Weight simulator

Device applies compressive force to bone to minimize loss of bone calcium during weightlessness or bedrest. Force is applied through weights, or hydraulic, pneumatic or electrically actuated devices. Device is lightweight and easy to maintain and operate

On the design of a reliability circuit simulator

This paper describes the outcome of a study into the feasibility of a reliability circuit simulator for ICs in general and the critical parameters involved in particular. The necessary conditions are formulated that have to be fulfilled before any construction of the reliability simulator is meaningful or can be done at all. It has been found that failure mechanisms in the wear-out regime meet these conditions. Next, a general approach is given to make a simulator. This approach is actually derived from circuit simulator activities on hot carrier degradation and electromigration, respectively. Finally, the different groups of parameters are defined

Waveform simulator Patent

Sign wave generation simulator for variable amplitude, frequency, damping, and phase pulses for oscilloscope displa

Control Strategy of Hardware-in-the-Loop Simulator EPOS 2.0 for Autonomous Docking Verification

This paper briefly describes the hybrid simulator system called European Proximity Operation Simulator (EPOS 2.0) and the development of the hardware-in-the-loop (HIL) docking simulation concept. A critical requirement for the docking simulation of this HIL simulator is that the 6-DOF robots in the loop have to exactly mimic the dynamic response of the two satellites during a contact operation. The main challenges to meet this requirement are in the stiffness of the robots, which is unlike that of the satellites, as well as the time delay in the HIL simulator. The paper mainly presents the impedance parameter identification concept for matching the impedance between the satellites impact model and the EPOS robots. In addition it presents the contact dynamics model used, and the control strategies to meet the requirements of the docking simulator. Finally it presents the preliminary results and future work

Impact simulator Patent

Lunar and planetary gravity simulator to test vehicular response to landin

Separation simulator Patent

Electrical circuit selection device for simulating stage separation of flight vehicl

Novel Floating General Element Simulators Using CBTA

In this study, a novel floating frequency dependent negative resistor (FDNR), floating inductor, floating capacitor and floating resistor simulator circuit employing two CBTAs and three passive components is proposed. The presented circuit can realize floating FDNR, inductor, capacitor or resistor depending on the passive component selection. Since the passive elements are all grounded, this circuit is suitable for fully integrated circuit design. The circuit does not require any component matching conditions, and it has a good sensitivity performance with respect to tracking errors. Moreover, the proposed FDNR, inductance, capacitor and resistor simulator can be tuned electronically by changing the biasing current of the CBTA or can be controlled through the grounded resistor or capacitor. The high-order frequency dependent element simulator circuit is also presented. Depending on the passive component selection, it realizes high-order floating circuit defining as V(s) = snAI(s) or V(s) = s-nBI(s). The proposed floating FDNR simulator circuit and floating high-order frequency dependent element simulator circuit are demonstrated by using PSPICE simulation for 0.25 μm, level 7, TSMC CMOS technology parameters