The following report describes in detail the elements of a  literature search performed for the Southwest Florida Water Management District (SWFWMD), Department of Surface Water Improvement and Management (SWIM). The work was performed in accordance with the agreement between the District and Mote Marine Laboratory (MML), and comprises Task 3.0 (Literature Search) of the project entitled,  Tampa Bay Water Quality Assessment- Determination of Environmental Requirements of Selected Populations

E. Cerri

M. El Mehetedi

P. Leo

S. Spigarelli

Materials Science and Engineering A

English

Leverone, Jay R.

Dixon, L. Kellie

Valenti, M. Grey

Scholar Commons | University of South Florida Research

Draft Seagrass Bibliography Data Base

This paper studies the high temperature mechanical properties of as-cast Al–Zn–Mg using tensile and
creep testing. Hot tensile tests were performed in the temperature and strain rate ranges of 350–400 ◦C
and 10−5 to 10−3 s−1 respectively. Creep tests were carried out under constant load with initial stress
ranging from 5 to 22 MPa, at 350 and 400 ◦C. The alloy exhibits class A creep behavior, due to the viscous
glide of dislocations. The tensile flow curves, corrected to account for the effect of sample elongation
on strain rate, also show a decline in stress commonly observed in Al–Mg alloys. The highest ductility
and strain rate sensitivity were both observed for strain rates ranging from 10−5 to 10−4 s−1. During
hot deformation the alloy exhibits cavitation which increases with temperature. The analysis of these
phenomena has shown that cavity growth is mainly controlled by plastic strain

LEO, PAOLA

Archivio Istituzionale della Ricerca- Università del Salento

High temperature mechanical properties of an aluminium alloy containing Zn and Mg

M. El Mehtedi

Crossref

High temperature mechanical properties of an aluminum alloy containing Zn and Mg

This paper studies the high temperature mechanical properties of as-cast Al–Zn–Mg using tensile and creep testing. Hot tensile tests were performed in the temperature and strain rate ranges of 350–400◦C and 10−5 to 10−3 s−1 respectively. Creep tests were carried out under constant load with initial stressn ranging from 5 to 22 MPa, at 350 and 400◦C. The alloy exhibits class A creep behavior, due to the viscous glide of dislocations. The tensile flow curves, corrected to account for the effect of sample elongation on strain rate, also show a decline in stress commonly observed in Al–Mg alloys. The highest ductilityand strain rate sensitivity were both observed for strain rates ranging from 10−5 to 10−4 s−1. Duringhot deformation the alloy exhibits cavitation which increases with temperature. The analysis of phenomena has shown that cavity growth is mainly controlled by plastic strain

Leo, P.

SPIGARELLI, Stefano

Cerri, E.

EL MEHTEDI, Mohamad

Archivio istituzionale della ricerca - Università di Cagliari

IRIS UniversitÃ  Politecnica delle Marche

CERRI, Emanuela

Archivio istituzionale della Ricerca -  Università degli Studi di Parma

https://scholarcommons.usf.edu/cgi/viewcontent.cgi?article=1004&amp;context=basgp_report

Draft Seagrass Bibliography Data Base

Abstract

Similar works

Full text

Available Versions

Scholar Commons | University of South Florida Research

Archivio Istituzionale della Ricerca- Università del Salento

Crossref

Archivio istituzionale della ricerca - Università di Cagliari

IRIS UniversitÃ Politecnica delle Marche

Archivio istituzionale della Ricerca - Università degli Studi di Parma