Error resilient video transcoding for robust inter-network communications using GPRS

A novel fully comprehensive mobile video communications system is proposed in this paper. This system exploits the useful rate management features of the video transcoders and combines them with error resilience for transmissions of coded video streams over general packet radio service (GPRS) mobileaccess networks. The error-resilient video transcoding operation takes place at a centralized point, referred to as a video proxy, which provides the necessary output transmission rates with the required amount of robustness. With the use of this proposed algorithm, error resilience can be added to an already compressed video stream at an intermediate stage at the edge of two or more different networks through two resilience schemes, namely the adaptive intra refresh (AIR) and feedback control signaling (FCS) methods. Both resilience tools impose an output rate increase which can also be prevented with the proposed novel technique in this paper. Thus, an error-resilient video transcoding scheme is presented to give robust video outputs at near target transmission rates that only require the same number of GPRS timeslots as the nonresilient schemes. Moreover, an ultimate robustness is also accomplished with the combination of the two resilience algorithms at the video proxy. Extensive computer simulations demonstrate the effectiveness of the proposed system

Intra Coding Strategy for Video Error Resiliency: Behavioral Analysis

One challenge in video transmission is to deal with packet loss. Since the compressed video streams are sensitive to data loss, the error resiliency of the encoded video becomes important. When video data is lost and retransmission is not possible, the missed data should be concealed. But loss concealment causes distortion in the lossy frame which also propagates into the next frames even if their data are received correctly. One promising solution to mitigate this error propagation is intra coding. There are three approaches for intra coding: intra coding of a number of blocks selected randomly or regularly, intra coding of some specific blocks selected by an appropriate cost function, or intra coding of a whole frame. But Intra coding reduces the compression ratio; therefore, there exists a trade-off between bitrate and error resiliency achieved by intra coding. In this paper, we study and show the best strategy for getting the best rate-distortion performance. Considering the error propagation, an objective function is formulated, and with some approximations, this objective function is simplified and solved. The solution demonstrates that periodical I-frame coding is preferred over coding only a number of blocks as intra mode in P-frames. Through examination of various test sequences, it is shown that the best intra frame period depends on the coding bitrate as well as the packet loss rate. We then propose a scheme to estimate this period from curve fitting of the experimental results, and show that our proposed scheme outperforms other methods of intra coding especially for higher loss rates and coding bitrates

Error resilient packet switched H.264 video telephony over third generation networks.

Real-time video communication over wireless networks is a challenging problem because wireless channels suffer from fading, additive noise and interference, which translate into packet loss and delay. Since modern video encoders deliver video packets with decoding dependencies, packet loss and delay can significantly degrade the video quality at the receiver. Many error resilience mechanisms have been proposed to combat packet loss in wireless networks, but only a few were specifically designed for packet switched video telephony over Third Generation (3G) networks. The first part of the thesis presents an error resilience technique for packet switched video telephony that combines application layer Forward Error Correction (FEC) with rateless codes, Reference Picture Selection (RPS) and cross layer optimization. Rateless codes have lower encoding and decoding computational complexity compared to traditional error correcting codes. One can use them on complexity constrained hand-held devices. Also, their redundancy does not need to be fixed in advance and any number of encoded symbols can be generated on the fly. Reference picture selection is used to limit the effect of spatio-temporal error propagation. Limiting the effect of spatio-temporal error propagation results in better video quality. Cross layer optimization is used to minimize the data loss at the application layer when data is lost at the data link layer. Experimental results on a High Speed Packet Access (HSPA) network simulator for H.264 compressed standard video sequences show that the proposed technique achieves significant Peak Signal to Noise Ratio (PSNR) and Percentage Degraded Video Duration (PDVD) improvements over a state of the art error resilience technique known as Interactive Error Control (IEC), which is a combination of Error Tracking and feedback based Reference Picture Selection. The improvement is obtained at a cost of higher end-to-end delay. The proposed technique is improved by making the FEC (Rateless code) redundancy channel adaptive. Automatic Repeat Request (ARQ) is used to adjust the redundancy of the Rateless codes according to the channel conditions. Experimental results show that the channel adaptive scheme achieves significant PSNR and PDVD improvements over the static scheme for a simulated Long Term Evolution (LTE) network. In the third part of the thesis, the performance of the previous two schemes is improved by making the transmitter predict when rateless decoding will fail. In this case, reference picture selection is invoked early and transmission of encoded symbols for that source block is aborted. Simulations for an LTE network show that this results in video quality improvement and bandwidth savings. In the last part of the thesis, the performance of the adaptive technique is improved by exploiting the history of the wireless channel. In a Rayleigh fading wireless channel, the RLC-PDU losses are correlated under certain conditions. This correlation is exploited to adjust the redundancy of the Rateless code and results in higher Rateless code decoding success rate and higher video quality. Simulations for an LTE network show that the improvement was significant when the packet loss rate in the two wireless links was 10%. To facilitate the implementation of the proposed error resilience techniques in practical scenarios, RTP/UDP/IP level packetization schemes are also proposed for each error resilience technique. Compared to existing work, the proposed error resilience techniques provide better video quality. Also, more emphasis is given to implementation issues in 3G networks

Robust multi-view video streaming through adaptive intra refresh video transcoding

A multi-view video (MVV) transcoder has been designed. The objective is to deliver maximum quality 3D video data from the source to the 2D video destination, through a wireless communication channel using all of its available bandwidth. This design makes use of the spatial and view downscaling algorithm. The method involves the reuse of motion information obtained from both the reference frames and views. Consequently, highly compressed MVV is converted into low bit rate single view video that is compliant with H.264/AVC format. Adaptive intra refresh (AIR) error resilience tool is configured to mitigate the error propagation resulting from channel conditions. Experimental results indicate that error resilience plus transcoding performed better than the cascaded technique. Simulation results demonstrated an efficient 3D video streaming service applied to low power mobile devices

Error resilience and concealment techniques for high-efficiency video coding

This thesis investigates the problem of robust coding and error concealment in High Efficiency Video Coding (HEVC). After a review of the current state of the art, a simulation study about error robustness, revealed that the HEVC has weak protection against network losses with significant impact on video quality degradation. Based on this evidence, the first contribution of this work is a new method to reduce the temporal dependencies between motion vectors, by improving the decoded video quality without compromising the compression efficiency. The second contribution of this thesis is a two-stage approach for reducing the mismatch of temporal predictions in case of video streams received with errors or lost data. At the encoding stage, the reference pictures are dynamically distributed based on a constrained Lagrangian rate-distortion optimization to reduce the number of predictions from a single reference. At the streaming stage, a prioritization algorithm, based on spatial dependencies, selects a reduced set of motion vectors to be transmitted, as side information, to reduce mismatched motion predictions at the decoder. The problem of error concealment-aware video coding is also investigated to enhance the overall error robustness. A new approach based on scalable coding and optimally error concealment selection is proposed, where the optimal error concealment modes are found by simulating transmission losses, followed by a saliency-weighted optimisation. Moreover, recovery residual information is encoded using a rate-controlled enhancement layer. Both are transmitted to the decoder to be used in case of data loss. Finally, an adaptive error resilience scheme is proposed to dynamically predict the video stream that achieves the highest decoded quality for a particular loss case. A neural network selects among the various video streams, encoded with different levels of compression efficiency and error protection, based on information from the video signal, the coded stream and the transmission network. Overall, the new robust video coding methods investigated in this thesis yield consistent quality gains in comparison with other existing methods and also the ones implemented in the HEVC reference software. Furthermore, the trade-off between coding efficiency and error robustness is also better in the proposed methods

Error and Congestion Resilient Video Streaming over Broadband Wireless

In this paper, error resilience is achieved by adaptive, application-layer rateless channel coding, which is used to protect H.264/Advanced Video Coding (AVC) codec data-partitioned videos. A packetization strategy is an effective tool to control error rates and, in the paper, source-coded data partitioning serves to allocate smaller packets to more important compressed video data. The scheme for doing this is applied to real-time streaming across a broadband wireless link. The advantages of rateless code rate adaptivity are then demonstrated in the paper. Because the data partitions of a video slice are each assigned to different network packets, in congestion-prone wireless networks the increased number of packets per slice and their size disparity may increase the packet loss rate from buffer overflows. As a form of congestion resilience, this paper recommends packet-size dependent scheduling as a relatively simple way of alleviating the buffer-overflow problem arising from data-partitioned packets. The paper also contributes an analysis of data partitioning and packet sizes as a prelude to considering scheduling regimes. The combination of adaptive channel coding and prioritized packetization for error resilience with packet-size dependent packet scheduling results in a robust streaming scheme specialized for broadband wireless and real-time streaming applications such as video conferencing, video telephony, and telemedicine

Evaluating the Use of QoS for Video Delivery in Vehicular Networks

In a near future, video transmission capabilities in intelligent vehicular networks will be essential for deploying high-demanded multimedia services for drivers and passengers. Applications and services like video on demand, iTV, context-aware video commercials, touristic information, driving assis-tance, multimedia e-call, etc., will be part of the common multimedia service-set of future transportation systems. However, wireless vehicular networks introduce several constraints that may seriously impact on the final quality of the video content delivery process. Factors like the shared-medium communication model, the limited bandwidth, the unconstrained delays, the signal propagation issues, and the node mobility, will be the ones that will degrade video delivery performance, so it will be a hard task to guarantee the minimum quality of service required by video applications. In this work, we will study how these factors impact on the received video quality by using a detailed simulation model of a urban vehicular network scenario. We will apply different techniques to reduce the video quality degradation produced by the transmission impairments like (a) Intra-refresh video coding modes, (b) frame partitioning (tiles/slices), and (c) quality of service at the Medium Access Control (MAC) level. So, we will learn how these techniques are able to fight against the network impairments produced by the hostile environment typically found in vehicular network scenarios. The experiments were carried out with a simulation environment based on the OMNeT++, Veins and SUMO simulators. Results show that the combination of the proposed techniques significantly improves the robustness of video transmission in vehicular networks, paving the way, with a wise collaboration with other techniques, to achieve a robust video delivery system that supports multimedia applications in future intelligent transportation systems

Error concealment-aware encoding for robust video transmission

In this paper an error concealment-aware encoding scheme is proposed to improve the quality of decoded video in broadcast environments prone to transmission errors and data loss. The proposed scheme is based on a scalable coding approach where the best error concealment (EC) methods to be used at the decoder are optimally determined at the encoder and signalled to the decoder through SEI messages. Such optimal EC modes are found by simulating transmission losses followed by a lagrangian optimisation of the signalling rate - EC distortion cost. A generalised saliency-weighted distortion is used and the residue between coded frames and their EC substitutes is encoded using a rate-controlled enhancement layer. When data loss occurs the decoder uses the signalling information is used at the decoder, in case of data loss, to improve the reconstruction quality. The simulation results show that the proposed method achieves consistent quality gains in comparison with other reference methods and previous works. Using only the EC mode signalling, i.e., without any residue transmitted in the enhancement layer, an average PSNR gain up to 2.95 dB is achieved, while using the full EC-aware scheme, i.e., including residue encoded in the enhancement layer, the proposed scheme outperforms other comparable methods, with PSNR gain up to 3.79 dB

Robust decoder-based error control strategy for recovery of H.264/AVC video content

Real-time wireless conversational and broadcasting multimedia applications offer particular transmission challenges as reliable content delivery cannot be guaranteed. The undelivered and erroneous content causes significant degradation in quality of experience. The H.264/AVC standard includes several error resilient tools to mitigate this effect on video quality. However, the methods implemented by the standard are based on a packet-loss scenario, where corrupted slices are dropped and the lost information concealed. Partially damaged slices still contain valuable information that can be used to enhance the quality of the recovered video. This study presents a novel error recovery solution that relies on a joint source-channel decoder to recover only feasible slices. A major advantage of this decoder-based strategy is that it grants additional robustness while keeping the same transmission data rate. Simulation results show that the proposed approach manages to completely recover 30.79% of the corrupted slices. This provides frame-by-frame peak signal-to-noise ratio (PSNR) gains of up to 18.1%dB, a result which, to the knowledge of the authors, is superior to all other joint source-channel decoding methods found in literature. Furthermore, this error resilient strategy can be combined with other error resilient tools adopted by the standard to enhance their performance.peer-reviewe