Reference Receiver Based Digital Self-Interference Cancellation in MIMO Full-Duplex Transceivers

In this paper we propose and analyze a novel self-interference cancellation structure for in-band MIMO full-duplex transceivers. The proposed structure utilizes reference receiver chains to obtain reference signals for digital self-interference cancellation, which means that all the transmitter-induced nonidealities will be included in the digital cancellation signal. To the best of our knowledge, this type of a structure has not been discussed before in the context of full-duplex transceivers. First, we will analyze the overall achievable performance of the proposed cancellation scheme, while also providing some insight into the possible bottlenecks. We also provide a detailed formulation of the actual cancellation procedure, and perform an analysis into the effect of the received signal of interest on self-interference coupling channel estimation. The achieved performance of the proposed reference receiver based digital cancellation procedure is then assessed and verified with full waveform simulations. The analysis and waveform simulation results show that under practical transmitter RF/analog impairment levels, the proposed reference receiver based cancellation architecture can provide substantially better self-interference suppression than any existing solution, despite deploying only low-complexity linear digital processing.Comment: 7 pages, 4 figures. To be presented in the 2014 IEEE Broadband Wireless Access Worksho

Self-interference cancellation for full-duplex MIMO transceivers

PhD ThesisIn recent years, there has been enormous interest in utilizing the full-duplex (FD) technique with multiple-input multiple-output (MIMO) systems to complement the evolution of fifth generation technologies. Transmission and reception using FD-MIMO occur simultaneously over the same frequency band and multiple antennas are employed in both sides. The motivation for employing FD-MIMO is the rapidly increasing demand on frequency resources, and also FD has the ability to improve spectral efficiency and channel capacity by a factor of two compared to the conventional half-duplex technique. Additionally, MIMO can enhance the diversity gain and enable FD to acquire further degrees of freedom in mitigating the self-interference (SI). The latter is one of the key challenges degrading the performance of systems operating in FD mode due to local transmission which involves larger power level than the signals of interest coming from distance sources that are significantly more attenuated due to path loss propagation phenomena. Various approaches can be used for self-interference cancellation (SIC) to tackle SI by combining passive suppression with the analogue and digital cancellation techniques. Moreover, active SIC techniques using special domain suppression based on zero-forcing and null-space projection (NSP) can be exploited for this purpose too. The main contributions of this thesis can be summarized as follows. Maximum-ratio combining with NSP are jointly exploited in order to increase the signal-to-noise ratio (SNR) of the desired path and mitigate the undesired loop path, respectively, for an equalize-and-forward (EF) relay using FD-MIMO. Additionally, an end-to-end performance analysis of the proposed system is obtained in the presence of imperfect channel state information by formulating mathematically the exact closed-form solutions for the signal-to-interference-plus-noise ratio (SINR) distribution, outage probability, and average symbol-error rate for uncoded M-ary phase-shift keying over Rayleigh fading channels and in the presence of additive white Gaussian noise (AWGN). The coefficients of the EF-relay are designed to attain the minimum mean-square error (MMSE) between the transmission symbols. Comparison of the results obtained with relevant state-of-the-art techniques suggests significant improvements in the SINR figures and system capacity. Furthermore, iterative detection and decoding (IDD) are proposed to mitigate the residual self-interference (SI) remaining after applying passive suppression along with two stages of SI cancellation (SIC) filters in the analogue and digital domains for coded FD bi-directional transceiver based multiple antennas. IDD comprises an adaptive MMSE filter with log-likelihood ratio demapping, while the soft-in soft-out decoder utilizes the maximum a posteriori (MAP) algorithm. The proposed system’s performance is evaluated in the presence of AWGN over non-selective (flat) Rayleigh fading single-input multiple-output (SIMO) and MIMO channels. However, the results of the analyses can be applied to multi-path channels if orthogonal frequency division multiplexing is utilised with a proper length of cyclic prefix in order to tackle the channels’ frequency-selectivity and delay spread. Simulation results are presented to demonstrate the bit-error rate (BER) performance as a function of the SNR, revealing a close match to the SI-free case for the proposed system. Furthermore, the results are validated by deriving a tight upper bound on the performance of rate-1=2 convolutional codes for FD-SIMO and FD-MIMO systems for different modulation schemes under the same conditions, which asymptotically exhibits close agreement with the simulated BER performance.Ministry of Higher Education and Scientific Research (MoHESR), and the University of Mosul and to the Iraqi Cultural Attache in London for providing financial support for my PhD scholarship

Joint Design of Multi-Tap Analog Cancellation and Digital Beamforming for Reduced Complexity Full Duplex MIMO Systems

Incorporating full duplex operation in Multiple Input Multiple Output (MIMO) systems provides the potential of boosting throughput performance. However, the hardware complexity of the analog self-interference canceller scales with the number of transmit and receive antennas, thus exploiting the benefits of analog cancellation becomes impractical for full duplex MIMO transceivers. In this paper, we present a novel architecture for the analog canceller comprising of reduced number of taps (tap refers to a line of fixed delay and variable phase shifter and attenuator) and simple multiplexers for efficient signal routing among the transmit and receive radio frequency chains. In contrast to the available analog cancellation architectures, the values for each tap and the configuration of the multiplexers are jointly designed with the digital beamforming filters according to certain performance objectives. Focusing on a narrowband flat fading channel model as an example, we present a general optimization framework for the joint design of analog cancellation and digital beamforming. We also detail a particular optimization objective together with its derived solution for the latter architectural components. Representative computer simulation results demonstrate the superiority of the proposed low complexity full duplex MIMO system over lately available ones.Comment: 8 pages, 4 figures, IEEE ICC 201

Modeling and Efficient Cancellation of Nonlinear Self-Interference in MIMO Full-Duplex Transceivers

This paper addresses the modeling and digital cancellation of self-interference in in-band full-duplex (FD) transceivers with multiple transmit and receive antennas. The self-interference modeling and the proposed nonlinear spatio-temporal digital canceller structure takes into account, by design, the effects of I/Q modulator imbalances and power amplifier (PA) nonlinearities with memory, in addition to the multipath self-interference propagation channels and the analog RF cancellation stage. The proposed solution is the first cancellation technique in the literature which can handle such a self-interference scenario. It is shown by comprehensive simulations with realistic RF component parameters and with two different PA models to clearly outperform the current state-of-the-art digital self-interference cancellers, and to clearly extend the usable transmit power range.Comment: 7 pages, 5 figures. To be presented in the 2014 International Workshop on Emerging Technologies for 5G Wireless Cellular Network

Feasibility of In-band Full-Duplex Radio Transceivers with Imperfect RF Components: Analysis and Enhanced Cancellation Algorithms

In this paper we provide an overview regarding the feasibility of in-band full-duplex transceivers under imperfect RF components. We utilize results and findings from the recent research on full-duplex communications, while introducing also transmitter-induced thermal noise into the analysis. This means that the model of the RF impairments used in this paper is the most comprehensive thus far. By assuming realistic parameter values for the different transceiver components, it is shown that IQ imaging and transmitter-induced nonlinearities are the most significant sources of distortion in in-band full-duplex transceivers, in addition to linear self-interference. Motivated by this, we propose a novel augmented nonlinear digital self-interference canceller that is able to model and hence suppress all the essential transmitter imperfections jointly. This is also verified and demonstrated by extensive waveform simulations.Comment: 7 pages, presented in the CROWNCOM 2014 conferenc