3 research outputs found

    Study of mechanical behavior by fatigue of a cracked plate repaired by different composite patches

    Get PDF
    This research is based on the study of the fatigue behavior of an aluminum alloy plate with a central crack. The plate is subjected to a tensile loading on its lower and upper parts. Several parameters were highlighted, such as the loading effect with a load ratio R = 0. The effects of the load ratio on both the repaired and not repaired plates, by two composite patches, which are boron/epoxy and graphite/epoxy, were investigated, as well as the effect of the plate material on plate life, comparing different material

    Comparative study of the repair of cracked plates with two different composite patches

    Get PDF
    The purpose of this study is to analyze the behavior of a crack with and without reinforcement by a composite patch of an aluminum plate in mode I using the finite element method. The repair patch is boron / epoxy and Carbon / epoxy, which are used with great success by many researchers For the distribution of the stresses according to the various loadings, we can conclude that the effect of repair by patch in composite is very distinct, considering the intensities of stresses which decrease for each repair corresponding to the plate not repaired, therefore, the patch in composite dampens the stress field induced at the crack tip and causes a reduction in stresses. The repair with the Bore / epoxy composite patch is more effective than the Carbon/Epoxy patch, this is due to the mechanical properties and the various characteristics specific to boron/Epoxy which gives very significant and very effective results for the repai

    Numerical simulation of a crack emanating from a micro-cavity in the orthopedic cement by technical sub modeling of total hip prosthesis

    Get PDF
    PMMA has important micro structural heterogeneities such as cavities, and its elastic behavior is greatly affected by the presence of defects that may imply its weakening and cause failure. In areas of high concentrations of stress and due to the presence of cavities, micro cracks appear after crushing cavities due to patient movements, and grow and weld to each other until they form a macro     fissure that propagates until the total removal of the prosthesis.. In this study, the existence of a crack emanating from  a cavity with a diameter of 0.7 mm was assumed; our assessment takes into account two parameters, the position of the crack in the cement and we calculated the stress intensity factor (SIF) in the proximal part of orthopedic cement
    corecore