250 research outputs found
Asymmetric transmission of linearly polarized light at optical metamaterials
We experimentally demonstrate a three-dimensional chiral optical metamaterial
that exhibits an asymmetric transmission for forwardly and backwardly
propagating linearly polarized light. The observation of this novel effect
requires a metamaterial composed of three-dimensional chiral metaatoms without
any rotational symmetry. Our analysis is supported by a systematic
investigation of the transmission matrices for arbitrarily complex, lossy media
that allows deriving a simple criterion for asymmetric transmission in an
arbitrary polarization base. Contrary to physical intuition, in general the
polarization eigenstates in such three-dimensional and low-symmetry
metamaterials do not obey fxed relations and the associated transmission
matrices cannot be symmetrized
Infrared recombination lasers pumped by low energy Nd: YAG and excimer lasers
24 infrared laser lines on atomic and ionic transitions have been observed in recombining plasmas by vaporizing and ionizing Cd, Pb, Sn, Zn, and Mg with low energy Nd:YAG or excimer pump-lasers. For operation and optimization of the recombination lasers separated plasma spots and a plasma confinement have been used. The operation of shorter wavelength systems by isoelectronic scaling is discussed
Potential mechanical loss mechanisms in bulk materials for future gravitational wave detectors
Low mechanical loss materials are needed to further decrease thermal noise in
upcoming gravitational wave detectors. We present an analysis of the
contribution of Akhieser and thermoelastic damping on the experimental results
of resonant mechanical loss measurements. The combination of both processes
allows the fit of the experimental data of quartz in the low temperature region
(10 K to 25 K). A fully anisotropic numerical calculation over a wide
temperature range (10 K to 300 K) reveals, that thermoelastic damping is not a
dominant noise source in bulk silicon samples. The anisotropic numerical
calculation is sucessfully applied to the estimate of thermoelastic noise of an
advanced LIGO sized silicon test mass.Comment: 7 pages, 3 figures, submitted to Journal of Physics: Conference
Series (AMALDI8
Multipole nonlinearity of metamaterials
We report on the linear and nonlinear optical response of metamaterials
evoked by first and second order multipoles. The analytical ground on which our
approach bases permits for new insights into the functionality of
metamaterials. For the sake of clarity we focus here on a key geometry, namely
the split-ring resonator, although the introduced formalism can be applied to
arbitrary structures. We derive the equations that describe linear and
nonlinear light propagation where special emphasis is put on second harmonic
generation. This contribution basically aims at stretching versatile and
existing concepts to describe light propagation in nonlinear media towards the
realm of metamaterials.Comment: 7 pages, 3 figure
High-sensitivity tool for studying phonon related mechanical losses in low loss materials
Fundamental mechanical loss mechanisms exist even in very pure materials, for
instance, due to the interactions of excited acoustic waves with thermal
phonons. A reduction of these losses in a certain frequency range is desired in
high precision instruments like gravitational wave detectors. Systematic
analyses of the mechanical losses in those low loss materials are essential for
this aim, performed in a highly sensitive experimental set-up. Our novel method
of mechanical spectroscopy, cryogenic resonant acoustic spectroscopy of bulk
materials (CRA spectroscopy), is well suited to systematically determine losses
at the resonant frequencies of the samples of less than 10^(-9) in the wide
temperature range from 5 to 300 K. A high precision set-up in a specially built
cryostat allows contactless excitation and readout of the oscillations of the
sample. The experimental set-up and measuring procedure are described.
Limitations to our experiment due to external loss mechanisms are analysed. The
influence of the suspension system as well as the sample preparation is
explained.Comment: 4 pages, 3 figures, proceedings of PHONONS07, submitted to Journal of
Physics: Conference Serie
Contribution of the magnetic resonance to the third harmonic generation from a fishnet metamaterial
We investigate experimentally and theoretically the third harmonic generated
by a double-layer fishnet metamaterial. To unambiguously disclose most notably
the influence of the magnetic resonance, the generated third harmonic was
measured as a function of the angle of incidence. It is shown experimentally
and numerically that when the magnetic resonance is excited by pump beam, the
angular dependence of the third harmonic signal has a local maximum at an
incidence angle of {\theta} \simeq 20{\deg}. This maximum is shown to be a
fingerprint of the antisymmetric distribution of currents in the gold layers.
An analytical model based on the nonlinear dynamics of the electrons inside the
gold shows excellent agreement with experimental and numerical results. This
clearly indicates the difference in the third harmonic angular pattern at
electric and magnetic resonances of the metamaterial.Comment: 7 pages, 5 figure
Mechanical losses in low loss materials studied by Cryogenic Resonant Acoustic spectroscopy of bulk materials (CRA spectroscopy)
Mechanical losses of crystalline silicon and calcium fluoride have been
analyzed in the temperature range from 5 to 300 K by our novel mechanical
spectroscopy method, cryogenic resonant acoustic spectroscopy of bulk materials
(CRA spectrocopy). The focus lies on the interpretation of the measured data
according to phonon-phonon interactions and defect induced losses in
consideration of the excited mode shape.Comment: 4 pages, 4 figures, proceedings of the PHONONS 2007, submitted to
Journal of Physics: Conference Serie
Real-time and Sub-wavelength Ultrafast Coherent Diffraction Imaging in the Extreme Ultraviolet
Coherent Diffraction Imaging is a technique to study matter with nanometer-scale spatial resolution based on coherent illumination of the sample with hard X-ray, soft X-ray or extreme ultraviolet light delivered from synchrotrons or more recently X-ray Free-Electron Lasers. This robust technique simultaneously allows quantitative amplitude and phase contrast imaging. Laser-driven high harmonic generation XUV-sources allow table-top realizations. However, the low conversion efficiency of lab-based sources imposes either a large scale laser system or long exposure times, preventing many applications. Here we present a lensless imaging experiment combining a high numerical aperture (NA=0.8) setup with a high average power fibre laser driven high harmonic source. The high flux and narrow-band harmonic line at 33.2 nm enables either sub-wavelength spatial resolution close to the Abbe limit (Delta r=0.8 lambda) for long exposure time, or sub-70 nm imaging in less than one second. The unprecedented high spatial resolution, compactness of the setup together with the real-time capability paves the way for a plethora of applications in fundamental and life sciences
Recommended from our members
Merging Top-Down and Bottom-Up Approaches to Fabricate Artificial Photonic Nanomaterials with a Deterministic Electric and Magnetic Response
Artificial photonic nanomaterials made from densely packed scatterers are frequently realized either by top-down or bottom-up techniques. While top-down techniques offer unprecedented control over achievable geometries for the scatterers, by trend they suffer from being limited to planar and periodic structures. In contrast, materials fabricated with bottom-up techniques do not suffer from such disadvantages but, unfortunately, they offer only little control on achievable geometries for the scatterers. To overcome these limitations, a nanofabrication strategy is introduced that merges both approaches. A large number of scatterers are fabricated with a tailored optical response by fast character projection electron-beam lithography and are embedded into a membrane. By peeling-off this membrane from the substrate, scrambling, and densifying it, a bulk material comprising densely packed and randomly arranged scatterers is obtained. The fabrication of an isotropic material from these scatterers with a strong electric and magnetic response is demonstrated. The approach of this study unlocks novel opportunities to fabricate nanomaterials with a complex optical response in the bulk but also on top of arbitrarily shaped surfaces. © 2019 The Authors. Published by WILEY-VCH Verlag GmbH & Co. KGaA, Weinhei
Sub-80 fe dissipative soliton large-mode-area fiber laser
We report on high-energy ultrashort pulse generation from an all-normal-dispersion large-mode-area fiber laser by exploiting an efficient combination of nonlinear polarization evolution (NPE) and a semiconductor-based saturable absorber mode-locking mechanism. The watt-level laser directly emits chirped pulses with a duration of 1 ps and 163 nJ of pulse energy. These can be compressed to 77 fs, generating megawatt-level peak power. Intracavity dynamics are discussed by numerical simulation, and the intracavity pulse evolution reveals that NPE plays a key role in pulse shaping. © 2010 Optical Society of America
- …