E-Glass Fiber Reinforced Composites in Dental Applications

Fiber reinforced composites (FRCs) are more and more widely applied in dentistry to substitute for metallic restorations: periodontal splints, fixed partial dentures, endodontic posts, orthodontic appliances, and some other indirect restorations. In general in FRCs, the fiber reinforcement provides the composite structure with better biomechanical performance due to their superior properties in tension and flexure. Nowadays, the E-glass fiber is most frequently used because of its chemical resistance and relatively low cost. Growing interest is being paid to enhance its clinical performance. Moreover, various techniques are utilized to reinforce the adhesion between the fiber and the matrix. Oral conditions set special requirements and challenges for the clinical applications of FRCs. The biomechanical properties of dental materials are of high importance in dentistry, and given this, there is on-going scientific interest to develop E-glass fiber reinforced composite systems. FRCs are generally biocompatible and their toxicity is not a concern. © 2011 The Author(s).published_or_final_versionSpringer Open Choice, 21 Feb 201

Thermal conductivity of refractory glass fibres

In the present study, the current international standards and corresponding apparatus for measuring the thermal conductivity of refractory glass fibre products have been reviewed. Refractory glass fibres are normally produced in the form of low-density needled mats. A major issue with thermal conductivity measurements of these materials is lack of reproducibility in the test results due to transformation of the test material during the test. Also needled mats are inherently inhomogeneous, and this poses additional problems. To be able to compare the various methods of thermal conductivity measurement, a refractory reference material was designed which is capable of withstanding maximum test temperatures (1673 K) with minimum transformation. The thermal conductivity of this reference material was then measured using various methods according to the different standards surveyed. In order to compare different materials, samples have been acquired from major refractory glass fibre manufacturers and the results have been compared against the newly introduced reference material. Materials manufactured by melt spinning, melt blowing and sol–gel have been studied, and results compared with literature values

Solid-phase Change Controlling the Tensile and Creep-behavior of Gel-spun High-modulus Polyethylene Fibers

Tensile and creep tests have been conducted on monofilaments of gel-spun high-modulus polyethylene fibres. Fibre strength has been determined over a temperature range - 175-100-degrees-C. The creep studies have revealed changes in behaviour which depend on the applied stress and the temperature. The results of these studies are explained by a change in crystallographic structure from orthorhombic to hexagonal which can take place under certain conditions of temperature and applied stress. It has therefore been possible to determine the applied stress necessary to obtain the change of phase as a function of temperature