This study examined numericallythe Thermal-hydrodynamic properties of airflow in the fin-and-tube compact heat exchangers (FTCHEs) with considering different shapes of tubes in lowReynoldsnumbers. The influence of applying flat, oval and circular tube adjustments on the thermal and hydraulic characteristics of air flow were analyzed on the in-line tube arrangements. Establishing standard conditions, the study compared different geometries based on circular tubes of 10.459 mm diameter tubes with 25.4 mm longitudinal pitches and 25.4 mm transverse pitches. The other geometries of tubes were assumed in a stable and constant state preparing the same heat transfer surface area per unit volume as that of the nominal case. The results showed that the FTCHE with flat tubes gives the best area goodness factor (j/f) with in a certainrange of Reynoldsnumbers. In addition, FTCHE with flat tubes shown the best thermo-hydraulic performance and a significant augmentation of up to 10.83% and 35.63% in the average area goodness factor achieved accompanied by a decrease in the average friction factor of 17.02% and 43.41% in the flat tube case compared to the oval and circle tube shapes, respectively. It is concluded that the average area goodness factorfor the oval tube is about 25.04% higher than that of the circular tube, while the average friction factor for the oval tube is about 26.9% lower than that of the circular tube. This means that the flat tube has a better-combined thermal-hydraulic performance than the oval and circle tube