12,234 research outputs found

    Control of heat pumps with CO2 emission intensity forecasts

    Full text link
    An optimized heat pump control for building heating was developed for minimizing CO2 emissions from related electrical power generation. The control is using weather and CO2 emission forecasts as input to a Model Predictive Control (MPC) - a multivariate control algorithm using a dynamic process model, constraints and a cost function to be minimized. In a simulation study the control was applied using weather and power grid conditions during a full year period in 2017-2018 for the power bidding zone DK2 (East, Denmark). Two scenarios were studied; one with a family house and one with an office building. The buildings were dimensioned on the basis of standards and building codes. The main results are measured as the CO2 emission savings relative to a classical thermostatic control. Note that this only measures the gain achieved using the MPC control, i.e. the energy flexibility, not the absolute savings. The results show that around 16% savings could have been achieved during the period in well insulated new buildings with floor heating. Further, a sensitivity analysis was carried out to evaluate the effect of various building properties, e.g. level of insulation and thermal capacity. Danish building codes from 1977 and forward was used as benchmarks for insulation levels. It was shown that both insulation and thermal mass influence the achievable flexibility savings, especially for floor heating. Buildings that comply with codes later than 1979 could provide flexibility emission savings of around 10%, while buildings that comply with earlier codes provided savings in the range of 0-5% depending on the heating system and thermal mass.Comment: 16 pages, 12 figures. Submitted to Energie

    A GIS-based model to assess electric energy consumptions and usable renewable energy potential in Lazio region at municipality scale

    Get PDF
    The ongoing energy transition processes need a rapprochement between the places of energy production and consumption with the aim of creating innovative and integrated territorial models. Consequentially, models and strategies for increasing the use of local and renewable energy sources (RES) play a key rule for enhancing energy independence and sustainability of the considered areas. The main objective of this study is to analyse the energy system of the Lazio Region in Italy, comparing electricity consumptions and production from renewable sources at municipality scale. In order to estimate the electricity consumptions and the local production by RES, the main sectors of electricity consumption together with the potential of the available RES for the electricity production have been analysed. The obtained results pinpointed the main critical aspects of the Lazio region, that are mainly focalized in the city of Rome and in the most densely inhabited municipalities. Furthermore, research outputs provide an overall framework on the regional RES potential and allowed the formulation of proposals aimed at overcoming the identified criticalities and increasing the share of electricity production from renewables. Finally, the research approach could be replicated in other areas, providing a useful process for decision makers and stakeholders

    Small-Scale Compressed Air Energy Storage Application for Renewable Energy Integration in a Listed Building

    Get PDF
    In the European Union (EU), where architectural heritage is significant, enhancing the energy performance of historical buildings is of great interest. Constraints such as the lack of space, especially within the historical centers and architectural peculiarities, make the application of technologies for renewable energy production and storage a challenging issue. This study presents a prototype system consisting of using the renewable energy from a photovoltaic (PV) array to compress air for a later expansion to produce electricity when needed. The PV-integrated small-scale compressed air energy storage system is designed to address the architectural constraints. It is located in the unoccupied basement of the building. An energy analysis was carried out for assessing the performance of the proposed system. The novelty of this study is to introduce experimental data of a CAES (compressed air energy storage) prototype that is suitable for dwelling applications as well as integration accounting for architectural constraints. The simulation, which was carried out for an average summer day, shows that the compression phase absorbs 32% of the PV energy excess in a vessel of 1.7 m(3), and the expansion phase covers 21.9% of the dwelling energy demand. The electrical efficiency of a daily cycle is equal to 11.6%. If air is compressed at 225 bar instead of 30 bar, 96.0% of PV energy excess is stored in a volume of 0.25 m3, with a production of 1.273 kWh, which is 26.0% of the demand

    Inclusion of on-site renewables in design-stage building life cycle assessments

    Get PDF
    This paper investigates the inclusion of renewables in building life cycle assessments. On-site renewable electricity generation is increasingly common in the built environment, but existing guidance for the inclusion of these renewable systems in design-stage life cycle assessment is limited. The life cycle assessment of a building with 42.8 kWpeak solar photovoltaic array is used as a case study to investigate the effect of different assumptions on the assessment outcome. The case study results are then used to suggest good practice. The paper also highlights where further research is required to provide reliable design-stage assessments in future

    A dynamic simulation of low-carbon policy influences on endogenous electricity demand in an isolated island system

    Get PDF
    This paper considers the dynamics of electricity demand in response to changes arising from low-carbon policies and socio-economic developments. As part of an investigation into the evolution of such systems on small economically-developed islands, endogenous electricity demand and associated policies are studied for the Azorean island of São Miguel. A comprehensive System Dynamics (SD) model covering the period 2005 − 2050 is presented which captures both historical behaviours and real-world influences on the endogenous demand dynamics of an island-based electricity system. The impact of tourism, energy efficiency and electric vehicles (EV) expansion allied with associated policy options, are critically evaluated by the SD model using a series of scenarios. The model shows that energy efficiency measures exhibit the most significant long-term impact on electricity demand, while in contrast, policies to increase tourism have a much less direct impact and EV expansion has thought-provoking impacts on the long-term demand, although this is not as influential as energy efficiency measures

    Relying on storage or ICT? How to maintain low voltage grids' stability with an increasing feed-in of fluctuating renewable energy sources

    Get PDF
    Since the beginning of the new century our electricity system is changing rapidly. Distributed energy resources, such as wind or solar energies are becoming more and more important. These energies are producing fluctuating electricity, which is fed into low voltage distribution grids. The resulting volatility complicates the exact balancing of demand and supply. These changes can lead to distribution grid instabilities, damages of electronic devices or even power outages and might therefore end in deadweight losses affecting all electricity users. A concept to tackle this challenge is matching demand with supply in real-time, which is known as smart grids. In this study, we focus on two smart grids' key components: decentralized electricity storages and smart meters. The aim of this study is to provide new insights concerning the low diffusion of smart meters and decentralized electricity storages and to examine whether we are facing situations of positive externalities. During our study we conducted eight in-depth expert interviews. Our findings show that the diffusion of smart meters as well as decentralized electricity storages is widely seen as beneficial to society. This study identifies the most important stakeholders and various related private costs and benefits. As private benefits are numerous but widely distributed among distinct players, we argue that we face situations of positive externalities and thus societal desirable actions are omitted. We identify and discuss measures to foster diffusion of the two studied smart grid key components. Surprisingly, we find that direct interventions like subsidies are mostly not seen as appropriate even by experts from industries that would directly benefit from them. As the most important point, we identified well-designed and clearly defined regulatory and legal frameworks that are free of contradictions. --smart meter,decentralized electricity storage,smart grid,externality
    corecore