Investigations on doping of amorphous and nano-crystalline silicon films deposited by catalytic chemical vapour deposition

Hydrogenated amorphous and nanocrystalline silicon, deposited by catalytic chemical vapour deposition, have been doped during deposition by the addition of diborane and phosphine in the feed gas, with concentrations in the region of 1%. The crystalline fraction, dopant concentration and electrical properties of the films are studied. The nanocrystalline films exhibited a high doping efficiency, both for n and p doping, and electrical characteristics similar to those of plasma-deposited films. The doping efficiency of n-type amorphous silicon is similar to that obtained for plasma-deposited electronic-grade amorphous silicon, whereas p-type layers show a doping efficiency of one order of magnitude lower. A higher deposition temperature of 450°C was required to achieve p-type films with electrical characteristics similar to those of plasma-deposited films

Spectral analysis of the angular distribution function of back reflectors for thin film silicon solar cells

Nowadays, one of the most important challenges to enhance the efficiency of thin film silicon solar cells is to increase the short circuit intensity by means of optical confinement methods, such as textured back-reflector structures. In this work, two possible textured structures to be used as back reflectors for n-i-p solar cells have been optically analyzed and compared to a smooth one by using a system which is able to measure the angular distribution function (ADF) of the scattered light in a wide spectral range (350-1000 nm). The accurate analysis of the ADF data corresponding to the reflector structures and to the μc-Si:H films deposited onto them allows the optical losses due to the reflector absorption and its effectiveness in increasing light absorption in the μc-Si:H layer, mainly at long wavelengths, to be quantified

Thin silicon films ranging from amorphous to nanocrystalline obtained by Hot-Wire CVD

In this paper, we have presented results on silicon thin films deposited by hot-wire CVD at low substrate temperatures (200 °C). Films ranging from amorphous to nanocrystalline were obtained by varying the filament temperature from 1500 to 1800 °C. A crystalline fraction of 50% was obtained for the sample deposited at 1700 °C. The results obtained seemed to indicate that atomic hydrogen plays a leading role in the obtaining of nanocrystalline silicon. The optoelectronic properties of the amorphous material obtained in these conditions are slightly poorer than the ones observed in device-grade films grown by plasma-enhanced CVD due to a higher hydrogen incorporation (13%)

Aluminium induced texturing of glass substrates with improved light management for thin film solar cells

Aluminium induced texturing (AIT) method has been used to texture glass substrates to enhance photon absorption in microcrystalline thin film Si solar cells. In this process, a thin Al film is deposited on a glass substrate and a non-uniform redox reaction between the glass and the Al film occurs when they are annealed at high temperature. After etching the reaction products, the resultant glass surface presents a uniform and rough morphology. In this work, three different textures (­σrms ~85, ~95, ~125 nm) have been achieved by tuning the dc sputtering power and over them and over smooth glass, pin microcrystalline silicon solar cells have been fabricated. The cells deposited over the textured substrates showed an efficiency improvement in comparison to the cells deposited over the smooth glass. The best result was given for the glass texture σrms~125 nm that led to an average efficiency 2.1% higher than that given by the cell deposited on smooth glas

Investigation of defect formation and electronic transport in microcrystalline silicon deposited by hot-wire CVD

We have investigated doped and undoped layers of microcrystalline silicon prepared by hot-wire chemical vapour deposition optically, electrically and by means of transmission electron microscopy. Besides needle-like crystals grown perpendicular to the substrate's surface, all of the layers contained a noncrystalline phase with a volume fraction between 4% and 25%. A high oxygen content of several per cent in the porous phase was detected by electron energy loss spectrometry. Deep-level transient spectroscopy of the crystals suggests that the concentration of electrically active defects is less than 1% of the undoped background concentration of typically 10^17 cm -3. Frequency-dependent measurements of the conductance and capacitance perpendicular to the substrate surface showed that a hopping process takes place within the noncrystalline phase parallel to the conduction in the crystals. The parasitic contribution to the electrical circuit arising from the porous phase is believed to be an important loss mechanism in the output of a pin-structured photovoltaic solar cell deposited by hot-wire CVD

Kelvin probe measurements of microcrystalline silicon on a nanometer scale using SFM

Work function measurements on cross-sectioned microcrystalline pin silicon solar cells deposited by Hot-Wire CVD are presented. The experiment is realized by combining a modified Kelvin probe experiment and a scanning force microscope. The measured surface potential revealed that the built-in electric drift field is weak in the middle of the compensated intrinsic layer. A graded donor distribution and a constant boron compensation have to be assumed within the intrinsic layer in order to obtain coincidence of the measurements and simulations. The microcrystalline p-silicon layer and the n-type transparent conducting oxide form a reverse polarized diode in series with the pin diode