35 research outputs found
Linear Precoders for Non-Regenerative Asymmetric Two-way Relaying in Cellular Systems
Two-way relaying (TWR) reduces the spectral-efficiency loss caused in
conventional half-duplex relaying. TWR is possible when two nodes exchange data
simultaneously through a relay. In cellular systems, data exchange between base
station (BS) and users is usually not simultaneous e.g., a user (TUE) has
uplink data to transmit during multiple access (MAC) phase, but does not have
downlink data to receive during broadcast (BC) phase. This non-simultaneous
data exchange will reduce TWR to spectrally-inefficient conventional
half-duplex relaying. With infrastructure relays, where multiple users
communicate through a relay, a new transmission protocol is proposed to recover
the spectral loss. The BC phase following the MAC phase of TUE is now used by
the relay to transmit downlink data to another user (RUE). RUE will not be able
to cancel the back-propagating interference. A structured precoder is designed
at the multi-antenna relay to cancel this interference. With multiple-input
multiple-output (MIMO) nodes, the proposed precoder also triangulates the
compound MAC and BC phase MIMO channels. The channel triangulation reduces the
weighted sum-rate optimization to power allocation problem, which is then cast
as a geometric program. Simulation results illustrate the effectiveness of the
proposed protocol over conventional solutions.Comment: 30 pages, 7 figures, submitted to IEEE Transactions on Wireless
Communication
How to Understand LMMSE Transceiver Design for MIMO Systems From Quadratic Matrix Programming
In this paper, a unified linear minimum mean-square-error (LMMSE) transceiver
design framework is investigated, which is suitable for a wide range of
wireless systems. The unified design is based on an elegant and powerful
mathematical programming technology termed as quadratic matrix programming
(QMP). Based on QMP it can be observed that for different wireless systems,
there are certain common characteristics which can be exploited to design LMMSE
transceivers e.g., the quadratic forms. It is also discovered that evolving
from a point-to-point MIMO system to various advanced wireless systems such as
multi-cell coordinated systems, multi-user MIMO systems, MIMO cognitive radio
systems, amplify-and-forward MIMO relaying systems and so on, the quadratic
nature is always kept and the LMMSE transceiver designs can always be carried
out via iteratively solving a number of QMP problems. A comprehensive framework
on how to solve QMP problems is also given. The work presented in this paper is
likely to be the first shoot for the transceiver design for the future
ever-changing wireless systems.Comment: 31 pages, 4 figures, Accepted by IET Communication
Mathematical optimization and signal processing techniques for cooperative wireless networks
The rapid growth of mobile users and emergence of high data rate multimedia and interactive services have resulted in a shortage of the radio spectrum. Novel solutions are therefore required for future generations of wireless networks to enhance capacity and coverage. This thesis aims at addressing this issue through the design and analysis of signal processing algorithms. In particular various resource allocation and spatial diversity techniques have
been proposed within the context of wireless peer-to-peer relays and coordinated base station (BS) processing.
In order to enhance coverage while providing improvement in capacity, peer-to-peer relays that share the same frequency band have been considered and various techniques for designing relay coefficients and allocating powers optimally are proposed. Both one-way and two-way amplify and forward (AF) relays have been investigated. In order to maintain fairness, a signal-to-interference plus noise ratio (SINR) balancing criterion has been adopted. In order to improve the spectrum utilization further, the relays within the context of cognitive radio network are also considered. In this case, a cognitive peer-to-peer relay network is required to achieve SINR balancing while maintaining the interference leakage to primary receiver below a certain threshold.
As the spatial diversity techniques in the form of multiple-input-multipleoutput (MIMO) systems have the potential to enhance capacity significantly, the above work has been extended to peer-to-peer MIMO relay networks. Transceiver and relay beamforming design based on minimum mean-square error (MSE) criterion has been proposed. Establishing uplink downlink MSE duality, an alternating algorithm has been developed. A scenario where multiple users are served by both the BS and a MIMO relay is considered and a joint beamforming technique for the BS and the MIMO relay is proposed. With the motivation of optimising the transmission power at both the BS and the relay, an interference precoding design is presented that takes into account the knowledge of the interference caused by the relay to the users served by the BS.
Recognizing joint beamformer design for multiple BSs has the ability to reduce interference in the network significantly, cooperative multi-cell beamforming design is proposed. The aim is to design multi-cell beamformers to maximize the minimum SINR of users subject to individual BS power constraints. In contrast to all works available in the literature that aimed at balancing SINR of all users in all cells to the same level, the SINRs of users in each cell is balanced and maximized at different values. This new technique takes advantage of the fact that BSs may have different available transmission powers and/or channel conditions for their users
Hybrid Transceiver Optimization for Multi-Hop Communications
Multi-hop communication with the aid of large-scale antenna arrays will play
a vital role in future emergence communication systems. In this paper, we
investigate amplify-and-forward based and multiple-input multiple-output
assisted multi-hop communication, in which all nodes employ hybrid
transceivers. Moreover, channel errors are taken into account in our hybrid
transceiver design. Based on the matrix-monotonic optimization framework, the
optimal structures of the robust hybrid transceivers are derived. By utilizing
these optimal structures, the optimizations of analog transceivers and digital
transceivers can be separated without loss of optimality. This fact greatly
simplifies the joint optimization of analog and digital transceivers. Since the
optimization of analog transceivers under unit-modulus constraints is
non-convex, a projection type algorithm is proposed for analog transceiver
optimization to overcome this difficulty. Based on the derived analog
transceivers, the optimal digital transceivers can then be derived using
matrix-monotonic optimization. Numeral results obtained demonstrate the
performance advantages of the proposed hybrid transceiver designs over other
existing solutions.Comment: 32 pages, 6 figures. This manuscript has been submitted to IEEE
Journal on Selected Areas in Communications (special issue on Multiple
Antenna Technologies for Beyond 5G