A Review of Inorganic Scintillation Crystals for Extreme Environments

In the past, the main research and use of scintillators in extreme environments were mainly limited to high energy physics and the well-logging industry, but their applications are now expanding to reactor monitoring systems, marine and space exploration, nuclear fusion, radiation therapy, etc. In this article, we review and summarize single-crystal inorganic scintillator candidates that can be applied to radiation detection in extreme environments. Crucial scintillation properties to consider for use in extreme environments are temperature dependence and radiation resistance, along with scintillators’ susceptibility to moisture and mechanical shock. Therefore, we report on performance change, with a focus on radiation resistance and temperature dependence, and the availability of inorganic scintillator for extreme environments—high radiation, temperature, humidity and vibration—according to their applications. In addition, theoretical explanations for temperature dependence and radiation resistance are also provided

Scintillation characteristics of chemically processed Ce:GAGG single crystals.

We investigated the correlation between the surface finish and luminescence properties of chemically polished cerium-doped single-crystal Gd3Al2Ga3O12 scintillators (Ce:GAGG), from the crystallographic perspective. The intrinsic defects in the crystals were identified via photoluminescence spectroscopy followed by scanning electron microscopy and X-ray diffraction to analyze their surface morphologies. Finally, the samples were individually wrapped with an enhanced specular reflector (ESR), coupled with a photomultiplier tube, placed inside a dark box, connected to a digitizer, and irradiated with a 137Cs radioactive source to evaluate the relative light (signal) output and energy resolution of each sample. The as-cut (rough) Ce:GAGG single-crystal samples, that were chemically polished with phosphoric acid at 190°C in air for 60 min, demonstrated a 33.1% increase in signal amplitude (light output to photosensor) and 2.4% (absolute value) improvement in energy resolution, which were comparable to those obtained for the mechanically polished sample. For these samples, the surface roughness was found to be ~430 nm, which was approximately half of that of the mechanically polished sample. The chemical polishing method used in this study is a cost-effective and straightforward technique to improve structural imperfections and can facilitate the treatment of inorganic scintillators with complex shapes and/or on a large scale

Performance Comparison of CdTe:Na, CdTe:As, and CdTe:P Single Crystals for Solar Cell Applications

We compared thermal stability, open-circuit voltage, short-circuit current, and fill factor values of single-crystal Cadmium telluride (CdTe) grown using the vertical Bridgman (VB) technique and doped with group V elements (phosphorus and arsenic), and group Ⅰ element (sodium), followed by an annealing process. The sodium-doped CdTe maintained a hole density of 1016 cm−3 or higher; after annealing for a long time, this decreased to 1015 cm−3 or less. The arsenic-doped CdTe maintained a hole density of approximately 1016 cm−3 even after the annealing process; however its bulk minority carrier lifetime decreased by approximately 10%. The phosphorus-doped CdTe maintained its properties after the annealing process, ultimately achieving a hole density of ~1016 cm−3 and a minority carrier lifetime of ~40 ns. The characteristics of a single-crystal solar cell were evaluated using a solar cell device that contained single-crystal CdTe with various dopants. The sodium-doped sample exhibited poor interfacial properties, and its performance decreased rapidly during annealing. The samples doped with group V elements exhibited stable characteristics even during long-term annealing. We concluded, therefore, that group V elements dopants are more suitable for CdTe single-crystal-based solar cell applications involving thermal stress conditions, such as space missions or extreme fabrication temperature environments