Green synthesis of vanillin: Pervaporation and dialysis for process intensification in a membrane reactor

In the present work, two different membrane processes (pervaporation and dialysis) are compared in view of their utilization in a membrane reactor, where vanillin, which is probably the most important aroma of the food industry, is synthesized in a green and sustainable way. The utilized precursor (ferulic acid, which is possibly a natural product from agricultural wastes) is partially oxidized (photocatalytically or biologically) and the product is continuously recovered from the reacting solution by the membrane process to avoid its degradation. It is observed that pervaporation is much more selective towards vanillin than dialysis, but the permeate flux of dialysis is much higher. Furthermore, dialysis can work also at lower temperatures and can be used to continuously restore the consumed substrate into the reacting mixture. A mathematical model of the integrated process (reaction combined with membrane separation) reproduces quite satisfactorily the experimental results and can be used for the analysis and the design of the process

Sequential biological and photocatalysis based treatments for shipboard slop purification: A pilot plant investigation

This study investigated the treatment of a shipboard slop containing commercial gasoline in a pilot plant scale consisting of a membrane biological reactor (MBR) and photocatalytic reactor (PCR) acting in series. The MBR contributed for approximately 70% to the overall slop purification. More precisely, the biological process was able to remove approximately 40%, on average, of the organic pollution in the slop. Nevertheless, the membrane was capable to retain a large amount of organic molecules within the system, amounting for a further 30% of the influent total organic content removal. However, this affected the membrane fouling, thus resulting in the increase of the pore blocking mechanism that accounted for approximately 20% to the total resistance to filtration (2.85∙10 13 m −1 ), even if a significant restoration of the original membrane permeability was obtained after chemical cleanings. On the other hand, the biological treatment produced a clear solution for the photocatalytic system, thereby optimizing the light penetration and generation of highly oxidizing active oxygen species that enabled the degradation of bio-recalcitrant compounds. Indeed, low total organic carbon (TOC) values (<10 mg L −1 ) were achieved in the output of the photocatalytic reactor by means of only 60 Einstein (E) of cumulative impinging energy after the addition of K 2 S 2 O 8 . Overall, coupling the two processes enabled very high TOC removal (ca. 95%)

Selective photocatalytic and photoelectrocatalytic synthesis of valuable compounds in aqueous medium

In the past decades, photocatalytic and photoelectrocatalytic methods have been widely employed for the degradation of harmful compounds present both is gaseous and aqueous effluents. In the last years scientists have paid great attention to the synthesis of valuable compounds and hydrogen production. Organic syntheses are generally carried out in organic solvents, under high temperature/pressure, with toxic oxidants such as permanganate. On the other hand, photocatalysis and photoelectrocatalysis using water as solvent, air or water as oxidant, and sunlight as energy source, can be an efficient alternative to the traditional, non-environmentally friendly methods. This review summarizes the photocatalytic and photoelectrocatalytic transformations of organic molecules to commercially valuable products in water, sometimes evaluating also the contemporary H2 production. The reaction conditions, mechanisms and kinetics are presented and discussed. Future perspectives are also given

Overview on oxidation mechanisms of organic compounds by TiO2 in heterogeneous photocatalysis

This review provides the reader with a general overview on heterogeneous photocatalytic oxidation mechanisms in the presence of TiO2, with a special address to conversion of aliphatic and aromatic organic species. The aim was to clarify the steps of the photo-oxidation of the various classes of compounds and to relate them with the properties of the catalysts and the experimental conditions used. Reactions carried out to perform complete degradation and photocatalytic partial oxidations have been deeply discussed. Recent isotopic studies highlighted new reaction pathways concerning partial oxidation of alcohols to aldehyde and oxidation of benzene while EPR investigations confirmed that not only the photogenerated hole but also the OH radicals are involved in the oxidation of the substrates

Review on Recent Advances in the Removal of Organic Drugs by Advanced Oxidation Processes

In recent years, due to the high consumption of drugs both for human needs and for their growing use, especially as regards antibiotics, in the diet of livestock, water pollution has reached very high levels and attracted widespread attention. Drugs have a stable chemical structure and are recalcitrant to many treatments, especially biological ones. Among the methods that have shown high efficiency are advanced oxidation processes (AOPs) which are, among other things, inexpensive and eco-friendly. AOPs are based on the production of reactive oxygen species (ROS) able to degrade organic pollutants in wastewater. The main problem related to the degradation of drugs is their partial oxidation to compounds that are often more harmful than their precursors. In this review, which is not intended to be exhaustive, we provide an overview of recent advances in the removal of organic drugs via advanced oxidation processes (AOPs). The salient points of each process, highlighting advantages and disadvantages, have been summarized. In particular, the use of AOPs such as UV, ozone, Fenton-based AOPs and heterogeneous photocatalysis in the removal of some of the most common drugs (tetracycline, ibuprofen, oxytetracycline, lincomycin) has been reported

Photocatalytic degradation of dyes by using a membrane reactor

Dyes are organic compounds used in textile, food and drug industries, and their abatement represents one of the main problems in the treatment processes because generally they are very stable toxic compounds. In this work, two commercial azo-dyes, i.e. Congo Red (C32H22N6Na2O6S2) and Patent Blue (C27H31N2NaO6S2), in aqueous solution were degraded in a photocatalytic membrane reactor by using TiO2 Degussa P25 as the catalyst. Different system con\ufb01gurations and irradiating sources were studied, and the in\ufb02uence of some operational parameters such as the pressure in the membrane cell and the initial concentration of the substrates was determined. A comparison between suspended and entrapped TiO2 was also done. The experimental results showed a satisfactory degradation ef\ufb01ciency of the photocatalytic membrane process. The in\ufb02uence of various parameters (e.g. feed concentration, recirculation rate) has been discussed to obtain high reaction rates, operating stability and high membrane rejection, both for substrates and by-products. Congo Red was photodegraded with higher rate under the same experimental conditions probably due to its higher adsorption onto the catalyst surface. It was possible to treat successfully highly concentrated solutions (500 mg/L) of both dyes by means of a continuous process obtaining good values of permeate \ufb02uxes (30\u201370 L/m2 h); this could be interesting for industrial applications. The reactor containing the suspended photocatalyst was signi\ufb01cantly more ef\ufb01cient than the reactor containing the catalyst entrapped into the membrane

Selective photooxidation of ortho-substituted benzyl alcohols and the catalytic role of ortho-methoxybenzaldehyde

It has been recently reported by Palmisano et al. (2015) [1] that the oxidation of 2-methoxybenzyl alcohol (2-MBA) to 2-methoxybenzaldehyde (2-MBAD) proceeds in water under near-UV light with an unexpected catalytic effect of 2-MBAD. In order to investigate the catalytic role of aldehyde in photolytic oxidation of ortho-substituted benzyl alcohols (OSBAs), reactivity runs were carried out with 2-methylbenzyl alcohol (2-MeBA), 2-nitrobenzyl alcohol (2-NBA), 2-hydroxybenzyl alcohol (2-HBA) and 2-chlorobenzyl alcohol (2-ClBA) in the absence and in the presence of their corresponding aldehyde. None of those alcohols showed a measurable oxidation rate even in the presence of their aldehydes but 2-NBA was oxidised very fast, although no corresponding carbonyl product was obtained. The possible catalytic role of 2-MBAD was investigated for the photolytic oxidation of 4-methoxybenzyl alcohol (4-MBA), 4-nitrobenzyl alcohol (4-NBA), 2-ClBA, 2-HBA, 2-MeBA and ferulic acid (FA). The results showed that 2-MBAD acts as a catalyst only for 4-MBA, 2-HBA and FA. The photocatalytic oxidation of OSBAs in the presence of powdered TiO2 has been also carried out in order to investigate the mutual influences, if any, between homogeneous and heterogeneous processes. The reactivity runs were carried out with TiO2 photocatalyst in water and under near-UV irradiation; a home-prepared (HP) TiO2 sample was used along with Degussa P25. HP catalyst showed the best performance: the 2-MBA half-life time was 5 times smaller and the selectivity to aldehyde 13 times higher than in the presence of Degussa P25

Enhancing H2 production rate in PGM-free photoelectrochemical cells by glycerol photo-oxidation

The photo-oxidation of glycerol was carried out by using TiO2 NTs photoanodes and Ni foam as the cathode for the Hydrogen Evolution Reaction. The photoanodes were prepared by anodizing Ti foils and titanium felt and then annealed under air exposure. They were tested in acidic aqueous solution without and with the addition of glycerol. When glycerol was present, the hydrogen production rate increased and allowed the simultaneous production of high value added partial oxidation compounds, i.e. 1,3-dihydroxyacetone (DHA), and glyceraldehyde (GA). The highest H2 evolution and partial oxidation compounds production rates were obtained by using home prepared TiO2 nanotubes (TiO2 NTs) synthesized on Ti fiber felt as the photoanode with an irradiated area of 90 cm2. These photoanodes were found to be highly stable both from a mechanical and a chemical point of view, so they can be reused after a simple cleaning step

Alcohol-Selective Oxidation in Water under Mild Conditions via a Novel Approach to Hybrid Composite Photocatalysts

The oxidation of alcohols to carbonyl compounds in a clean fashion (i.e., with water as a solvent or under solvent-free conditions, and using O2 or H2O2 as the primary oxidant) is the subject of considerable research efforts. A new approach for the selective oxidation of soluble aromatic alcohols in water under mild conditions via a novel composite photocatalyst has been developed. The catalyst is synthesized by grafting 4-(4-(4-hydroxyphenylimino)cyclohexa-2,5dienylideneamino)phenol and silver nanoparticles onto the surface of moderately crystalline titanium dioxide. The titanium dioxide-based composite was first extensively characterized and then employed in the catalytic oxidation of 4-methoxybenzyl alcohol to 4-methoxybenzaldehyde under UV irradiation in water at room temperature. The corresponding aldehyde was obtained with unprecedented high selectivity (up to 86 %). The method is general and opens the route to fabrication of photocatalytic composites based on titanium dioxide functionalized with shuttle organic molecules and metal nanoparticles for a variety of oxidative conversions

Selective aqueous oxidation of aromatic alcohols under solar light in the presence of TiO2 modified with different metal species

A set of metals modified TiO2 photocatalysts were prepared starting from titanium tetraisopropoxyde and different metal precursors to study the influence of the addition of the various foreign agents on the physico-chemical and photocatalytic properties of the catalysts. The powders were characterized by X-ray diffraction, Raman spectroscopy, specific surface area measurements, scanning electron microscopy, energy dispersive X-ray spectroscopy, UV–Vis diffuse reflectance spectroscopy, photoluminescence, temperature programmed desorption after CO2 adsorption. The photocatalytic activity was evaluated using as probe reactions the partial oxidation of three aromatic alcohols: benzyl alcohol (BA), 4-methoxy benzyl alcohol (4-MBA), and 4-hydroxy benzyl alcohol (4-HBA) under simulated solar light irradiation. Different oxidation and selectivity values were obtained for the three substrates depending not only on the type of metals but also on the nature and position of the substituent in the phenyl ring of benzyl alcohol. As a general behaviour, the doped samples allowed the achievement of a greater selectivity especially for 4-MBA even if sometimes with minor conversions. The presence of W or Nb was beneficial for both conversion and selectivity for all the substrates with respect to bare TiO2. Graphical abstract: [Figure not available: see fulltext.