Coordinated Multicasting with Opportunistic User Selection in Multicell Wireless Systems

Physical layer multicasting with opportunistic user selection (OUS) is examined for multicell multi-antenna wireless systems. By adopting a two-layer encoding scheme, a rate-adaptive channel code is applied in each fading block to enable successful decoding by a chosen subset of users (which varies over different blocks) and an application layer erasure code is employed across multiple blocks to ensure that every user is able to recover the message after decoding successfully in a sufficient number of blocks. The transmit signal and code-rate in each block determine opportunistically the subset of users that are able to successfully decode and can be chosen to maximize the long-term multicast efficiency. The employment of OUS not only helps avoid rate-limitations caused by the user with the worst channel, but also helps coordinate interference among different cells and multicast groups. In this work, efficient algorithms are proposed for the design of the transmit covariance matrices, the physical layer code-rates, and the target user subsets in each block. In the single group scenario, the system parameters are determined by maximizing the group-rate, defined as the physical layer code-rate times the fraction of users that can successfully decode in each block. In the multi-group scenario, the system parameters are determined by considering a group-rate balancing optimization problem, which is solved by a successive convex approximation (SCA) approach. To further reduce the feedback overhead, we also consider the case where only part of the users feed back their channel vectors in each block and propose a design based on the balancing of the expected group-rates. In addition to SCA, a sample average approximation technique is also introduced to handle the probabilistic terms arising in this problem. The effectiveness of the proposed schemes is demonstrated by computer simulations.Comment: Accepted by IEEE Transactions on Signal Processin

Energy-Efficient Coordinated Multi-Cell Multigroup Multicast Beamforming with Antenna Selection

This paper studies energy-efficient coordinated beamforming in multi-cell multi-user multigroup multicast multiple-input single-output systems. We aim at maximizing the network energy efficiency by taking into account the fact that some of the radio frequency chains can be switched off in order to save power. We consider the antenna specific maximum power constraints to avoid non-linear distortion in power amplifiers and user-specific quality of service (QoS) constraints to guarantee a certain QoS levels. We first introduce binary antenna selection variables and use the perspective formulation to model the relation between them and the beamformers. Subsequently, we propose a new formulation which reduces the feasible set of the continuous relaxation, resulting in better performance compared to the original perspective formulation based problem. However, the resulting optimization problem is a mixed-Boolean non-convex fractional program, which is difficult to solve. We follow the standard continuous relaxation of the binary antenna selection variables, and then reformulate the problem such that it is amendable to successive convex approximation. Thereby, solving the continuous relaxation mostly results in near-binary solution. To recover the binary variables from the continuous relaxation, we switch off all the antennas for which the continuous values are smaller than a small threshold. Numerical results illustrate the superior convergence result and significant achievable gains in terms of energy efficiency with the proposed algorithm.Comment: 6 pages, 5 figures, accepted to IEEE ICC 2017 - International Workshop on 5G RAN Desig

Coordinated Multicast Beamforming in Multicell Networks

We study physical layer multicasting in multicell networks where each base station, equipped with multiple antennas, transmits a common message using a single beamformer to multiple users in the same cell. We investigate two coordinated beamforming designs: the quality-of-service (QoS) beamforming and the max-min SINR (signal-to-interference-plus-noise ratio) beamforming. The goal of the QoS beamforming is to minimize the total power consumption while guaranteeing that received SINR at each user is above a predetermined threshold. We present a necessary condition for the optimization problem to be feasible. Then, based on the decomposition theory, we propose a novel decentralized algorithm to implement the coordinated beamforming with limited information sharing among different base stations. The algorithm is guaranteed to converge and in most cases it converges to the optimal solution. The max-min SINR (MMS) beamforming is to maximize the minimum received SINR among all users under per-base station power constraints. We show that the MMS problem and a weighted peak-power minimization (WPPM) problem are inverse problems. Based on this inversion relationship, we then propose an efficient algorithm to solve the MMS problem in an approximate manner. Simulation results demonstrate significant advantages of the proposed multicast beamforming algorithms over conventional multicasting schemes.Comment: 10pages, 9 figure

Spectrum Sharing in Wireless Networks via QoS-Aware Secondary Multicast Beamforming

Secondary spectrum usage has the potential to considerably increase spectrum utilization. In this paper, quality-of-service (QoS)-aware spectrum underlay of a secondary multicast network is considered. A multiantenna secondary access point (AP) is used for multicast (common information) transmission to a number of secondary single-antenna receivers. The idea is that beamforming can be used to steer power towards the secondary receivers while limiting sidelobes that cause interference to primary receivers. Various optimal formulations of beamforming are proposed, motivated by different ldquocohabitationrdquo scenarios, including robust designs that are applicable with inaccurate or limited channel state information at the secondary AP. These formulations are NP-hard computational problems; yet it is shown how convex approximation-based multicast beamforming tools (originally developed without regard to primary interference constraints) can be adapted to work in a spectrum underlay context. Extensive simulation results demonstrate the effectiveness of the proposed approaches and provide insights on the tradeoffs between different design criteria