18,741 research outputs found
How do Wireless Chains Behave? The Impact of MAC Interactions
In a Multi-hop Wireless Networks (MHWN), packets are routed between source
and destination using a chain of intermediate nodes; chains are a fundamental
communication structure in MHWNs whose behavior must be understood to enable
building effective protocols. The behavior of chains is determined by a number
of complex and interdependent processes that arise as the sources of different
chain hops compete to transmit their packets on the shared medium. In this
paper, we show that MAC level interactions play the primary role in determining
the behavior of chains. We evaluate the types of chains that occur based on the
MAC interactions between different links using realistic propagation and packet
forwarding models. We discover that the presence of destructive interactions,
due to different forms of hidden terminals, does not impact the throughput of
an isolated chain significantly. However, due to the increased number of
retransmissions required, the amount of bandwidth consumed is significantly
higher in chains exhibiting destructive interactions, substantially influencing
the overall network performance. These results are validated by testbed
experiments. We finally study how different types of chains interfere with each
other and discover that well behaved chains in terms of self-interference are
more resilient to interference from other chains
Spectrum Utilization and Congestion of IEEE 802.11 Networks in the 2.4 GHz ISM Band
Wi-Fi technology, plays a major role in society thanks to its widespread availability, ease of use and low cost. To assure its long term viability in terms of capacity and ability to share the spectrum efficiently, it is of paramount to study the spectrum utilization and congestion mechanisms in live environments. In this paper the service level in the 2.4 GHz ISM band is investigated with focus on todays IEEE 802.11 WLAN systems with support for the 802.11e extension. Here service level means the overall Quality of Service (QoS), i.e. can all devices fulfill their communication needs? A crosslayer approach is used, since the service level can be measured at several levels of the protocol stack. The focus is on monitoring at both the Physical (PHY) and the Medium Access Control (MAC) link layer simultaneously by performing respectively power measurements with a spectrum analyzer to assess spectrum utilization and packet sniffing to measure the congestion. Compared to traditional QoS analysis in 802.11 networks, packet sniffing allows to study the occurring congestion mechanisms more thoroughly. The monitoring is applied for the following two cases. First the influence of interference between WLAN networks sharing the same radio channel is investigated in a controlled environment. It turns out that retry rate, Clear-ToSend (CTS), Request-To-Send (RTS) and (Block) Acknowledgment (ACK) frames can be used to identify congestion, whereas the spectrum analyzer is employed to identify the source of interference. Secondly, live measurements are performed at three locations to identify this type of interference in real-live situations. Results show inefficient use of the wireless medium in certain scenarios, due to a large portion of management and control frames compared to data content frames (i.e. only 21% of the frames is identified as data frames)
Collision-free Time Slot Reuse in Multi-hop Wireless Sensor Networks
To ensure a long-lived network of wireless communicating sensors, we are in need of a medium access control protocol that is able to prevent energy-wasting effects like idle listening, hidden terminal problem or collision of packets. Schedule-based medium access protocols are in general robust against these effects, but require a mechanism to establish a non-conflicting schedule. In this paper, we present such a mechanism which allows wireless sensors to choose a time interval for transmission, which is not interfering or causing collisions with other transmissions. In our solution, we do not assume any hierarchical organization in the network and all operation is localized. We empirically show that our localized algorithm is successful within a factor 2 of the minimum necessary time slots in random networks; well in range of the expected (worst case) factor 3-approximation of known first-fit algorithms. Our algorithm assures similar minimum distance between simultaneous transmissions as CSMA(/CD)-based approaches
Opportunistic Interference Mitigation Achieves Optimal Degrees-of-Freedom in Wireless Multi-cell Uplink Networks
We introduce an opportunistic interference mitigation (OIM) protocol, where a
user scheduling strategy is utilized in -cell uplink networks with
time-invariant channel coefficients and base stations (BSs) having
antennas. Each BS opportunistically selects a set of users who generate the
minimum interference to the other BSs. Two OIM protocols are shown according to
the number of simultaneously transmitting users per cell: opportunistic
interference nulling (OIN) and opportunistic interference alignment (OIA).
Then, their performance is analyzed in terms of degrees-of-freedom (DoFs). As
our main result, it is shown that DoFs are achievable under the OIN
protocol with selected users per cell, if the total number of users in
a cell scales at least as . Similarly, it turns out that
the OIA scheme with () selected users achieves DoFs, if scales
faster than . These results indicate that there exists a
trade-off between the achievable DoFs and the minimum required . By deriving
the corresponding upper bound on the DoFs, it is shown that the OIN scheme is
DoF optimal. Finally, numerical evaluation, a two-step scheduling method, and
the extension to multi-carrier scenarios are shown.Comment: 18 pages, 3 figures, Submitted to IEEE Transactions on Communication
Dynamic Channel Access Scheme for Interference Mitigation in Relay-assisted Intra-WBANs
This work addresses problems related to interference mitigation in a single
wireless body area network (WBAN). In this paper, We propose a distributed
\textit{C}ombined carrier sense multiple access with collision avoidance
(CSMA/CA) with \textit{F}lexible time division multiple access (\textit{T}DMA)
scheme for \textit{I}nterference \textit{M}itigation in relay-assisted
intra-WBAN, namely, CFTIM. In CFTIM scheme, non interfering sources
(transmitters) use CSMA/CA to communicate with relays. Whilst, high interfering
sources and best relays use flexible TDMA to communicate with coordinator (C)
through using stable channels. Simulation results of the proposed scheme are
compared to other schemes and consequently CFTIM scheme outperforms in all
cases. These results prove that the proposed scheme mitigates interference,
extends WBAN energy lifetime and improves the throughput. To further reduce the
interference level, we analytically show that the outage probability can be
effectively reduced to the minimal.Comment: 2015 IEEE International Conference on Protocol Engineering (ICPE) and
International Conference on New Technologies of Distributed Systems (NTDS),
Paris, France. arXiv admin note: text overlap with arXiv:1602.0865
Issues on packet transmissioin strategies in a TDD-TD/CDMA scenario
This paper presents a packet transmission scheme that deals with the problems of a TDD CDMA scenario with different levels of frame structure asymmetry in adjacent base stations by distributing the users in the slots depending on their Time Advance. A multiple access protocol and a scheduling algorithm are also proposed to provide a certain degree of Quality of Service.Peer ReviewedPostprint (published version
AirSync: Enabling Distributed Multiuser MIMO with Full Spatial Multiplexing
The enormous success of advanced wireless devices is pushing the demand for
higher wireless data rates. Denser spectrum reuse through the deployment of
more access points per square mile has the potential to successfully meet the
increasing demand for more bandwidth. In theory, the best approach to density
increase is via distributed multiuser MIMO, where several access points are
connected to a central server and operate as a large distributed multi-antenna
access point, ensuring that all transmitted signal power serves the purpose of
data transmission, rather than creating "interference." In practice, while
enterprise networks offer a natural setup in which distributed MIMO might be
possible, there are serious implementation difficulties, the primary one being
the need to eliminate phase and timing offsets between the jointly coordinated
access points.
In this paper we propose AirSync, a novel scheme which provides not only time
but also phase synchronization, thus enabling distributed MIMO with full
spatial multiplexing gains. AirSync locks the phase of all access points using
a common reference broadcasted over the air in conjunction with a Kalman filter
which closely tracks the phase drift. We have implemented AirSync as a digital
circuit in the FPGA of the WARP radio platform. Our experimental testbed,
comprised of two access points and two clients, shows that AirSync is able to
achieve phase synchronization within a few degrees, and allows the system to
nearly achieve the theoretical optimal multiplexing gain. We also discuss MAC
and higher layer aspects of a practical deployment. To the best of our
knowledge, AirSync offers the first ever realization of the full multiuser MIMO
gain, namely the ability to increase the number of wireless clients linearly
with the number of jointly coordinated access points, without reducing the per
client rate.Comment: Submitted to Transactions on Networkin
- …