2 research outputs found

    Smart sticker including split square rings for adapting mobile phone radiation pattern to lower SAR

    Get PDF
    A Split Square Rings (SSR) based on a sticker is presented to modify the direction of mobile phone radiation pattern. This smart sticker permits the radiation from the antenna of a phone to steer away from the user head. The presented smart sticker is designed for 5 GHz WiFi band (IEEE 802.11ac) for VOIP (Voice Over Internet Protocol) and data applications. It is observed that the smart sticker reduces the peak SAR (Specific Absorption Rate) value averaged over 10g of human head tissues from 2.11 W/kg to a safety value of 1.46 W/kg (a reduction of over 30%)

    Diseño de una antena dipolo de 6 GHz en la banda 5G para la medición del SAR

    Get PDF
    En este artículo se presenta el diseño y análisis del SAR de una antena dipolo en ANSYS HFSS. La antena dipolo propuesta opera a una frecuencia de 6 GHz. Esta antena está diseñada con una fuente, una impedancia característica de 73 ohm que está conectada a dos conductores los cuales serán de tres materiales cobre, acero inoxidable y aluminio. El VSWR de la antena dipolo es de 1.2571 siendo este el valor con el cual la antena trabajará para la simulación. Una vez realizado el diseño de la antena dipolo se realizó la medición de la Tasa de Absorción Específica (SAR), mediante los valores de la Comisión Internacional de Protección contra la Radiación No Ionizante (ICNIRP) correspondiente a 10g, teniendo como valor máximo del SAR de 0.46 [W/kg], así como la Comisión Federal de Comunicaciones (FCC) correspondiente a 1g, teniendo como valor máximo del SAR de 0.53 [W/kg], para equipos de comunicación. Obteniendo en esta investigación los valores máximos del SAR de 0.00022, 0.000124 y 0.00022 [W/kg] para 1g y 0.000134, 0.000035 y 0.000132 [W/kg] para 10g, demostrando que los materiales utilizados no provocan excesiva radiación al tejido humano, estando dentro de los valores del SAR avalados por la OMS.This article presents the design and SAR analysis of a dipole antenna in ANSYS HFSS. The proposed dipole antenna operates at a frequency of 6 GHz. This antenna is designed with a source, a characteristic impedance of 73 ohms that is connected to two conductors which will be made of three materials: copper, stainless steel and aluminum. The VSWR of the dipole antenna is 1.2571, this being the value with which the antenna will work for the simulation. Once the design of the dipole antenna was carried out, the measurement of the Specific Absorption Rate (SAR) was carried out, using the values of the International Commission on Protection against Non-Ionizing Radiation (ICNIRP) corresponding to 10g, having the maximum value of SAR. of 0.46 [W/kg], as well as the Federal Communications Commission (FCC) corresponding to 1g, with a maximum SAR value of 0.53 [W/kg], for communication equipment. Obtaining in this investigation the maximum SAR values of 0.00022, 0.000124 and 0.00022 [W/kg] for 1g and 0.000134, 0.000035 and 0.000132 [W/kg] for 10g, demonstrating that the materials used do not cause excessive radiation to human tissue, being within the SAR values endorsed by the OMS
    corecore