40 research outputs found
3D meso-scale modelling of concrete material in spall tests
Tensile strength is one of the key factors of concrete material that need be accurately defined in analysis of concrete structures subjected to high-speed impact loads. Dynamic tensile strength of concrete material is usually obtained by conducting laboratory tests such as direct tensile test, Brazilian splitting test and spall test. Concrete is a heterogeneous material with different components, but is conventionally assumed to be homogeneous, i.e., cement mortar only, in most previous experimental or numerical studies. The aggregates in concrete material are usually neglected owing to testing limitation and numerical simplification. It has been well acknowledged that neglecting coarse aggregates might not necessarily give accurate concrete dynamic material properties. In the present study, a 3D meso-scale model of concrete specimen with consideration of cement mortar and aggregates is developed to simulate spall tests and investigate the behaviour of concrete material under high strain rate. The commercial software LS-DYNA is used to perform the numerical simulations of spall tests. The mesh size sensitivity is examined by conducting mesh convergence tests. The reliability of the numerical model in simulating the spall tests is verified by comparing the numerical results with the experimental data from the literature. The influence of coarse aggregates on the experimental test results is studied. The wave attenuation in concrete specimen is analysed, and empirical equations are proposed for quick assessment of the test data to determine the true dynamic tensile strength of concrete material. The contributions of aggregates to dynamic strength in spall tests are quantified for modifying the test results based on mortar material in the literature
Spalling uniaxial strength of Al2O3 at high strain rates
In this article research into the uniaxial tensile strength of Al2O3 monolithic ceramic is presented. The experimental procedure of the spalling of long bars is investigated from different approaches. This method is used to obtain the tensile strength at high strain rates under uniaxial conditions. Different methodologies proposed by several authors are used to obtain the tensile strength. The hypotheses needed for the experimental set-up are also checked, and the requirements of the set-up and the variables are also studied by means of numerical simulations. The research shows that the shape of the projectile is crucial to achieve successfully tests results. An experimental campaign has been carried out including high speed video and a digital image correlation system to obtain the tensile strength of alumina. Finally, a comparison of the test results provided by three different methods proposed by different authors is presented. The tensile strength obtained from the three such methods on the same specimens provides contrasting results. Mean values vary from one method to another but the trends are similar for two of the methods. The third method gives less scatter, though the mean values obtained are lower and do not follow the same trend as the other methods for the different specimens
Damping Ratio of Foundation Bed with Multilayered Rubber-Soil Mixtures
In this paper, a series of plate load tests on a sandy soil bed containing multiple layers of granulated rubber-soil mixture (RSM) under incremental cyclic loading was performed. Incremental cyclic loading in five steps with amplitudes of 140, 280, 420, 560 and 700 kPa were applied to the loading plate to evaluate the settlement behavior and damping ratios of foundation bed. The results show that both the total and residual settlements of the loading plate decrease with increase in the number of RSM layers, regardless of the level of applied cyclic load, but the rate of reduction in both settlements reduces with increase in the number of RSM layers. There is also an appreciable improvement in the value of the damping capacity with increase in the number of RSM layers as the damping ratio increases by 4-5% beyond the value of 12-15% obtained on untreated sand. On the basis of the study, the concept of using multiple RSM layers not only is a very attractive material to achieve vibration attenuation for machine foundation and railway track beds, but also, the environmental impacts of waste tires are attenuated by using as composite materials in geotechnical applications