A horncore feature was encountered during excavations at Border Cave, in Member 2 BSL, dated 60–49 ka. The basal half of the horncore lay towards the centre of a combustion feature and was calcined. The tip half lay on a mat of burnt grass bedding towards the edge of the fireplace. It was covered with a black shiny residue, which was also present on nearby stone tools. The feature was jacketed and excavated later under a microscope in the laboratory. Raman spectroscopy identified the residue only as amorphous carbon, indicating the presence of a heated organic substance. Knowing that variation exists in modern and archaeological glue recipes, we wanted to know if the black residue was melted keratin, and if it was, whether it had been used as a substitute for beeswax or latex for hafting. We set out to test the hypothesis by conducting a heating experiment with a modern sheathed horncore. Experimental results showed that keratin does not transform into viable glue when heated. Instead, it reduces immediately to a glassy brittle residue. Our finding strongly supports a scenario of incidental deposition of residue on the archaeological stone tools. Previous combustion experiments have shown that the sediment below a fire can reach 300+ °C through vertical heat transfer. This implies that horn sheaths in archaeological deposits, separated from overlying combustion features by thousands of years, can transform into a black residue that may deposit on nearby stone and bone tools.Fil: Backwell, Lucinda Ruth. University of the Witwatersrand; Sudáfrica. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - Tucumán. Instituto Superior de Estudios Sociales. Universidad Nacional de Tucumán. Instituto Superior de Estudios Sociales; ArgentinaFil: Wojcieszak, Marine. University of the Witwatersrand; Sudáfrica. Royal Institute For Cultural Heritage; BélgicaFil: Wadley, Lyn. University of the Witwatersrand; Sudáfric