Energy-efficient wireless communication

In this chapter we present an energy-efficient highly adaptive network interface architecture and a novel data link layer protocol for wireless networks that provides Quality of Service (QoS) support for diverse traffic types. Due to the dynamic nature of wireless networks, adaptations in bandwidth scheduling and error control are necessary to achieve energy efficiency and an acceptable quality of service. In our approach we apply adaptability through all layers of the protocol stack, and provide feedback to the applications. In this way the applications can adapt the data streams, and the network protocols can adapt the communication parameters

Joint Uplink and Downlink Coverage Analysis of Cellular-based RF-powered IoT Network

Ambient radio frequency (RF) energy harvesting has emerged as a promising solution for powering small devices and sensors in massive Internet of Things (IoT) ecosystem due to its ubiquity and cost efficiency. In this paper, we study joint uplink and downlink coverage of cellular-based ambient RF energy harvesting IoT where the cellular network is assumed to be the only source of RF energy. We consider a time division-based approach for power and information transmission where each time-slot is partitioned into three sub-slots: (i) charging sub-slot during which the cellular base stations (BSs) act as RF chargers for the IoT devices, which then use the energy harvested in this sub-slot for information transmission and/or reception during the remaining two sub-slots, (ii) downlink sub-slot during which the IoT device receives information from the associated BS, and (iii) uplink sub-slot during which the IoT device transmits information to the associated BS. For this setup, we characterize the joint coverage probability, which is the joint probability of the events that the typical device harvests sufficient energy in the given time slot and is under both uplink and downlink signal-to-interference-plus-noise ratio (SINR) coverage with respect to its associated BS. This metric significantly generalizes the prior art on energy harvesting communications, which usually focused on downlink or uplink coverage separately. The key technical challenge is in handling the correlation between the amount of energy harvested in the charging sub-slot and the information signal quality (SINR) in the downlink and uplink sub-slots. Dominant BS-based approach is developed to derive tight approximation for this joint coverage probability. Several system design insights including comparison with regularly powered IoT network and throughput-optimal slot partitioning are also provided

Feasibility Study of Enabling V2X Communications by LTE-Uu Radio Interface

Compared with the legacy wireless networks, the next generation of wireless network targets at different services with divergent QoS requirements, ranging from bandwidth consuming video service to moderate and low date rate machine type services, and supporting as well as strict latency requirements. One emerging new service is to exploit wireless network to improve the efficiency of vehicular traffic and public safety. However, the stringent packet end-to-end (E2E) latency and ultra-low transmission failure rates pose challenging requirements on the legacy networks. In other words, the next generation wireless network needs to support ultra-reliable low latency communications (URLLC) involving new key performance indicators (KPIs) rather than the conventional metric, such as cell throughput in the legacy systems. In this paper, a feasibility study on applying today's LTE network infrastructure and LTE-Uu air interface to provide the URLLC type of services is performed, where the communication takes place between two traffic participants (e.g., vehicle-to-vehicle and vehicle-to-pedestrian). To carry out this study, an evaluation methodology of the cellular vehicle-to-anything (V2X) communication is proposed, where packet E2E latency and successful transmission rate are considered as the key performance indicators (KPIs). Then, we describe the simulation assumptions for the evaluation. Based on them, simulation results are depicted that demonstrate the performance of the LTE network in fulfilling new URLLC requirements. Moreover, sensitivity analysis is also conducted regarding how to further improve system performance, in order to enable new emerging URLLC services.Comment: Accepted by IEEE/CIC ICCC 201

E2MaC: an energy efficient MAC protocol for multimedia traffic

Energy efficiency is an important issue for mobile computers since they must rely on their batteries. We present a novel MAC protocol that achieves a good energy efficiency of wireless interface of the mobile and provides support for diverse traffic types and QoS. The scheduler of the base station is responsible to provide the required QoS to connections on the wireless link and to minimise the amount of energy spend by the mobile. The main principles of the E2MaC protocol are to avoid unsuccessful actions, minimise the number of transitions, and synchronise the mobile and the base-station. We will show that considerable amounts of energy can be saved using these principles. In the protocol the actions of the mobile are minimised. The base-station with plenty of energy performs actions in courtesy of the mobile. We have paid much attention in reducing the cost of a mobile for just being connected. The protocol is able to provide near-optimal energy efficiency (i.e. energy is only spent for the actual transfer) for a mobile within the constraints of the QoS of all connections in a cell, and only requires a small overhead