Oxide Film Destruction on Al-Mg Alloys in HCl Solutions

Open circuit potential technique is used to follow the oxide film destruction of three of Al-Mg alloys in HCl solutions of varying concentrations.  Dissolution of the passive film on pare metal surface takes place in two distinct steps indicating that the film is composed mainly of a barrier layer of Al2O3 adjacent to the metal surface and an outer porous modification on the top of the first one. The rates of oxide film destruction and/or dissolution (δ1¯ and δ2¯) follow a direct logarithmic law. The extent of oxide film destruction and metal dissolution were found to increase with increasing the acid concentration and the percent of Mg content in the alloy sample

Bioflocculation of Basic Dye onto Isolated Microbial Biopolymers

Three purified biopolymers isolated from Bacillus velezensis (40B), Bacillus mojavensis (32A) and Pseudomonas (38A) strains were evaluated for dye decolourization as bioflocculants. The decolourization capacity of the three polymers was inspected using C.I 28 basic yellow dye as hazardous pollutant. The chemical compositions of these purified biopolymers were considered by HPLC and FTIR spectrum. The decolourization efficiency of the three purified biopolymers was determined using both real dye polluted wastewater (discharged from AKSA EGYPT acrylic fibres industry) and simulated synthetic wastewater. The maximum decolourization efficiencies of the purified biopolymers of the three studied strains (40B), (32A) and (38A) were 91, 89 and 88 %, respectively. The equilibrium of dye sorption process onto biopolymers was described using Langmuir isotherm equation. However, its kinetics follows the pseudo second order model. The thermodynamic examination investigated the exothermic and spontaneous nature of the decolourization process using the purified biopolymers. This work is licensed under a Creative Commons Attribution 4.0 International License

GIZA 11 AND GIZA 12; TWO NEW FLAX DUAL PURPOSE TYPE VARIETIES

Sixteen flax genotypes {13 promising lines and 3 check varieties viz., Giza 8 (oil type), Sakha 1 (dual purpose type) and Sakha 3 (fiber type)} were evaluated for straw, seed, oil yields and their related traits under twelve different environments; four locations (Sakha, Etay El-Baroud, Ismailia and Giza Exp. Stations through three successive seasons (2011/12, 2012/13 and 2013/14). These materials were evaluated in a randomized complete blocks design with three replications at the twelve above-mentioned environments. The analysis of variance revealed highly significant differences among genotypes (G), environments (E) and G x E interaction for all studied traits except straw weight per plant, indicating a wide range of variation among genotypes, environments and these genotypes exhibited differential response to environmental conditions. The significant variance due to residual for all characters except both straw weight per plant and oil yield per fad indicated that genotypes differed with respect to their stability suggesting that prediction would be difficult, which means that mean performance alone would not be appropriate. Interaction component of variance (σ2ge) was less than the genotypic variance (σ2g) for all characters, indicating that genotypes differ in their genetic potential for these traits. This was reflected in high heritability and low discrepancy between phenotypic (PCV) and genotypic (GCV) coefficients of variability values for these traits indicating the possibility of using each of long fiber percentage, plant height and technical stem length as selection indices for improving straw weight per plant, as well as, using 1000-seed weight and capsules number per plant as selection indices for improving seed weight per plant. Yield stability (YSi) statistic indicated that S.541-C/3 and S.541-D/10 gave high mean performance and stability for straw, fiber, seed and oil yields per fad in addition to oil percentage, capsules number per plant and 1000-seed weight. Therefore, the two genotypes well be released under the name Giza 11 and Giza 12, respectively. These newly released varieties are of dual purpose type for straw, fiber, seed and oil yield. They may replace the low yielding cultivars Giza 8, Sakha 1 and Sakha 3

Aminoglycoside Resistance Rates, Phenotypes, and Mechanisms of Gram-Negative Bacteria from Infected Patients in Upper Egypt

With the re-emergence of older antibiotics as valuable choices for treatment of serious infections, we studied the aminoglycoside resistance of Gram-negative bacteria isolated from patients with ear, urinary tract, skin, and gastrointestinal tract infections at Minia university hospital in Egypt. Escherichia coli (mainly from urinary tract and gastrointestinal tract infections) was the most prevalent isolate (28.57%), followed by Pseudomonas aeruginosa (25.7%) (mainly from ear discharge and skin infections). Isolates exhibited maximal resistance against streptomycin (83.4%), and minimal resistance against amikacin (17.7%) and intermediate degrees of resistance against neomycin, kanamycin, gentamicin, and tobramycin. Resistance to older aminoglycosides was higher than newer aminoglycoides. The most common aminoglycoside resistance phenotype was that of streptomycin resistance, present as a single phenotype or in combination, followed by kanamycin-neomycin as determined by interpretative reading. The resistant Pseudomonas aeruginosa strains were capable of producing aminoglycoside-modifying enzymes and using efflux as mechanisms of resistance. Using checkerboard titration method, the most frequently-observed outcome in combinations of aminoglycosides with β-lactams or quinolones was synergism. The most effective combination was amikacin with ciprofloxacin (100% Synergism), whereas the least effective combination was gentamicin with amoxicillin (53.3% Synergistic, 26.7% additive, and 20% indifferent FIC indices). Whereas the studied combinations were additive and indifferent against few of the tested strains, antagonism was never observed. The high resistance rates to aminoglycosides exhibited by Gram-negative bacteria in this study could be attributed to the selective pressure of aminoglycoside usage which could be controlled by successful implementation of infection control measures

[3H]Adenine is a suitable radioligand for the labeling of G protein-coupled adenine receptors but shows high affinity to bacterial contaminations in buffer solutions

[3H]Adenine has previously been used to label the newly discovered G protein-coupled murine adenine receptors. Recent reports have questioned the suitability of [3H]adenine for adenine receptor binding studies because of curious results, e.g. high specific binding even in the absence of mammalian protein. In this study, we showed that specific [3H]adenine binding to various mammalian membrane preparations increased linearly with protein concentration. Furthermore, we found that Tris-buffer solutions typically used for radioligand binding studies (50 mM, pH 7.4) that have not been freshly prepared but stored at 4°C for some time may contain bacterial contaminations that exhibit high affinity binding for [3H]adenine. Specific binding is abolished by heating the contaminated buffer or filtering it through 0.2-μm filters. Three different, aerobic, gram-negative bacteria were isolated from a contaminated buffer solution and identified as Achromobacter xylosoxidans, A. denitrificans, and Acinetobacter lwoffii. A. xylosoxidans, a common bacterium that can cause nosocomial infections, showed a particularly high affinity for [3H]adenine in the low nanomolar range. Structure–activity relationships revealed that hypoxanthine also bound with high affinity to A. xylosoxidans, whereas other nucleobases (uracil, xanthine) and nucleosides (adenosine, uridine) did not. The nature of the labeled site in bacteria is not known, but preliminary results indicate that it may be a high-affinity purine transporter. We conclude that [3H]adenine is a well-suitable radioligand for adenine receptor binding studies but that bacterial contamination of the employed buffer solutions must be avoided

Physico-chemical studies of some aminobenzoic acid hydrazide complexes

The stability constants and related thermodynamic functions characterizing the formation of divalent Ni, Cu, Zn, Cd and Hg complexes with o- and p-aminobenzoic acid hydrazide were determined potentiometrically at different temperatures. The formations of the complexes are endothermic processes. The formed bonds are mainly electrostatic. Conductometric titration was carried out to determine the stoichiometry and stability of the formed complexes. The structures of complexes were characterized by their IR, 1H-NMR and 13C-NMR spectra, as well as X-ray diffractograms. The coordination process takes place through the carbonyl group and the terminal hydrazinic amino group. The thermal stability of the complexes was followed in the temperature range 20600ºC