Dynamic model for failures in biological systems

A dynamic model for failures in biological organisms is proposed and studied both analytically and numerically. Each cell in the organism becomes dead under sufficiently strong stress, and is then allowed to be healed with some probability. It is found that unlike the case of no healing, the organism in general does not completely break down even in the presence of noise. Revealed is the characteristic time evolution that the system tends to resist the stress longer than the system without healing, followed by sudden breakdown with some fraction of cells surviving. When the noise is weak, the critical stress beyond which the system breaks down increases rapidly as the healing parameter is raised from zero, indicative of the importance of healing in biological systems.Comment: To appear in Europhys. Let

ESR, raman and conductivity studies on fractionated poly(2-methoxyaniline-5-sulfonic acid)

Synthesis methods used to produce poly(2-methoxyaniline-5-sulfonic acid) (PMAS), a water soluble, self-doped conducting polymer, have been shown to form two distinctly different polymer fractions with molecular weights of approximately 2 kDa and 8 -10 kDa. The low molecular weight (LMWT) PMAS fraction is redox inactive and non-conducting while the high molecular weight (HMWT) PMAS is electro-active with electrical conductivities of 0.94 0.05 S cm-1. Previous investigations have illustrated the different photochemical and electrochemical properties of these fractions, but have not correlated these properties with the structural and electronic interactions that drive them. Incomplete purification of the PMAS mixture, typically via bag dialysis, has been shown to result in a mixture of approximately 50:50 HMWT:LMWT PMAS with electrical conductivity significantly lower at approximately 0.10 to 0.26 S cm-1. The difference between the electrical conductivities of these fractions has been investigated by the controlled addition of the non-conducting LMWT PMAS fraction into the HMWT PMAS composite film with the subsequent electronic properties investigated by solid-state ESR and Raman spectroscopies. These studies illustrate strong electronic intereactions of the insulating LMWT PMAS with the emeraldine salt HMWT PMAS to substantially alter the population of the electronic charge carriers in the conducting polymer. ESR studies on these mixtures, when compared to HMWT PMAS, exhibited a lower level of electron spin in the presence of LMWT PMAS indicative of the the formation of low spin bipolarons without a change the oxidation state of the conducting HMWT fraction

Comparison of Structural Properties between Monopile and Tripod Offshore Wind-Turbine Support Structures

Offshore wind power provides a new kind of green energy. This paper presents a comparison study on the structural properties of monopile and tripod wind-turbine support structures, which are used extensively in offshore wind farms. Both structures have the same upper tower, but different lower structures, one with a monopile and the other with a tripod. Static, fatigue, and modal analyses indicate that both the tripod and monopile structures are feasible in the field, but that the tripod structure is superior to the monopile structure. Static analysis reveals that the location of maximum stress in the monopile structure is different from that in the tripod structure, and that the tripod structure shows higher stiffness and greater stress-control capacity than the monopile structure. Fatigue analysis indicates that the tripod structure has a longer lifetime than the monopile structure. Modal analysis indicates that the two structures exhibit large differences in their natural frequencies. Unlike the monopile structure, the third and first modes both have a substantial influence on the dynamic response of the tripod structure