1,726 research outputs found
Acetone in the Atmosphere of Hong Kong, Abundance, Sources and Photochemical Precursors
Intensive field measurements were carried out at a mountain site and an urban site at the foot of the mountain from September to November 2010 in Hong Kong. Acetone was monitored using both canister air samples and 2,4-dinitrophenylhydrazine cartridges. The spatiotemporal patterns of acetone showed no difference between the two sites (p > 0.05), and the mean acetone mixing ratios on O3 episode days were higher than those on non-O3 episode days at both sites (p < 0.05). The source contributions to ambient acetone at both sites were estimated using a receptor model i.e. Positive Matrix Factorization (PMF). The PMF results showed that vehicular emission and secondary formation made the most important contribution to ambient acetone, followed by the solvent use at both sites. However, the contribution of biogenic emission at the mountain site was significantly higher than that at the urban site, whereas biomass burning made more remarkable contribution at the urban site than that at the mountain site. The mechanism of oxidation formation of acetone was investigated using a photochemical box model. The results indicated that i-butene was the main precursor of secondary acetone at the mountain site, while the oxidation of i-butane was the major source of secondary acetone at the urban site.Department of Civil and Environmental Engineerin
Emissions of Volatile Organic Compounds Inferred From Airborne Flux Measurements over a Megacity
Toluene and benzene are used for assessing the ability to measure disjunct eddy covariance (DEC) fluxes of Volatile Organic Compounds (VOC) using Proton Transfer Reaction Mass Spectrometry (PTR-MS) on aircraft. Statistically significant correlation between vertical wind speed and mixing ratios suggests that airborne VOC eddy covariance (EC) flux measurements using PTR-MS are feasible. City-median midday toluene and benzene fluxes are calculated to be on the order of 14.1&plusmn;4.0 mg/m<sup>2</sup>/h and 4.7&plusmn;2.3 mg/m<sup>2</sup>/h, respectively. For comparison the adjusted CAM2004 emission inventory estimates toluene fluxes of 10 mg/m<sup>2</sup>/h along the footprint of the flight-track. Wavelet analysis of instantaneous toluene and benzene measurements during city overpasses is tested as a tool to assess surface emission heterogeneity. High toluene to benzene flux ratios above an industrial district (e.g. 10–15 g/g) including the International airport (e.g. 3–5 g/g) and a mean flux (concentration) ratio of 3.2&plusmn;0.5 g/g (3.9&plusmn;0.3 g/g) across Mexico City indicate that evaporative fuel and industrial emissions play an important role for the prevalence of aromatic compounds. Based on a tracer model, which was constrained by BTEX (BTEX– Benzene/Toluene/Ethylbenzene/m, p, o-Xylenes) compound concentration ratios, the fuel marker methyl-tertiary-butyl-ether (MTBE) and the biomass burning marker acetonitrile (CH<sub>3</sub>CN), we show that a combination of industrial, evaporative fuel, and exhaust emissions account for >87% of all BTEX sources. Our observations suggest that biomass burning emissions play a minor role for the abundance of BTEX compounds in the MCMA (2–13%)
Recommended from our members
Dimethyl disulfide (DMDS) and dimethyl sulfide (DMS) emissions from biomass burning in Australia
We identify dimethyl disulfide (DMDS) as the major reduced sulfur-containing gas emitted from bushfires in Australia's Northern Territory. Like dimethyl sulfide (DMS), DMDS is oxidized in the atmosphere to sulfur dioxide (SO2) and methane sulfonic acid (MSA), which are intermediates in the formation of sulfuric acid (H2SO4). The mixing ratios of DMDS and DMS were the highest we have ever detected, with maximum values of 113 and 35 ppbv, respectively, whereas background values were below the detection limit (10 pptv). Molar emission ratios relative to carbon monoxide (CO) were [1.6 ± 0.1] × 10-5 and [6.2 ± 0.3] × 10-6, for DMDS and DMS respectively, while molar emission ratios relative to carbon dioxide (CO2) were [4.7 ± 0.4] × 10 6 and [1.4 ± 0.4] × 10 7, respectively. Assuming these observations are representative of biomass burning, we estimate that biomass burning could yield up to 175 Gg/yr of DMDS (119 Gg S/yr) and 13 Gg/yr of DMS
Nonmethane hydrocarbon and halocarbon distributions during Atlantic Stratocumulus Transition Experiment/Marine Aerosol and Gas Exchange, June 1992
Aircraft measurements of selected nonmethane hydrocarbon and halocarbon species were made in the lower troposphere of the NE Atlantic near the Azores, Portugal, during June 1992 as part of the Atlantic Stratocumulus Transition Experiment/Marine Aerosol and Gas Exchange. In this paper, the impact of continental outflow from both Europe and North America on the study region were assessed. Four main air mass types were characterized from trajectories and trace gas concentrations: clean marine from the Atlantic, and continental air from the Iberian Peninsula, the British Isles and Northern Europe, and North America. Each classification exhibited trace gas concentrations that had been modified en route by photochemical processes and mixing. Comparison with the clean marine boundary layer (MBL) shows that the boundary layer of the predominantly continental air masses were enhanced in hydrocarbons and halocarbons by factors of approximately 2 for ethane, 5 for propane, 2-6 for ethyne and benzene, and 2-3 for C2Cl4. The same air masses also exhibited large ozone enhancements, with 2 to 3 times higher mixing ratios in the continental boundary layer air compared to the clean MBL. This indicates a primarily anthropogenic photochemical source for a significant fraction of the lower tropospheric ozone in this region. Methyl bromide exhibited on average 10-20% higher concentrations in the boundary layer affected by continental outflow than in the clean MBL, and was seen to be enhanced in individual plumes of air of continental origin. This is consistent with significant anthropogenic sources for methyl bromide. In addition, median MBL concentrations of ethene and methyl iodide showed enhancements of approximately a factor of 2 above free tropospheric values, suggesting primarily coastal/oceanic sources for these species. Copyright 1996 by the American Geophysical Union
The subtropical global plume in the Pacific Exploratory Mission-Tropics A (PEM-Tropics A), PEM-Tropics B, and the Global Atmospheric Sampling Program (GASP): How tropical emissions affect the remote Pacific
[1] An extended southern subtropical plume of CO meanders>15,000 km around the world, gradually spreading around 20 S. This southern pollution plume is most noticeable in the burning season, southern spring; a similar subtropical plume appears in the northern spring. We use tracer maps to guide the use of trajectories to trace observations of the plume to their origins. The MM5 mesoscale model provides high-resolution, near-global synoptic reconstructions of the weather. Two situations are analyzed: NASA’s airborne Pacific Exploratory Mission-Tropics A (PEM-Tropics A) period, September–October 1996 and the PEM-Tropics B period, March–April 1999. Similar features are noted for a much earlier mission in 1977, which apparently captured the first, but never-recognized, samples of the global pollution of the Southern Hemisphere. For PEM-Tropics A, near-source pieces of the plume are clearly seen in the Total Ozone Mapping Spectrometer (TOMS) absorbing aerosol product and are well simulated. Downwind, the aircraft sampling of several strands deriving from a single plume seems representative and well simulated. A general mechanism of the plume emerges: The southern plume arises in surface accumulation regions in Africa and Sout
Recommended from our members
New Directions: Enhancing the natural sulfur cycle to slow global warming
Recommended from our members
Long-term decrease in the global atmospheric burden of tetrachloroethene (C2Cl4)
We present a 14-year record of tropospheric tetrachloroethene (C2Cl4) mixing ratios measured each season at remote surface locations throughout the Pacific Basin (71°N-47°S . Our calculated annual mean C2Cl4 mixing ratio for the extra-tropical northern hemisphere (NH) was 13.9 ± 0.5 pptv in 1989, but declined to less than half this value (to 6.5 ± 0.2 pptv) by 2002. Mid-latitude southern hemisphere (SH) mixing ratios, which were much smaller than NH values, showed interannual variations comparable to measured long-term changes, and the SH annual mean was slightly less in 2002 than in 1989. Driven by the relatively large decrease in NH values, the global C2Cl4, mixing ratio declined from 6.3 ± 0.6 pptv in 1989 to 3.5 ± 0.2 pptv in 2002. These values suggest that the global C2Cl4 burden decreased by roughly 205 Gg between 1989-2002, which is consistent with industrial estimates of declining NH emissions over a similar period. Copyright 2004 by the American Geophysical Union
Atmospheric residence time of CH3Br estimated from the junge spatial variability relation
The atmospheric residence time for methyl bromide (CH3Br) has been estimated as 0.8 +/- 0.1 years from its empirical spatial variability relative to C2H6, C2Cl4, CHCl3, and CH3Cl. This evaluation of the atmospheric residence time, based on Junge's 1963 general proposal, provides an estimate for CH3Br that is independent of source and sink estimates. Methyl bromide from combined natural and anthropogenic sources furnishes about half of the bromine that enters the stratosphere, where it plays an important role in ozone destruction. This residence time is consistent with the 0.7-year value recently calculated for CH3Br from the combined strength estimates for its known significant sinks
- …