of the same fuel blended with a small amount of cetane improver. In the present study, numerical simulations have been carried out to study injection strategy in a single-fuel RCCI engine fueled with isobutanol – isobutanol + 20% di-tert-butyl peroxide (DTBP). Firstly, the effects of start of injection (SOI) timing, injection pressure (pinj), spray cone angle (SCA), and DI fuel ratio were explored. Then, the effect of DI fuel ratio was discussed in each best case in order to decrease the high DI requirement. The results indicate that SOI = −88° ATDC, pinj = 1400 bar, and SCA = 45° can improve the single-fuel RCCI engine performance and emissions compared to the baseline case (SOI = −58° ATDC, pinj = 600 bar, SCA = 72.5°). Moreover, it is shown that by advancing the SOI timing to −88° ATDC, a 20% reduction in DI ratio, 3.3% increase in gross indicated efficiency (GIE) together with reductions in CO, and NOx emissions by 3.56 g/kW-h and 0.254 g/kW-h, could be achieved, respectively.Peer reviewedFinal Accepted Versio

Synthesis gas as a fuel for internal combustion engines in transportation

© 2022 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/).The adverse environmental impact of fossil fuel combustion in engines has motivated research towards using alternative low-carbon fuels. In recent years, there has been an increased interest in studying the combustion of fuel mixtures consisting mainly of hydrogen and carbon monoxide, referred to as syngas, which can be considered as a promising fuel toward cleaner combustion technologies for power generation. This paper provides an extensive review of syngas production and application in internal combustion (IC) engines as the primary or secondary fuel. First, a brief overview of syngas as a fuel is presented, introducing the various methods for its production, focusing on its historical use and summarizing the merits and drawbacks of using syngas as a fuel. Then its physicochemical properties relevant to IC engines are reviewed, highlighting studies on the fundamental combustion characteristics, such as ignition delay time and laminar and turbulent flame speeds. The main body of the paper is devoted to reviewing the effect of syngas utilization on performance and emissions characteristics of spark ignition (SI), compression ignition (CI), homogeneous charge compression ignition (HCCI), and advanced dual-fuel engines such as reactivity-controlled compression ignition (RCCI) engines. Finally, various on-board fuel reforming techniques for syngas production and use in vehicles are reviewed as a potential route towards further increases in efficiency and decreases in emissions of IC engines. These are then related to the research reported on the behavior of syngas and its blends in IC engines. It was found that the selection of the syngas production method, choice of the base fuel for reforming, its physicochemical properties, combustion strategy, and engine combustion system and operating conditions play critical roles in dictating the potential advantages of syngas use in IC engines. The discussion of the present review paper provides valuable insights for future research on syngas as a possible fuel for IC engines for transport.Peer reviewe