Hormonal modulation of reproduction-specific thiamin carrier protein in the rat

The hormonal modulation of thiamin carrier protein in the plasma and uterine luminal secretion during the normal reproductive phases of the animal (estrous cycle and pregnancy) as well as during experimental estrogenisation was investigated in the rat using a specific and sensitive homologous radioimmunoassay procedure developed for this purpose. Following a single injection of estrogen to immature male rats, thiamin carrier protein rapidly accumulated in plasma attaining peak concentration at 48 h and declining thereafter. A 1.5-fold amplification of the inductive response was observed on secondary stimulation with the hormone. The magnitude of the response exhibited a clear dependency on the dose of the steroid hormone, whereas the time at which peak levels of thiamin carrier protein production was remained unaltered in the concentration range of the steroid tested. The inductive effect of estrogen was severely curtailed by the antiestrogens,viz., En- and Zu-clomiphene citrates, while progesterone was incapable of either modulating the estrogen-induced response or eliciting an induction by itself. Cycloheximide drastically blocked the response to estrogen. Evidence for the ability of uterus to serve as yet another independent site of thiamin carrier protein synthesis was obtained by in vitro incorporation of radioactive amino acids into immunoprecipitable thiamin carrier protein in the tissue explants of estrogenised female rats. The levels of thiamin carrier protein in uterine luminal fluid measured during estrous cycle, pregnancy and experimental estrogenisation exhibited remarkable similarity to the plasma thiamin carrier protein profiles

Temperature dependence of mechanical stiffness and dissipation in ultrananocrystalline diamond

Ultrananocrystalline diamond (UNCD) films are promising for radio frequency micro electro mechanical systems (RF-MEMS) resonators due to the extraordinary physical properties of diamond, such as high Young’s modulus, quality factor, and stable surface chemistry. UNCD films used for this study are grown on 150 mm silicon wafers using hot filament chemical vapor deposition (HFCVD) at 680°C. UNCD fixed free (cantilever) resonator structures designed for the resonant frequencies in the kHz range have been fabricated using conventional microfabrication techniques and are wet released. Resonant excitation and ring down measurements in the temperature range of 138 K to 300 K were conducted under ultra high vacuum (UHV) conditions in a custom built UHV AFM stage to determine the temperature dependence of Young’s Modulus and dissipation (quality factor) in these UNCD cantilever structures. We measured a temperature coefficient of frequency (TCF) of 121 and 133 ppm/K for the cantilevers of 350 ìm and 400 ìm length respectively. Young’s modulus of the cantilevers increased by about 3.1% as the temperature was reduced from 300 K to 138 K. This is the first such measurement for UNCD and suggests that the nanostructure plays a significant role in modifying the thermo-mechanical response of the material. The quality factor of these resonators showed a moderate increase as the cantilevers were cooled from 300 K to 138 K. The results suggest that surface and bulk defects significantly contribute to the observed dissipation in UNCD resonators

Ultrahigh Vacuum Packaging and Surface Cleaning for Quantum Devices

We describe design, implementation and performance of an ultra-high vacuum (UHV) package for superconducting qubit chips or other surface sensitive quantum devices. The UHV loading procedure allows for annealing, ultra-violet light irradiation, ion milling and surface passivation of quantum devices before sealing them into a measurement package. The package retains vacuum during the transfer to cryogenic temperatures by active pumping with a titanium getter layer. We characterize the treatment capabilities of the system and present measurements of flux tunable qubits with an average T$_1=84~\mu$s and T$^{echo}_2=134~\mu$s after vacuum-loading these samples into a bottom loading dilution refrigerator in the UHV-package.Comment: 5 pages, 6 figure

Mechanical stiffness and dissipation in ultrananocrystalline diamond microresonators

We have characterized mechanical properties of ultrananocrystalline diamond UNCD thin films grown using the hot filament chemical vapor deposition HFCVD technique at 680 °C, significantly lower than the conventional growth temperature of 800 °C. The films have 4.3% sp2 content in the near-surface region as revealed by near edge x-ray absorption fine structure spectroscopy. The films, 1 m thick, exhibit a net residual compressive stress of 3701 MPa averaged over the entire 150 mm wafer. UNCD microcantilever resonator structures and overhanging ledges were fabricated using lithography, dry etching, and wet release techniques. Overhanging ledges of the films released from the substrate exhibited periodic undulations due to stress relaxation. This was used to determine a biaxial modulus of 8382 GPa. Resonant excitation and ring-down measurements in the kHz frequency range of the microcantilevers were conducted under ultrahigh vacuum UHV conditions in a customized UHV atomic force microscope system to determine Young’s modulus as well as mechanical dissipation of cantilever structures at room temperature. Young’s modulus is found to be 79030 GPa. Based on these measurements, Poisson’s ratio is estimated to be 0.0570.038. The quality factors Q of these resonators ranged from 5000 to 16000. These Q values are lower than theoretically expected from the intrinsic properties of diamond. The results indicate that surface and bulk defects are the main contributors to the observed dissipation in UNCD resonators

Are diamonds a MEMS\u27 best friend?

Next-generation military and civilian communication systems will require technologies capable of handling data/ audio, and video simultaneously while supporting multiple RF systems operating in several different frequency bands from the MHz to the GHz range [1]. RF microelectromechanical/nanoelectromechanical (MEMS/NEMS) devices, such as resonators and switches, are attractive to industry as they offer a means by which performance can be greatly improved for wireless applications while at the same time potentially reducing overall size and weight as well as manufacturing costs

Simultaneous electrical and optical readout of graphene-coated high Q silicon nitride resonators

Resonant mechanics of high quality factor (Q) graphene coated silicon nitride devices have been explored using optical and electrical transduction schemes. With the addition of the graphene layer, we retain the desirable mechanical properties of silicon nitride but utilize the electrical and optical properties of graphene to transduce and tune the resonant motion by both optical and electrical means. By positioning the graphene-on-silicon-nitride drums in a tunable optical cavity, we observe position dependent damping and resonant frequency control of the devices due to optical absorption by graphene

Effect of growth regulators and micronutrients on quality parameters in cashew (Anacardium occidentale L.)

Cashew (Anacardium occidentale L.) is an important tropical nut crop of social and economic importance worldwide. However, the crop is threatened with the low yield. In the present study, an attempt was made to test the effects of plant growth hormones as well as micronutrients on nut and apple quality of cashew var. Bhaskara. Significant differences in kernel weight, shelling percentage, carbohydrates and starch content of cashew kernel and juice content of cashew apple were observed with the foliar application of growth hormones and micronutrients. The foliar application of ethrel @ 50 ppm increased shelling percentage (35.8%), carbohydrate content (21.63%), sugar content (6.26%), protein content (32.4%), starch content (31.42%), juice content (78.3%) and total soluble solids (120 Brix). Further, the foliar spray of zinc sulphate (0.5%) + borax (0.1%) increased shelling (36.13%), protein content (32.15%), starch content (32.03%) among all the treatments tested. Furthermore, higher cashew apple juice content (78%) and total soluble solids (120Brix) was also recorded with the foliar spray of zinc sulphate (0.5%) + borax (0.1%)