Flow field simulation Patent

Wind tunnel method for simulating flow fields around blunt vehicles entering planetary atmospheres without involving high temperature

Continuous-flow laboratory simulation of stream water quality changes downstream of an untreated wastewater discharge.

In regions of the world with poor provision of wastewater treatment, raw sewage is often discharged directly into surface waters. This paper describes an experimental evaluation of the fate of two organic chemicals under these conditions using an artificial channel cascade fed with a mix of settled sewage and river water at its upstream end and operated under continuous steady-state conditions. The experiments underpin an environmental risk assessment methodology based on the idea of an “impact zone” (IZ) – the zone downstream of wastewater emission in which water quality is severely impaired by high concentrations of unionised ammonia, nitrite and biochemical oxygen demand (BOD). Radiolabelled dodecane-6-benzene sulphonate (DOBS) and aniline hydrochloride were used as the model chemical and reference compound respectively. Rapid changes in 14C counts were observed with flow-time for both these materials. These changes were most likely to be due to complete mineralisation. A dissipation half-life of approximately 7.1 h was observed for the 14C label with DOBS. The end of the IZ was defined as the point at which the concentration of both unionised ammonia and nitrite fell below their respective predicted no-effect concentrations for salmonids. At these points in the cascade, approximately 83 and 90% of the initial concentration of 14C had been removed from the water column, respectively. A simple model of mineral nitrogen transformations based on Michaelis–Menten kinetics was fitted to observed concentrations of NH4, NO2 and NO3. The cascade is intended to provide a confirmatory methodology for assessing the ecological risks of chemicals under direct discharge co

Hydrodynamic simulation of elliptic flow

We use a hydrodynamic model to study the space-time evolution transverse to the beam direction in ultrarelativistic heavy-ion collisions with nonzero impact parameters. We focus on the influence of early pressure on the development of radial and elliptic flow. We show that at high energies elliptic flow is generated only during the initial stages of the expansion while radial flow continues to grow until freeze-out. Quantitative comparisons with SPS data from semiperipheral Pb+Pb collisions suggest the applicability of hydrodynamical concepts already $\approx$ 1 fm/c after impact.Comment: 4 pages, 5 figures, proceedings for Quark Matter 9

A numerical flow simulation of a mixed flow pump

Mixed flow pumps are primarily axial flow pumps, but they impart some degree of radial and swirling momentum to the pump fluid as it passes through the rotor section. They are popular for pumping water in tight spaces, so are used for residential wells, municipal water works, industrial applications, and even for powering small water craft

An Automated Design-flow for FPGA-based Sequential Simulation

In this paper we describe the automated design flow that will transform and map a given homogeneous or heterogeneous hardware design into an FPGA that performs a cycle accurate simulation. The flow replaces the required manually performed transformation and can be embedded in existing standard synthesis flows. Compared to the earlier manually translated designs, this automated flow resulted in a reduced number of FPGA hardware resources and higher simulation frequencies. The implementation of the complete design flow is work in progress.\u