32 research outputs found
Specific Features of the Hydrogen-Induced Discrete (Jumplike) Structural Evolution in Pd–Ta–H and Pd–Mo–H Alloys
The stochastic nature of phase transformations in a Pd–Ni alloy after electrolytic hydrogenation
Angular Molecular–Electronic Sensor with Negative Magnetohydrodynamic Feedback
A high-precision angular accelerometer based on molecular–electronic transfer (MET) technology with a high dynamic range and a low level of self-noise has been developed. Its difference from the analogues is in the use of liquid (electrolyte) as the inertial mass and the use of negative feedback based on the magnetohydrodynamic effect. This article reports on the development of the angular molecular–electronic accelerometer with a magnetohydrodynamic cell for the creation of negative feedback, and the optimization of electronics for the creation of a feedback signal. The main characteristics of the angular accelerometer, such as amplitude–frequency characteristics, self-noise and Allan variance were experimentally measured. The obtained output parameters were compared to its analogues and it showed perspectives for further development in this field
Stochastic structural changes in deformed hydrogen-saturated Pd-Ta alloys from the kinetic X-ray data
Physics of the evolution of structure and elastic stresses in Pd-Mo alloys saturated with hydrogen
Influence of the Dielectric Coating of the Outer Side of the Cathode in the Anode–Cathode Pairs of a Molecular Electronic Sensitive Element on the Conversion Coefficient
Molecular electronic sensors of motion parameters use miniature electrochemical cells as a sensitive element, in which the interelectrode current is sensitive to external mechanical influences. New approaches for creating conversion elements are based on precision methods of micromachining materials. The use of new technologies has opened up the possibility of creating sensitive elements with configurations that have not been previously studied, and for which there is no clear understanding of the regularities that determine the output parameters depending on the geometry of the conversion elements. This work studies the influence of the dielectric coating on the surface of the cathodes on the conversion coefficient. The transforming structure has been made from three plates. The outer plates were an anode–cathode electrode pair. The middle plate served as a separator between the pairs of electrodes. It was found that an insulating layer on the side of the cathode facing away from the adjacent anode allows the conversion factor to be doubled. This result is applicable for a wide class of conversion elements made with microelectronic technologies, as well as structures made of mesh electrodes