Selectivity of benzene sulphonation in three gas—liquid reactors with different mass transfer characteristics: II: Mass transfer and selectivity in a cyclone reactor and in a tube reactor

Liquid benzene was sulphonated with gaseous sulphur trioxide in a tube reactor and in a new gas—liquid cyclone reactor. The products are benzenesulphonic acid and diphenyl sulphone (byproduct). The observed selectivity depends on the conversion, the initial benzene concentration and the mass transfer characteristics of the reactor. Minimum diphenyl sulphone formation was obtained for a low initial benzene concentration, a low benzene conversion and with a high liquid-side mass transfer coefficient, as in the cyclone reactor. As the actual mass transfer rate during sulphonation could not be measured, the observed selectivity was related to the mass transfer coefficient determined by the simultaneous absorption of CO2and O2 in aqueous sodium hydroxide solution

Cometabolic Degradation of Trichloroethylene by Pseudomonas cepacia G4 in a Chemostat with Toluene as the Primary Substrate

Pseudomonas cepacia G4 is capable of cometabolic degradation of trichloroethylene (TCE) if the organism is grown on certain aromatic compounds. To obtain more insight into the kinetics of TCE degradation and the effect of TCE transformation products, we have investigated the simultaneous conversion of toluene and TCE in steady-state continuous culture. The organism was grown in a chemostat with toluene as the carbon and energy source at a range of volumetric TCE loading rates, up to 330 mumol/liter/h. The specific TCE degradation activity of the cells and the volumetric activity increased, but the efficiency of TCE conversion dropped when the TCE loading was elevated from 7 to 330 mumol/liter/h. At TCE loading rates of up to 145 mumol/liter/h, the specific toluene conversion rate and the molar growth yield of the cells were not affected by the presence of TCE. The response of the system to varying TCE loading rates was accurately described by a mathematical model based on Michaelis-Menten kinetics and competitive inhibition. A high load of 3,400 mumol of TCE per liter per h for 12 h caused inhibition of toluene and TCE conversion, but reduction of the TCE load to the original nontoxic level resulted in complete recovery of the system within 2 days. These results show that P. cepacia can stably and continuously degrade toluene and TCE simultaneously in a single-reactor system without biomass retention and that the organism is more resistant to high concentrations and shock loadings of TCE than Methylosinus trichosporium OB3b

Effect of Mass Transfer Limitations on the Enzymatic Kinetic Resolution of Epoxides in a Two-Liquid-Phase System

Optically active epoxides can be obtained by kinetic resolution of racemic mixtures using enantioselective epoxide hydrolases. To increase the productivity of the conversion of sparingly aqueous soluble epoxides, we investigated the use of a two-phase aqueous/organic system. A kinetic model which takes into account interphase mass transfer, enzymatic reaction, and enzyme inactivation was developed to describe epoxide conversion in the system by the epoxide hydrolase from Agrobacterium radiobacter. A Lewis cell was used to determine model parameters and results from resolutions carried out in the Lewis cell were compared to model predictions to validate the model. It was found that n-octane is a biocompatible immiscible solvent suitable for use as the organic phase. Good agreement between the model predictions and experimental data was found when the enzyme inactivation rate was fitted. Simulations showed that mass transfer limitations have to be avoided in order to maximize the yield of enantiomerically pure epoxide. Resolution of a 39 g/L solution of racemic styrene oxide in octane was successfully carried out in an emulsion batch reactor to obtain (S)-styrene oxide in high enantiomeric excess (>95% e.e.) with a yield of 30%.

NADH-Regulated Metabolic Model for Growth of Methylosinus trichosporium OB3b. Cometabolic Degradation of Trichloroethene and Optimization of Bioreactor System Performance

A metabolic model describing growth of Methylosinus trichosporium OB3b and cometabolic contaminant conversion is used to optimize trichloroethene (TCE) conversion in a bioreactor system. Different process configurations are compared: a growing culture and a nongrowing culture to which TCE is added at both constant and pulsed levels. The growth part of the model, presented in the preceding article, gives a detailed description of the NADH regeneration required for continued TCE conversion. It is based on the metabolic pathways, includes Michaelis-Menten type enzyme kinetics, and uses NADH as an integrating and controlling factor. Here the model is extended to include TCE transformation, incorporating the kinetics of contaminant conversion, the related NADH consumption, toxic effects, and competitive inhibition between TCE and methane. The model realistically describes the experimentally observed negative effects of the TCE conversion products, both on soluble methane monooxygenase through the explicit incorporation of the activity of this enzyme and on cell viability through the distinction between dividing and nondividing cells. In growth-based systems, the toxicity of the TCE conversion products causes rapid cell death, which leads to wash-out of suspended cultures at low TCE loads (below μM inlet concentrations). Enzyme activity, which is less sensitive, is hardly affected by the toxicity of the TCE conversion products and ensures high conversions (>95%) up to the point of wash-out. Pulsed addition of TCE (0.014-0.048 mM) leads to a complete loss of viability. However, the remaining enzyme activity can still almost completely convert the subsequently added large TCE pulses (0.33-0.64 mM). This emphasizes the inefficient use of enzyme activity in growth-based systems. A comparison of growth-based and similar non-growth-based systems reveals that the highest TCE conversions per amount of cells grown can be obtained in the latter. Using small amounts of methane (negligible compared to the amount needed to grow the cells), NADH limitation in the second step of this two-step system can be eliminated. This results in complete utilization of enzyme activity and thus in a very effective treatment system.

NADH-Regulated Metabolic Model for Growth of Methylosinus trichosporium OB3b. Model Presentation, Parameter Estimation, and Model Validation

A biochemical model is presented that describes growth of Methylosinus trichosporium OB3b on methane. The model, which was developed to compare strategies to alleviate NADH limitation resulting from cometabolic contaminant conversion, includes (1) catabolism of methane via methanol, formaldehyde, and formate to carbon dioxide; (2) growth as formaldehyde assimilation; and (3) storage material (poly-β-hydroxybutyric acid, PHB) metabolism. To integrate the three processes, the cofactor NADH is used as central intermediate and controlling factor-instead of the commonly applied energy carrier ATP. This way a stable and well-regulated growth model is obtained that gives a realistic description of a variety of steady-state and transient-state experimental data. An analysis of the cells’ physiological properties is given to illustrate the applicability of the model. Steady-state model calculations showed that in strain OB3b flux control is located primarily at the first enzyme of the metabolic pathway. Since no adaptation in VMAX values is necessary to describe growth at different dilution rates, the organism seems to have a “rigid enzyme system”, the activity of which is not regulated in response to continued growth at low rates. During transient periods of excess carbon and energy source availability, PHB is found to accumulate, serving as a sink for transiently available excess reducing power.