Measurement of Creep Deformation across Welds in 316H Stainless Steel Using Digital Image Correlation

Spatially resolved measurement of creep deformation across weldments at high temperature cannot be achieved using standard extensometry approaches. In this investigation, a Digital Image Correlation (DIC) based system has been developed for long-term high-temperature creep strain measurement in order to characterise the material deformation behaviour of separate regions of a multi-pass weld. The optical system was sufficiently stable to allow a sequence of photographs to be taken suitable for DIC analysis of creep specimens tested at a temperature of 545 °C for over 2000 h. The images were analysed to produce local creep deformation curves from two cross-weld samples cut from contrasting regions of a multi-pass V-groove weld joining thick-section AISI Type 316H austenitic stainless steel. It is shown that for this weld, the root pass is the weakest region of the structure in creep, most likely due to the large number of thermal cycles it has experienced during the fabrication process. The DIC based measurement method offers improved spatial resolution over conventional methods and greatly reduces the amount of material required for creep characterisation of weldments

Residual stress measurement round robin on an electron beam welded joint between austenitic stainless steel 316L(N) and ferritic steel P91

This paper is a research output of DMW-Creep project which is part of a national UK programme through the RCUK Energy programme and India's Department of Atomic Energy. The research is focussed on understanding the characteristics of welded joints between austenitic stainless steel and ferritic steel that are widely used in many nuclear power generating plants and petrochemical industries as well as conventional coal and gas-fired power systems. The members of the DMW-Creep project have under- taken parallel round robin activities measuring the residual stresses generated by a dissimilar metal weld (DMW) between AISI 316L(N) austenitic stainless steel and P91 ferritic-martensitic steel. Electron beam (EB) welding was employed to produce a single bead weld on a plate specimen and an additional smoothing pass (known cosmetic pass) was then introduced using a defocused beam. The welding re- sidual stresses have been measured by five experimental methods including (I) neutron diffraction (ND), (II) X-Ray diffraction (XRD), (III) contour method (CM), (IV) incremental deep hole drilling (iDHD) and (V) incremental centre hole drilling (iCHD). The round robin measurements of weld residual stresses are compared in order to characterise surface and sub-surface residual stresses comprehensively

Impact of Chlamydia trachomatis in the reproductive setting: British Fertility Society Guidelines for practice

Chlamydia trachomatis infection of the genital tract is the most common sexually transmitted infection and has a world-wide distribution. The consequences of infection have an adverse effect on the reproductive health of women and are a common cause of infertility. Recent evidence also suggests an adverse effect on male reproduction. There is a need to standardise the approach in managing the impact of C. trachomatis infection on reproductive health. We have surveyed current UK practice towards screening and management of Chlamydia infections in the fertility setting. We found that at least 90% of clinicians surveyed offered screening. The literature on this topic was examined and revealed a paucity of solid evidence for estimating the risks of long-term reproductive sequelae following lower genital tract infection with C. trachomatis. The mechanism for the damage that occurs after Chlamydial infections is uncertain. However, instrumentation of the uterus in women with C. trachomatis infection is associated with a high risk of pelvic inflammatory disease, which can be prevented by appropriate antibiotic treatment and may prevent infected women from being at increased risk of the adverse sequelae, such as ectopic pregnancy and tubal factor infertility. Recommendations for practice have been proposed and the need for further studies is identified