Single-Crystal Organic Field Effect Transistors with the Hole Mobility ~ 8 cm2/Vs

We report on the fabrication and characterization of single-crystal organic p-type field-effect transistors (OFETs) with the field-effect hole mobility mu \~ 8 cm2/Vs, substantially higher than that observed in thin-film OFETs. The single-crystal devices compare favorably with thin-film OFETs not only in this respect: the mobility for the single-crystal devices is nearly independent of the gate voltage and the field effect onset is very sharp. Subthreshold slope as small as S = 0.85 V/decade has been observed for a gate insulator capacitance Ci = 2 +- 0.2 nF/cm2. This corresponds to the intrinsic subthreshold slope Si = SCi at least one order of magnitude smaller than that for the best thin-film OFETs and amorphous hydrogenated silicon (a-Si:H) devices

Basic Robotecnical Platform for Implementation of Accurate Farming Technologies

Improvement of modern technical systems and technologies. Increasing the productivity of modern agricultural machines with increasing their weight, which leads, in the course of their work, to a significant compaction of the soil. The heterogeneity of the soil, as a bearing surface, causes not adjustable fluctuations in the workplace, which makes automation of the application of robotics more difficult. Modern solutions to the problems of reducing the negative impact on the soil, increasing the permeability of aggregates due to the reconstruction of the propulsors do not give the proper effect. More cardinally solve these problems, as well as the ability to implement automation and robotics bridge systems such as ABAC, moving along rail tracks, AASP on vertical piles and point gravel-halide supports with concrete platforms. The most promising of these is the AAS platform, which is a 30x10 m bridge structure that moves by step-by-step extension, the beams onto 3 subsequent pads located 10 m away. After entering the new position of the bridge platform, along the long 30-meter span beams Moves the work-technological module with a set of working elements, performing the programmed operations. Thus, in the AASP bridge system under consideration, the soil area subjected to compaction at reference points is just over 1% of the 70% protraction of modern machines. Compared to the ABAC system, moving along railways, the equipment of point supports is much less expensive and requires insignificant operating costs. At the same time, the rigidity of AASP design ensures stable operation of technological mechanisms in a programmed robotic mode with a minimum of unproductive energy costs associated with movement

Heralded gate search with genetic algorithms for quantum computation

In this paper we present genetic algorithms based search technique for the linear optics schemes, performing two-qubit quantum gates. We successfully applied this technique for finding heralded two-qubit gates and obtained the new schemes with performance parameters equal to the best currently known. The new simple metrics is introduced which enables comparison of schemes with different heralding mechanisms. The scheme performance degradation is discussed for the cases when detectors in the heralding part of the scheme are not photon-number-resolving. We propose a procedure for overcoming this drawback which allows us to restore the reliable heralding signal even with not-photon-number-resolving detectors

Electronic Structure of Nitrogen- and Phosphorus-Doped Graphenes Grown by Chemical Vapor Deposition Method

Heteroatom doping is a widely used method for the modification of the electronic and chemical properties of graphene. A low-pressure chemical vapor deposition technique (CVD) is used here to grow pure, nitrogen-doped and phosphorous-doped few-layer graphene films from methane, acetonitrile and methane-phosphine mixture, respectively. The electronic structure of the films transferred onto SiO2/Si wafers by wet etching of copper substrates is studied by X-ray photoelectron spectroscopy (XPS) and near-edge X-ray absorption fine structure (NEXAFS) spectroscopy using a synchrotron radiation source. Annealing in an ultra-high vacuum at ca. 773 K allows for the removal of impurities formed on the surface of films during the synthesis and transfer procedure and changes the chemical state of nitrogen in nitrogen-doped graphene. Core level XPS spectra detect a low n-type doping of graphene film when nitrogen or phosphorous atoms are incorporated in the lattice. The electrical sheet resistance increases in the order: graphene < P-graphene < N-graphene. This tendency is related to the density of defects evaluated from the ratio of intensities of Raman peaks, valence band XPS and NEXAFS spectroscopy data. View Full-Tex

Self-activated ultrahigh chemosensitivity of oxide thin film nanostructures for transparent sensors

One of the top design priorities for semiconductor chemical sensors is developing simple, low-cost, sensitive and reliable sensors to be built in handheld devices. However, the need to implement heating elements in sensor devices, and the resulting high power consumption, remains a major obstacle for the realization of miniaturized and integrated chemoresistive thin film sensors based on metal oxides. Here we demonstrate structurally simple but extremely efficient all oxide chemoresistive sensors with similar to 90% transmittance at visible wavelengths. Highly effective self-activation in anisotropically self-assembled nanocolumnar tungsten oxide thin films on glass substrate with indium-tin oxide electrodes enables ultrahigh response to nitrogen dioxide and volatile organic compounds with detection limits down to parts per trillion levels and power consumption less than 0.2 microwatts. Beyond the sensing performance, high transparency at visible wavelengths creates opportunities for their use in transparent electronic circuitry and optoelectronic devices with avenues for further functional convergence.open181

Three-Dimensional Dynamical Instabilities in Galactic Ionization Fronts

Ionization front instabilities have long been of interest for their suspected role in a variety of phenomena in the galaxy, from the formation of bright rims and 'elephant trunks' in nebulae to triggered star formation in molecular clouds. Numerical treatments of these instabilities have historically been limited in both dimensionality and input physics, leaving important questions about their true evolution unanswered. We present the first three-dimensional radiation hydrodynamical calculations of both R-type and D-type ionization front instabilities in galactic environments (i.e., solar metallicity gas). Consistent with linear stability analyses of planar D-type fronts, our models exhibit many short-wavelength perturbations growing at early times that later evolve into fewer large-wavelength structures. The simulations demonstrate that both self-consistent radiative transfer and three-dimensional flow introduce significant morphological differences to unstable modes when compared to earlier two-dimensional approximate models. We find that the amplitude of the instabilities in the nonlinear regime is primarily determined by the efficiency of cooling within the shocked neutral shell. Strong radiative cooling leads to long, extended structures with pronounced clumping while weaker cooling leads to saturated modes that devolve into turbulent flows. These results suggest that expanding H II regions may either promote or provide turbulent support against the formation of later generations of stars, with potential consequences for star formation rates in the galaxy today.Comment: 16 pages, 9 figures, accepted to Ap

The UV Effect on the Chemiresistive Response of ZnO Nanostructures to Isopropanol and Benzene at PPM Concentrations in Mixture with Dry and Wet Air

Towards the development of low-power miniature gas detectors, there is a high interest in the research of light-activated metal oxide gas sensors capable to operate at room temperature (RT). Herein, we study ZnO nanostructures grown by the electrochemical deposition method over Si/SiO$_{2}$ substrates equipped by multiple Pt electrodes to serve as on-chip gas monitors and thoroughly estimate its chemiresistive performance upon exposing to two model VOCs, isopropanol and benzene, in a wide operating temperature range, from RT to 350 °C, and LED-powered UV illumination, 380 nm wavelength; the dry air and humid-enriched, 50 rel. %, air are employed as a background. We show that the UV activation allows one to get a distinctive chemiresistive signal of the ZnO sensor to isopropanol at RT regardless of the interfering presence of H$_{2}$O vapors. On the contrary, the benzene vapors do not react with UV-illuminated ZnO at RT under dry air while the humidity’s appearance gives an opportunity to detect this gas. Still, both VOCs are well detected by the ZnO sensor under heating at a 200–350 °C range independently on additional UV exciting. We employ quantum chemical calculations to explain the differences between these two VOCs’ interactions with ZnO surface by a remarkable distinction of the binding energies characterizing single molecules, which is −0.44 eV in the case of isopropanol and −3.67 eV in the case of benzene. The full covering of a ZnO supercell by H$_{2}$O molecules taken for the effect’s estimation shifts the binding energies to −0.50 eV and −0.72 eV, respectively. This theory insight supports the experimental observation that benzene could not react with ZnO surface at RT under employed LED UV without humidity’s presence, indifference to isopropanol

Changes in somatosensory evoked potentials in rats following transient cerebral ischemia

Background. Cerebral ischemia induced by transient middle cerebral artery occlusion is one of the most popular ischemic stroke models used to evaluate drug candidates with neuroprotective properties. The possibilities of combining this model with neurophysiological techniques (e.g., electroencephalography, electrocorticography, evoked potential registration, etc.) to assess the effectiveness of novel pharmacotherapeutic strategies appear to be of great interest to current biomedical research.The aim. Identifying specific changes in somatosensory evoked potentials occurring after cerebral ischemia induced by middle cerebral artery occlusion in rats.Materials and methods. A total number of 18 white outbred male rats were randomized into 3 groups by 6 animals in each: 1) control (presumably healthy animals); 2) ischemia-30 (30-minute middle cerebral artery occlusion); 3) ischemia-45 (45-minute occlusion). At post-surgery day 7, cortical responses to sequential electrical stimulation of left and right n. ischiadicus were registered. N1, P2, N2, P3, and N3 peak latencies and amplitudes, peak-to-peak interval durations and amplitudes were calculated. Spearman’s rank correlation coefficients were used to assess the relationship between ischemia duration and evoked potential parameters, and the Chaddock scale was used to qualitatively evaluate the strength of correlations.Results. The rats subjected to cerebral ischemia demonstrated a decrease in some of the peak amplitudes of the ipsi- and contralateral somatosensory potentials evoked by n. ischiadicus stimulation. In the injured hemisphere, decreased P2 and N3 peak and P3–N3 interval amplitudes were registered ipsilaterally, and decreased P3 peak amplitudes and N2–P3 interval durations were observed contralaterally.Conclusions. The obtained data suggest that somatosensory evoked potential registration and analysis can be used to evaluate the functional state of central nerve tracts in rats subjected to cerebral ischemia

2D Molybdenum Carbide MXenes for Enhanced Selective Detection of Humidity in Air

2D transition metal carbides and nitrides (MXenes) open up novel opportunities in gas sensing with high sensitivity at room temperature. Herein, 2D Mo2CTx flakes with high aspect ratio are successfully synthesized. The chemiresistive effect in a sub-mu m MXene multilayer for different organic vapors and humidity at 10(1)-10(4) ppm in dry air is studied. Reasonably, the low-noise resistance signal allows the detection of H2O down to 10 ppm. Moreover, humidity suppresses the response of Mo2CTx to organic analytes due to the blocking of adsorption active sites. By measuring the impedance of MXene layers as a function of ac frequency in the 10(-2)-10(6) Hz range, it is shown that operation principle of the sensor is dominated by resistance change rather than capacitance variations. The sensor transfer function allows to conclude that the Mo2CTx chemiresistance is mainly originating from electron transport through interflake potential barriers with heights up to 0.2 eV. Density functional theory calculations, elucidating the Mo2C surface interaction with organic analytes and H2O, explain the experimental data as an energy shift of the density of states under the analyte's adsorption which induces increasing electrical resistance