13 research outputs found
Oxidation Stability of Fatty Acid Methyl Ester under Three Different Conditions
Maintaining fuel stability is one important criterion in sustaining the quality of fuels. This research investigated the production of biodiesel from waste groundnut oil and the oxidation stability of the biodiesel samples stored under three conditions (a vacuum, a fridge and an exposure to atmosphere) by considering their saponification values, percentage of free fatty acid, peroxide values, iodine values and viscosity. Maximum biodiesel yield was obtained at 9 methanol/oil mole ratio, 1.0w/w%Oil KOH catalyst concentration, reaction time of 60 minutes and reaction temperature of 60 0C. The results showed that biodiesel oxidation stability is adversely affected by increase in saponification value, percentage of free fatty acid, peroxide value; and decrease in iodine value and viscosity. Also, the results of these physico-chemical properties shows that vacuum is the most favourable storage condition, compared to freezing and atmospheric conditions. Keywords: Atmosphere, Biodiesel, Refrigerator, Trans-esterification, Vacuu
ASSESSMENT OF THE POTENTIAL EMISSIONSFROM BIODIESEL PRODUCED FROM GROUNDNUT AND SOYBEAN OILS
Biodiesel an alternative fuel to fossil fuel) does not only require production at commercial level, but the production process also
needs to be a clean and environmental friendly. This research aim at assessing the potential emissions form the biodiesel
produced from the trans-esterification of groundnut oil and soybean oil, using KOH homogenous catalyst. The impact assessment
of the potential emissions wasanalysed, quantified and characterized using Simapro 8.2.3.0. Comparatively, soybean biodiesel
produced higher yield of biodiesel compare to yield obtained from groundnut oil biodiesel, under same experimental conditions.
Also, high yields of biodiesel observed (97.1 % using both soybean oil and 92.1 % using groundnut oil) were at experimental
conditions of 52.5oC and catalyst concentration 0.9 wt/wt%, at constant methanol/oil mole ratio of 6 and reaction time of 1 hour.
The impact assessment of the emissions from the biodiesels obtained from the two oils revealed that groundnut oil biodiesel has
the potential to release more fresh water toxic substances, terrestrial toxic substances and human toxic substances
A comparative evaluation of fermentable sugars production from oxidative, alkaline, alkaline peroxide oxidation, dilute acid, and molten hydrate salt pretreatments of corn cob biomass
Production of high value-added products from lignocelluloses is an economically
sustainable alternative to decreasing dependence on fossil fuels and making the chemical processes
environmentally friendly. In this study, different methodologies of alkaline (Ca(OH)2 and NaOH),
dilute acid (10%w/w H2SO4), hydrogen peroxide (H2O2), alkaline peroxide oxidation (H2O2/Ca(OH)2
and H2O2/NaOH), and molten hydrated salt (MHS) mediated (ZnCl2.4H2O) pretreatments were
employed in the hydrolysis of corncob amenable to enzymatic hydrolysis. Optimal enzyme
hydrolysis temperature (considering 45 and 50 ℃) and time (2, 24, 72, and 96 h) were investigated for
each pretreatment procedure to ascertain the concentrations of glucose, xylose, and total sugar
present in the corncob. At 45 ℃ and 96 h, NaOH alkaline pretreatment achieved the best optimum
total sugar production of 75.54 mg/mL (about 54% and 88% increments compared to dilute acid
pretreatment (35.06 mg/mL total sugars) and MHS (9.32 mg/mL total sugar) pretreatment
respectively). In this study, total sugars production increased appreciably at 45 ℃ and longer
hydrolysis period (96 h) compared to hydrolysis at 50 ℃ (with maximum total sugars production of 18.00 mg/mL at 96 h). Scanning electron microscopic imaging of the untreated and treated
samples displayed cell wall distortion and surface disruptions.Covenant University, Ota, Nigeria.http://www.aimspress.com/journal/energypm2021Chemical Engineerin
A Review on Corrosion in Concrete Structure: Inhibiting Admixtures and Their Compatibility in Concrete
The development in marine industry and its effort in building bridges has
placed a huge demand on reliability and duration of service of reinforcing
steel in concrete. Literature has documented several studies on corrosion of
reinforcing steel in concrete induced via carbonation and chloride in marine
milieus. Extension of concrete structures service life has been one of the
foremost strong worries of the concrete industry, especially for marine
industry. Hence, the necessity to employ a cost effect system for shielding the
reinforced steel in concrete from corrosion. Studies have shown that one
prospective solution in combating corrosion deterioration in reinforced steel
in concrete structures is the introduction of corrosion-inhibiting admixtures
into concrete. This review discussed at length corrosion in reinforced concrete
and corrosion inhibitors in relation to concrete together with the classification
of inhibitors based on the method of applications. This review further reports
corrosion-inhibiting admixtures in concrete. As a result, the aspects of corrosion inhibitors this manuscript reviewed are corrosion inhibitors
employed as admixtures in concrete for new construction in the marine
industry. Furthermore, corrosion inhibitors are employed for repairs and
maintenances admixed with concrete for patches on marine structures,
squirted onto the surface of the concrete or put on the concrete surface via
saturation treatment. As a result of the excellent properties of functional
nanostructured materials, the advancement in the implementation of
functional materials in inhibiting admixtures in concrete is fast growing in
marine industry. Hence, the Integration of functional materials in inhibiting
admixture and their compatibility were reviewed. The significance of inhibitors
employed as admixtures in concrete for practical applications of corrosion are
the suppression or mitigation of corrosion process of metals used in marine
industry and the patches of already constructed structures. The current
problems related to corrosion-inhibiting admixtures in concrete and the future
research and development directions were discussed
Influence of aluminum silicate stabilizer on the coating structural composition and characteristics of multifunctional developed composite coating: a buildup for defense application.
Data on calcium oxide and cow bone catalysts used for soybean biodiesel production
Biodiesel was produced from soybean oil using calcium oxide and cow bone as heterogeneous catalysts, through transesterification process. The soybean oil used was characterized using gas chromatography mass spectrometer (GCMS) and the cow bone catalyst produced was characterized X-ray fluorescence (XRF) spectrometer. The effects of the variation of methanol/oil mole ratio, catalyst concentration and reaction temperature on biodiesel yield during the transesterification of soybean oil were investigated. Reaction time of 3 h and stirring rate of 500 rpm were kept constant. Using Response Optimizer (Minitab 17), the optimum conditions for biodiesel production were established. It was observed that the calcination of cow bone catalyst enhanced its conversion to apatite-CaOH. Also, the results obtained showed that the performance trends of calcined cow bone catalyst and the conventional CaO catalyst were similar. Keywords: Biodiesel, Calcined cow bone, Catalyst, Soybea
Data on CaO and eggshell catalysts used for biodiesel production
This research investigated the production of biodiesel from soybean oil (transesterification process) using pure calcium oxide and calcium oxide obtained from eggshell as heterogeneous catalysts. Uncalcined eggshell and calcined eggshell catalysts produced were analysed using XRF and XRD spectrometers. The processing parameters considered during the transesterification of the soybean were methanol/oil mole ratio, catalyst concentration and reaction time and their effects on biodiesel yield were evaluated. Reaction temperature of 60 °C and stirring rate of 450 rpm (revolution per minute) were kept constant. As a result of calcination, XRF analysis revealed an increase in CaO percentage composition of eggshell catalyst from 96% to 97%. Also, the biodiesel yields obtained revealed similar performance patterns for both the calcined eggshell catalyst and the pure CaO catalyst. Keywords: Biodiesel, Calcined eggshell, Catalys
Optimization of Experimental Conditions for Biodiesel Production
Abstract-- Index Term-- Biodiesel, fossil fuel, methanol, transesterification, waste cooking oil