Performance analysis of modified asymmetrically-clipped optical orthogonal frequency-division multiplexing systems

A modification to the Asymmetrically-Clipped Optical Orthogonal Frequency-Division Multiplexing (ACO-OFDM) technique is proposed through unipolar encoding. A performance analysis of the Bit Error Rate (BER) is developed and Monte Carlo simulations are carried out to verify the analysis. Results are compared to that of the corresponding ACO-OFDM system under the same bit energy and transmission rate; an improvement of 1 dB is obtained at a BER of 10-4. In addition, the performance of the proposed system in the presence of atmospheric turbulence is investigated using single-input multiple-output (SIMO) configuration and its performance under that environment is compared to that of ACO-OFDM. Energy improvements of 4 dB and 2.2 dB are obtained at a BER of 10-4 for SIMO systems of 1 and 2 photodetectors at the receiver for the case of strong turbulence, respectively

Flip-OFDM for Optical Wireless Communications

We consider two uniploar OFDM techniques for optical wireless communications: asymmetric clipped optical OFDM (ACO-OFDM) and Flip-OFDM. Both techniques can be used to compensate multipath distortion effects in optical wireless channels. However, ACO-OFDM has been widely studied in the literature, while the performance of Flip-OFDM has never been investigated. In this paper, we conduct the performance analysis of Flip-OFDM and propose additional modification to the original scheme in order to compare the performance of both techniques. Finally, it is shown by simulation that both techniques have the same performance but different hardware complexities. In particular, for slow fading channels, Flip-OFDM offers 50% saving in hardware complexity over ACO-OFDM at the receiver.Comment: published in IEEE Information Theory Workshop, Paraty Brazil, Sept 201

EVM and Achievable Data Rate Analysis of Clipped OFDM Signals in Visible Light Communication

Orthogonal frequency division multiplexing (OFDM) has been considered for visible light communication (VLC) thanks to its ability to boost data rates as well as its robustness against frequency-selective fading channels. A major disadvantage of OFDM is the large dynamic range of its time-domain waveforms, making OFDM vulnerable to nonlinearity of light emitting diodes (LEDs). DC biased optical OFDM (DCO-OFDM) and asymmetrically clipped optical OFDM (ACO-OFDM) are two popular OFDM techniques developed for the VLC. In this paper, we will analyze the performance of the DCO-OFDM and ACO-OFDM signals in terms of error vector magnitude (EVM), signal-to-distortion ratio (SDR), and achievable data rates under both average optical power and dynamic optical power constraints. EVM is a commonly used metric to characterize distortions. We will describe an approach to numerically calculate the EVM for DCO-OFDM and ACO-OFDM. We will derive the optimum biasing ratio in the sense of minimizing EVM for DCO-OFDM. Additionally, we will formulate the EVM minimization problem as a convex linear optimization problem and obtain an EVM lower bound against which to compare the DCO-OFDM and ACO-OFDM techniques. We will prove that the ACO-OFDM can achieve the lower bound. Average optical power and dynamic optical power are two main constraints in VLC. We will derive the achievable data rates under these two constraints for both additive white Gaussian noise (AWGN) channel and frequency-selective channel. We will compare the performance of DCO-OFDM and ACO-OFDM under different power constraint scenarios

Coded Index Modulation for Non-DC-Biased OFDM in Multiple LED Visible Light Communication

Use of multiple light emitting diodes (LED) is an attractive way to increase spectral efficiency in visible light communications (VLC). A non-DC-biased OFDM (NDC OFDM) scheme that uses two LEDs has been proposed in the literature recently. NDC OFDM has been shown to perform better than other OFDM schemes for VLC like DC-biased OFDM (DCO OFDM) and asymmetrically clipped OFDM (ACO OFDM) in multiple LEDs settings. In this paper, we propose an efficient multiple LED OFDM scheme for VLC which uses {\em coded index modulation}. The proposed scheme uses two transmitter blocks, each having a pair of LEDs. Within each block, NDC OFDM signaling is done. The selection of which block is activated in a signaling interval is decided by information bits (i.e., index bits). In order to improve the reliability of the index bits at the receiver (which is critical because of high channel correlation in multiple LEDs settings), we propose to use coding on the index bits alone. We call the proposed scheme as CI-NDC OFDM (coded index NDC OFDM) scheme. Simulation results show that, for the same spectral efficiency, CI-NDC OFDM that uses LDPC coding on the index bits performs better than NDC OFDM

On the Performance of Single- and Multi-carrier Modulation Schemes for Indoor Visible Light Communication Systems

In this paper, we investigate and compare the performance of single- and multi-carrier modulation schemes for indoor visible light communication (VLC). Particularly, the performances of single carrier frequency domain equalization (SCFDE), orthogonal frequency division multiplexing (OFDM) and on-off keying (OOK) with minimum mean square error equalization (MMSE) are analyzed in order to mitigate the effect of multipath distortion of the indoor optical channel where nonlinearity distortion of light emitting diode (LED) transfer function is taken into account. Our results indicate that SCFDE system, in contrast to OFDM system, does not suffer from high peak to average power ratio (PAPR) and can outperform OFDM and OOK systems. We further investigate the impact of LED bias point on the performance of OFDM systems and show that biasing LED with the optimum value can significantly enhance the performance of the system. Bit-interleaved coded modulation (BICM) is also considered for OFDM and SCFDE systems to further compensate signal degradation due to inter-symbol interference (ISI) and LED nonlinearity.Comment: 6 Pages, IEEE Globecom conference 201

System design and performance analysis of asymmetrically and symmetrically clipped optical (ASCO)-OFDM for IM/DD optical wireless communications

As the quantity of mobile communication devices, such as cellphones, tablets, and laptops, dramatically increase, the demand for high speed wireless service has been growing. Optical wireless communications (OWCs), which offer unlimited transmission bandwidth, have received a lot of attention and been studied in recent decades. They can be an effective alternative to radio frequency communications (RFCs) for indoor high speed data transmission. Intensity modulation direct detection (IM/DD) is a simple way to realize the transmission of optical wireless signals in an indoor environment. Information data streams are modulated into the intensity of optical carriers and transmitted by light emitting diodes (LEDs). At the receiver, the instantaneous power of optical signals can be directly detected by photodiodes. Multipath distortion, especially in an indoor environment, caused by reflection from walls or furniture, severely affects the transmission quality of optical signals. Orthogonal frequency division multiplexing (OFDM) is a promising modulation technique and has been widely used to combat inter-symbol-interference (ISI) resulting from multipath propagation in RFCs. So far, the technique of OFDM has also been successfully applied into IM/DD optical wireless systems. In this dissertation, the author focuses on the system design and performance analysis of a novel power-efficient scheme based on OFDM for IM/DD OWCs. This dissertation is divided into four main sections. In the first part, a novel power-efficient scheme, called asymmetrically and symmetrically clipped optical (ASCO)-OFDM, for intensity modulation direct detection (IM/DD) optical wireless systems is proposed. The average bit rate versus (vs.) normalized bandwidth and the optical power per bit of this novel scheme are expressed by a closed form, respectively. The symbol error rate (SER) performance is investigated when optical signals are transmitted in a flat fading channel. Simulation results show that this proposed scheme can achieve better performances in terms of both power efficiency and symbol error rate (SER) when the optical power of transmitted signals is limited. In the second part, an improved receiving technique is applied into the conventional receiver of ASCO-OFDM to improve the SER performance. This technique can explore and reuse some useful information hidden in the received signals. The detection procedure is described in detail and the improved SER performances are presented for different constellation cases. In the third part, the information rates of ADO-OFDM and ASCO-OFDM are obtained for an additive white Gaussian noise (AWGN) channel with an average transmitted optical power constraint. In the last part, this novel power efficient scheme, ASCO-OFDM, is extended into two-dimensional (2D) IM/DD optical wireless systems. The theoretical analysis and simulation results show that this technique not only achieves high average bit rate, but reduces the Peak-to-average power ratio (PAPR) as well

Study And Analysis Of An Optical OFDM Based On The Discrete Hartley Transform For IM/DD Systems

Projecte fet en col.lboració amb CTTC. Centre Tecnològic de Telecomunicacions de CatalunyaOrthogonal frequency division multiplexing (OFDM) is used extensively in broadband wired and wireless communication systems because it is an effective solution to inter channel. While many details of OFDM systems are very complex, the basic concept of OFDM is quite simple: data is transmi number of different frequencies, and as a result the symbol period is much longer than for a serial system with the same total data rate. Because the symbol period is longer, ISI affects at most one symbol, and equalization is simplified. In most OFDM implementations any residual ISI is removed by using a form of guard interval called a cyclic prefix