Turbulence Models Studying the Airflow around a Greenhouse Based in a Wind Tunnel and Under Different Conditions

Turbulence phenomena created around a greenhouse due to different wind loads are key factors in its structural design and significantly affect the ventilation rates through its side and roof openings. Using the turbulence models of ANSYS FLUENT software to investigate the airflow around an arched-roof-greenhouse-shaped obstacle placed inside a wind tunnel was the aim of this study. Velocity and pressure areas around the obstacle were examined by selecting three different turbulence models (Standard, RNG and Realizable k–ε models) under three different airflow entry velocities (0.34, 1.00 and 10.00 m s−1) in the wind tunnel. All k–ε models showed that when the air velocity was intensified, the airflow was identified as turbulent. The horizontal velocity profile predicted more accurately the presence of vortices in contrast with the vector sum of the perpendicular velocity components. Vortices were formed upstream, above the roof and downstream of the obstacle, and the applied models showed that when airflow velocity increases, the size of the upstream vortex decreases. Finally, there was a strong indication from the modeling results that the vortex on the roof of the obstacle was an extension of the vortex that was created downstream

Improvement of the Performance of an Earth to Air Heat Exchanger for Greenhouse Cooling by the Incorporation of Water Finned Tubes—A Theoretical Approach

Proper climatic conditions in greenhouses are one of the major parameters to ensure optimum crop development. The installation of heating and cooling systems are the common solution to form a proper microclimate inside the greenhouse. However, the operation of these systems is accompanied by energy consumption. Therefore, many methods and alternative systems are sought to encounter this issue. A system which has been examined as an alternative solution for full or partial cover of a greenhouse is the Earth to Air Heat Exchanger (EAHE). Up to now, many research works have concentrated on the investigation and operation of such systems. In this study, a method to enhance the efficiency of the EAHE is examined based on the simultaneous flow of water (Water assisted earth to air heat exchanger—WAEAHE) following the concept of a double pipe heat exchanger which has been widely used in other applications. Furthermore, the improvement of the systems’ efficiency is investigated via the application of fins on the internal pipe of the heat exchanger. For the purpose of the study, different case studies have been investigated in order to reach safe results conserving the parameters affecting its efficiency. The results of the theoretical analysis have shown that the application of an internal water pipe can increase the system’s efficiency sufficiently, while it is further increased with the application of fins. In fact, the application of fins can lead to an increase of the overall heat transfer coefficients varying from 36–68%. In the current study, only the energy efficiency of the system was estimated. This system needs to be further investigated to be technically and financially efficient and applicable in actual case studies

Improvement of the Performance of an Earth to Air Heat Exchanger for Greenhouse Cooling by the Incorporation of Water Finned Tubes—A Theoretical Approach

Proper climatic conditions in greenhouses are one of the major parameters to ensure optimum crop development. The installation of heating and cooling systems are the common solution to form a proper microclimate inside the greenhouse. However, the operation of these systems is accompanied by energy consumption. Therefore, many methods and alternative systems are sought to encounter this issue. A system which has been examined as an alternative solution for full or partial cover of a greenhouse is the Earth to Air Heat Exchanger (EAHE). Up to now, many research works have concentrated on the investigation and operation of such systems. In this study, a method to enhance the efficiency of the EAHE is examined based on the simultaneous flow of water (Water assisted earth to air heat exchanger—WAEAHE) following the concept of a double pipe heat exchanger which has been widely used in other applications. Furthermore, the improvement of the systems’ efficiency is investigated via the application of fins on the internal pipe of the heat exchanger. For the purpose of the study, different case studies have been investigated in order to reach safe results conserving the parameters affecting its efficiency. The results of the theoretical analysis have shown that the application of an internal water pipe can increase the system’s efficiency sufficiently, while it is further increased with the application of fins. In fact, the application of fins can lead to an increase of the overall heat transfer coefficients varying from 36–68%. In the current study, only the energy efficiency of the system was estimated. This system needs to be further investigated to be technically and financially efficient and applicable in actual case studies

A Prototype Passive Solar Drying System: Exploitation of the Solar Chimney Effect for the Drying of Potato and Banana

Agricultural product drying is of great importance as it is a reliable method for fruit and vegetable preservation. Tackling the high energy consumption of the process will reduce the final product cost and mitigate greenhouse gas emissions. In this work, a passive drying method was experimentally evaluated. The method was based on the principle of the stack effect taking place in the solar chimney structure. Different types of solar chimneys in terms of dimensions and materials were evaluated for the drying of banana and potato slices. The results of the experiments showed that the drying rate was close to solar drying systems. Parameters such as height and material characteristics of drying tubes, as also weather conditions, influenced the drying rate. It was found that the banana and potato slices were dried at a satisfactory rate for almost 48 h during the summer period in Greece. From the parameters of the drying tubes that were varied, it was found that both the height and material played a major role, as did the air flow rate. With the increase in the drying tube by 1 m and with the choice of proper manufacturing material, an increase in the flow rate between 40% and 100% can be achieved. When only the color of two 3 m-high tubes changed, the flow rate varied between 4% and 15%. The proposed method has almost zero energy consumption, and it could be used as a standalone or as a part of a hybrid drying system. It can also be adjusted in existing greenhouse-type agricultural structures as a parallel operation system

A Prototype Passive Solar Drying System: Exploitation of the Solar Chimney Effect for the Drying of Potato and Banana

Agricultural product drying is of great importance as it is a reliable method for fruit and vegetable preservation. Tackling the high energy consumption of the process will reduce the final product cost and mitigate greenhouse gas emissions. In this work, a passive drying method was experimentally evaluated. The method was based on the principle of the stack effect taking place in the solar chimney structure. Different types of solar chimneys in terms of dimensions and materials were evaluated for the drying of banana and potato slices. The results of the experiments showed that the drying rate was close to solar drying systems. Parameters such as height and material characteristics of drying tubes, as also weather conditions, influenced the drying rate. It was found that the banana and potato slices were dried at a satisfactory rate for almost 48 h during the summer period in Greece. From the parameters of the drying tubes that were varied, it was found that both the height and material played a major role, as did the air flow rate. With the increase in the drying tube by 1 m and with the choice of proper manufacturing material, an increase in the flow rate between 40% and 100% can be achieved. When only the color of two 3 m-high tubes changed, the flow rate varied between 4% and 15%. The proposed method has almost zero energy consumption, and it could be used as a standalone or as a part of a hybrid drying system. It can also be adjusted in existing greenhouse-type agricultural structures as a parallel operation system