Energy Efficiency in MIMO Underlay and Overlay Device-to-Device Communications and Cognitive Radio Systems

This paper addresses the problem of resource allocation for systems in which a primary and a secondary link share the available spectrum by an underlay or overlay approach. After observing that such a scenario models both cognitive radio and D2D communications, we formulate the problem as the maximization of the secondary energy efficiency subject to a minimum rate requirement for the primary user. This leads to challenging non-convex, fractional problems. In the underlay scenario, we obtain the global solution by means of a suitable reformulation. In the overlay scenario, two algorithms are proposed. The first one yields a resource allocation fulfilling the first-order optimality conditions of the resource allocation problem, by solving a sequence of easier fractional problems. The second one enjoys a weaker optimality claim, but an even lower computational complexity. Numerical results demonstrate the merits of the proposed algorithms both in terms of energy-efficient performance and complexity, also showing that the two proposed algorithms for the overlay scenario perform very similarly, despite the different complexity.Comment: to appear in IEEE Transactions on Signal Processin

Distributed power allocation for D2D communications underlaying/overlaying OFDMA cellular networks

The implementation of device-to-device (D2D) underlaying or overlaying pre-existing cellular networks has received much attention due to the potential of enhancing the total cell throughput, reducing power consumption and increasing the instantaneous data rate. In this paper we propose a distributed power allocation scheme for D2D OFDMA communications and, in particular, we consider the two operating modes amenable to a distributed implementation: dedicated and reuse modes. The proposed schemes address the problem of maximizing the users' sum rate subject to power constraints, which is known to be nonconvex and, as such, extremely difficult to be solved exactly. We propose here a fresh approach to this well-known problem, capitalizing on the fact that the power allocation problem can be modeled as a potential game. Exploiting the potential games property of converging under better response dynamics, we propose two fully distributed iterative algorithms, one for each operation mode considered, where each user updates sequentially and autonomously its power allocation. Numerical results, computed for several different user scenarios, show that the proposed methods, which converge to one of the local maxima of the objective function, exhibit performance close to the maximum achievable optimum and outperform other schemes presented in the literature

Channel assembling and resource allocation in multichannel spectrum sharing wireless networks

Submitted in fulfilment of the academic requirements for the degree of Doctor of Philosophy (Ph.D.) in Engineering, in the School of Electrical and Information Engineering, Faculty of Engineering and the Built Environment, at the University of the Witwatersrand, Johannesburg, South Africa, 2017The continuous evolution of wireless communications technologies has increasingly imposed a burden on the use of radio spectrum. Due to the proliferation of new wireless networks applications and services, the radio spectrum is getting saturated and becoming a limited resource. To a large extent, spectrum scarcity may be a result of deficient spectrum allocation and management policies, rather than of the physical shortage of radio frequencies. The conventional static spectrum allocation has been found to be ineffective, leading to overcrowding and inefficient use. Cognitive radio (CR) has therefore emerged as an enabling technology that facilitates dynamic spectrum access (DSA), with a great potential to address the issue of spectrum scarcity and inefficient use. However, provisioning of reliable and robust communication with seamless operation in cognitive radio networks (CRNs) is a challenging task. The underlying challenges include development of non-intrusive dynamic resource allocation (DRA) and optimization techniques. The main focus of this thesis is development of adaptive channel assembling (ChA) and DRA schemes, with the aim to maximize performance of secondary user (SU) nodes in CRNs, without degrading performance of primary user (PU) nodes in a primary network (PN). The key objectives are therefore four-fold. Firstly, to optimize ChA and DRA schemes in overlay CRNs. Secondly, to develop analytical models for quantifying performance of ChA schemes over fading channels in overlay CRNs. Thirdly, to extend the overlay ChA schemes into hybrid overlay and underlay architectures, subject to power control and interference mitigation; and finally, to extend the adaptive ChA and DRA schemes for multiuser multichannel access CRNs. Performance analysis and evaluation of the developed ChA and DRA is presented, mainly through extensive simulations and analytical models. Further, the cross validation has been performed between simulations and analytical results to confirm the accuracy and preciseness of the novel analytical models developed in this thesis. In general, the presented results demonstrate improved performance of SU nodes in terms of capacity, collision probability, outage probability and forced termination probability when employing the adaptive ChA and DRA in CRNs.CK201

Interference Management of Inband Underlay Device-toDevice Communication in 5G Cellular Networks

The explosive growth of data traffic demands, emanating from smart mobile devices and bandwidth-consuming applications on the cellular network poses the need to drastically modify the cellular network architecture. A challenge faced by the network operators is the inability of the finite spectral resources to support the growing data traffic. The Next Generation Network (NGN) is expected to meet defined requirements such as massively connecting billions of devices with heterogeneous applications and services through enhanced mobile broadband networks, which provides higher data rates with improved network reliability and availability, lower end-to-end latency and increased energy efficiency. Device-to-Device (D2D) communication is one of the several emerging technologies that has been proposed to support NGN in meeting these aforementioned requirements. D2D communication leverages the proximity of users to provide direct communication with or without traversing the base station. Hence, the integration of D2D communication into cellular networks provides potential gains in terms of throughput, energy efficiency, network capacity and spectrum efficiency. D2D communication underlaying a cellular network provides efficient utilisation of the scarce spectral resources, however, there is an introduction of interference emanating from the reuse of cellular channels by D2D pairs. Hence, this dissertation focuses on the technical challenge with regards to interference management in underlay D2D communication. In order to tackle this challenge to be able to exploit the potentials of D2D communication, there is the need to answer some important research questions concerning the problem. Thus, the study aims to find out how cellular channels can be efficiently allocated to D2D pairs for reuse as an underlay to cellular network, and how mode selection and power control approaches influence the degree of interference caused by D2D pairs to cellular users. Also, the research study continues to determine how the quality of D2D communication can be maintained with factors such as bad channel quality or increased distance. In addressing these research questions, resource management techniques of mode selection, power control, relay selection and channel allocation are applied to minimise the interference caused by D2D pairs when reusing cellular channels to guarantee the Quality of Service (QoS) of cellular users, while optimally improving the number of permitted D2D pairs to reuse channels. The concept of Open loop power control scheme is examined in D2D communication underlaying cellular network. The performance of the fractional open loop power control components on SINR is studied. The simulation results portrayed that the conventional open loop power control method provides increased compensation for the path loss with higher D2D transmit power when compared with the fractional open loop power control method. Furthermore, the problem of channel allocation to minimise interference is modelled in two system model scenarios, consisting of cellular users coexisting with D2D pairs with or without relay assistance. The channel allocation problem is solved as an assignment problem by using a proposed heuristic channel allocation, random channel allocation, Kuhn-Munkres (KM) and Gale-Shapley (GS) algorithms. A comparative performance evaluation for the algorithms are carried out in the two system model scenarios, and the results indicated that D2D communication with relay assistance outperformed the conventional D2D communication without relay assistance. This concludes that the introduction of relay-assisted D2D communication can improve the quality of a network while utilising the available spectral resources without additional infrastructure deployment costs. The research work can be extended to apply an effective relay selection approach for a user mobility scenario