6 research outputs found

    The First 1 1/2 Years of TOTEM Roman Pot Operation at LHC

    Get PDF
    Since the LHC running season 2010, the TOTEM Roman Pots (RPs) are fully operational and serve for collecting elastic and diffractive proton-proton scattering data. Like for other moveable devices approaching the high intensity LHC beams, a reliable and precise control of the RP position is critical to machine protection. After a review of the RP movement control and position interlock system, the crucial task of alignment will be discussed.Comment: 3 pages, 6 figures; 2nd International Particle Accelerator Conference (IPAC 2011), San Sebastian, Spain; contribution MOPO01

    LIFETIME ANALYSIS AT HIGH INTENSITY COLLIDERS APPLIED TO THE LHC

    No full text
    Abstract The beam lifetime is one of the main parameters to define the performance of a collider. In a super-conducting machine like the LHC, the lifetime determines the intensity reach for a given collimation cleaning. The beam lifetime can be calculated from the direct measurement of beam current. However, due to the noise in the beam current signal only an average lifetime over several seconds can be calculated. We propose here an alternative method, which uses the signal of the beam loss monitors in the vicinity of the primary collimators to get the instantaneous beam lifetime at the collimators. In this paper we compare the lifetime from the two methods and investigate the minimum lifetime over the LHC cycle for all the physics fills in 2011 and 2012. These data provide a reference for estimates of performance reach from collimator cleaning

    FIRST BEAM RESULTS FOR A COLLIMATOR WITH IN-JAW BEAM POSITION MONITORS

    No full text
    Abstract With more than 100 collimators the LHC has the most complex collimation system ever installed in an accelerator. The beam-based setup time of the system was a nonnegligible factor during the commissioning of the LHC. In addition if the particle orbit at a collimator goes out of tolerance, this collimator needs to be setup again. To reduce the required setup time for the collimation system and to obtain the tight tolerances required for the LHC operation with small beta* and high beam energy, a new collimator design is being developed that integrates a beam position monitor (BPM) into the jaws of the collimator. A prototype of such a phase-II LHC collimator was installed in the SPS at CERN for the 2010 run. In this paper we present the first experimental results from the beam tests performed

    Simulations and Measurements of Cleaning with 100 MJ Beams in the LHC

    No full text
    Abstract The CERN Large Hadron Collider is routinely storing proton beam intensities of more than 100 MJ, which puts extraordinary demands on the control of beam losses to avoid quenches of the superconducting magnets. Therefore, a detailed understanding of the LHC beam cleaning is required. We present tracking and shower simulations of the LHC's multi-stage collimation system and compare with measured beam losses, which allow us to conclude on the predictive power of the simulations

    Accelerator Engineering and Technology: Accelerator Technology

    No full text
    Magnets are at the core of both circular and linear accelerators. The main function of a magnet is to guide the charged particle beam by virtue of the Lorentz force, given by the following expression:where q is the electrical charge of the particle, v its velocity, and B the magnetic field induction. The trajectory of a particle in the field depends hence on the particle velocity and on the space distribution of the field. The simplest case is that of a uniform magnetic field with a single component and velocity v normal to it, in which case the particle trajectory is a circle. A uniform field has thus a pure bending effect on a charged particle, and the magnet that generates it is generally referred to as a dipole
    corecore