Cladding of Mg alloy with Zr based BMG Alloy

In the present work, an attempt has been made to clad AZ31 magnesium alloy with Zr-based bulk metallic glassy alloy (Vit-1), by casting method. The interface studies conducted using SEM-EDS line scan indicate that a good bond is formed at the clad interface of Zr and Mg. And the mechanism involved is discussed herein.110Ysciescopu

Al-TiH2 Composite Foams Magnesium Alloy

The work presented here in describes the synthesis of aluminum based titanium-hydride particulate composite by casting method and its foaming behavior of magnesium alloy. Results obtained indicate that the Al-10TiH(2) composite can be synthesized successfully by casting method. Further, results also reveal that closed-cell magnesium alloy foam can be synthesized by using Al-10TiH(2) composite as a foaming agent.111Ysciescopu

Al-Ti-C-Sr master alloy-A melt inoculant for simultaneous grain refinement and modification of hypoeutectic Al-Si alloys

Present article is focused on the microstructural features of Al-Ti-C-Sr master alloy, an inoculant for simultaneous grain refinement and modification of hypoeutectic Al-Si alloys. This master alloy is basically a metal matrix composite consisting of TiC and Al(4)Sr phases formed in situ in the Al-matrix. TiC particles initiate the refinement of primary alpha-Al through heterogeneous nucleation in molten hypoeutectic Al-Si alloy, while Al(4)Sr phase dissolves in molten Al-7Si alloy enriching the melt with Sr, which eventually leads to modification of eutectic silicon during solidification of the Al-7Si alloy casting. Thus present master alloy serves in both ways, as a grain refiner and a modifier for hypoeutectic Al-Si alloys. (C) 2009 Elsevier B.V. All rights reserved.

Development of a mathematical model to study the feasibility of creating a clad AZ31 magnesium sheet via twin roll casting

A previously developed and validated thermalfluid mathematical model of the twin roll casting (TRC) process for magnesium alloy AZ31 was used to quantitatively study the feasibility of producing a clad magnesium strip via the TRC process. The clad material was varied to identify the effect of material composition on the feasibility of producing a clad strip. The clad alloys chosen included pure Zn, pure Al, AA3003, and AA5182 aluminum alloys. In the analysis, the effect of casting speed and clad sheet thickness (100 and 500 μm) on the thermal history in the magnesium strip and clad layer was analyzed. Assessment of the process feasibility was determined based on the exit temperature of the clad strip at the centerline, temperature of the clad sheet prior to the roll bite entry, and fraction solid of both the core (magnesium sheet) and clad along the core/clad interface. The results indicated that using pure Zn as a clad material is not feasible due to premelting of the clad strip prior to introduction into the TRC apparatus. All three aluminum alloys studied proved to be feasible in terms of a cladmaterial, and it was found that the effect of clad thickness and clad material chemical composition on the thermal history (temperature distribution) of the clad strip was negligible. It was also predicted using the thermodynamics package FactSageTM that the intermetallic phase at the core/clad interface will be primarily α-Mg (Mg17Al12). For AA5182 clad material, formation of β-Mg (Al3Mg2) is also possible. © Springer-Verlag London 2014