754 research outputs found

    Nonclassicality of photon-added squeezed vacuum and its decoherence in thermal environment

    Full text link
    We study the nonclassicality of photon-added squeezed vacuum (PASV) and its decoherence in thermal environment in terms of the sub-Poissonian statistics and the negativity of Wigner function (WF). By converting the PASV to a squeezed Hermite polynomial excitation state, we derive a compact expression for the normalization factor of m-PASV, which is an m-order Legendre polynomial of squeezing parameter r. We also derive the explicit expression of WF of m-PASV and find the negative region of WF in phase space. We show that there is an upper bound value of r for this state to exhibit sub-Poissonian statistics increasing as m increases. Then we derive the explicit analytical expression of time evolution of WF of m-PASV in the thermal channel and discuss the loss of nonclassicality using the negativity of WF. The threshold value of decay time is presented for the single PASV.Comment: 14 pages and 7 figure

    Searching for Exoplanets Using a Microresonator Astrocomb

    Get PDF
    Detection of weak radial velocity shifts of host stars induced by orbiting planets is an important technique for discovering and characterizing planets beyond our solar system. Optical frequency combs enable calibration of stellar radial velocity shifts at levels required for detection of Earth analogs. A new chip-based device, the Kerr soliton microcomb, has properties ideal for ubiquitous application outside the lab and even in future space-borne instruments. Moreover, microcomb spectra are ideally suited for astronomical spectrograph calibration and eliminate filtering steps required by conventional mode-locked-laser frequency combs. Here, for the calibration of astronomical spectrographs, we demonstrate an atomic/molecular line-referenced, near-infrared soliton microcomb. Efforts to search for the known exoplanet HD 187123b were conducted at the Keck-II telescope as a first in-the-field demonstration of microcombs

    Iron content in forage sorghum (Sorghum bicolor (L.) Moench) measured on different slit widths with atomic absorption spectrometry

    Get PDF
    Our objective was to know the right slit width for iron (Fe) concentration of forage sorghum, sorghum hybrid (Sorghum bicolor (L.) Moench), and also to discern which water treatment sludge (WTS) were good for ruminant's health with the feeding sorghum on the present study. The present experiment was carried out on a randomized block design with four treatments; Control, alum sludge compost, alum sludge + NPK (nitrogen, phosphorus, potassium fertilizers), alum sludge compost + NPK (nitrogen, phosphorus, potassium fertilizers). Sorghum hybrid was harvested, and iron content of it was analyzed with an atomic absorption spectrophotometer on background correction (BGC) mode. In order to analyze the iron (Fe) content of the sorghum with the spectrophotometer, three different slit widths conditions were used; 0.15, 0.20 and 0.25 nm. Absorbance and background values were obtained during the Fe analyses with the apparatus. When the background value is small, it is preferred for some trace metals’ analyses. Both (AM/BS) ratio (mean of the absorbance values<AM> to the standard deviation of back ground values<BS>) and (AS<standard deviation of the absorbance values>/BS) ratio, were larger on 0.25 nm slit than those on 0.15 and 0.20 nm slit, and, from our experiment, the condition seemed better on the 0.25 nm slit for the iron analysis with the spectrophotometer. Therefore, the sorghum hybrid grown on (Alum+NPK) and on (Compost only) might be dangerous for ruminants because of their higher values than 200 mg Fe/kg DM (dry matter).Key words: Absorbance, alum sludge, atomic absorption spectrophotometer, background, forage sorghum hybrid, iron, slit

    An Integrated-Photonics Optical-Frequency Synthesizer

    Full text link
    Integrated-photonics microchips now enable a range of advanced functionalities for high-coherence applications such as data transmission, highly optimized physical sensors, and harnessing quantum states, but with cost, efficiency, and portability much beyond tabletop experiments. Through high-volume semiconductor processing built around advanced materials there exists an opportunity for integrated devices to impact applications cutting across disciplines of basic science and technology. Here we show how to synthesize the absolute frequency of a lightwave signal, using integrated photonics to implement lasers, system interconnects, and nonlinear frequency comb generation. The laser frequency output of our synthesizer is programmed by a microwave clock across 4 THz near 1550 nm with 1 Hz resolution and traceability to the SI second. This is accomplished with a heterogeneously integrated III/V-Si tunable laser, which is guided by dual dissipative-Kerr-soliton frequency combs fabricated on silicon chips. Through out-of-loop measurements of the phase-coherent, microwave-to-optical link, we verify that the fractional-frequency instability of the integrated photonics synthesizer matches the 7.010137.0*10^{-13} reference-clock instability for a 1 second acquisition, and constrain any synthesis error to 7.710157.7*10^{-15} while stepping the synthesizer across the telecommunication C band. Any application of an optical frequency source would be enabled by the precision optical synthesis presented here. Building on the ubiquitous capability in the microwave domain, our results demonstrate a first path to synthesis with integrated photonics, leveraging low-cost, low-power, and compact features that will be critical for its widespread use.Comment: 10 pages, 6 figure

    Effects of Four Host Plants on Biology and Food Utilization of the Cutworm, Spodoptera litura

    Get PDF
    Effects of four host plants, tobacco, Chinese cabbage, cowpea and sweet potato, on larval and pupal development and survival, and longevity and fecundity of adults of Spodoptera litura (F) (Lepidoptera: Noctuidae), were studied under laboratory conditions (26° C, 60–80% RH), as was the utilization of the four host plants and adaptation on tobacco. All of the biological parameters included in the study were affected by the host plants. In a choice test, S. litura females oviposited most on Chinese cabbage, least on tobacco, and intermediate on cowpea and sweet potato. S. litura larvae developed differently on the four host plants, from shortest to longest in the following order: Chinese cabbage, cowpea, sweet potato, and tobacco. Pupal development was shorter on cowpea than on the other three host plants, and males generally developed longer than females. More females than males were found among emerged adults, and male adults lived 1–2 d longer than females. Larvae survived best on cowpea (81.6%), followed by Chinese cabbage (75.5%), then sweet potato (66.1%), and worst on tobacco (49.2%). Pupal survival rates were relatively high (91.4 – 95.9%) in all four host plant treatments, although that on sweet potato was lower than those on the other three host plants. Pupal weights on tobacco and sweet potato were similar, but both were lower than those on Chinese cabbage and cowpea. Generally, male pupae weighed less than female pupae. Numbers of eggs oviposited by female S. litura were highest on sweet potato, followed by those on cowpea, Chinese cabbage, and lowest on tobacco. Relative food consumption rate was highest on sweet potato, followed by that on cowpea, Chinese cabbage, and lowest on tobacco. In contrast, S. litura larvae that fed on tobacco had higher efficiency of conversion of digested food, highest efficiency of conversion of ingested food, and lowest approximate digestibility as compared with larvae that fed on other host plants. The potential causes for S. litura outbreaks on tobacco are discussed

    Bridging ultrahigh-Q devices and photonic circuits

    Get PDF
    Optical microresonators are essential to a broad range of technologies and scientific disciplines. However, many of their applications rely on discrete devices to attain challenging combinations of ultra-low-loss performance (ultrahigh Q) and resonator design requirements. This prevents access to scalable fabrication methods for photonic integration and lithographic feature control. Indeed, finding a microfabrication bridge that connects ultrahigh-Q device functions with photonic circuits is a priority of the microcavity field. Here, an integrated resonator having a record Q factor over 200 million is presented. Its ultra-low-loss and flexible cavity design brings performance to integrated systems that has been the exclusive domain of discrete silica and crystalline microcavity devices. Two distinctly different devices are demonstrated: soliton sources with electronic repetition rates and high-coherence/low-threshold Brillouin lasers. This multi-device capability and performance from a single integrated cavity platform represents a critical advance for future photonic circuits and systems

    Do agreements between adolescent and parent reports on family socioeconomic status vary with household financial stress?

    Get PDF
    <p>Abstract</p> <p>Background</p> <p>Many studies compared the degree of concordance between adolescents' and parents' reports on family socioeconomic status (SES). However, none of these studies analyzed whether the degree of concordance varies by different levels of household financial stress. This research examines whether the degree of concordance between adolescents' and parent reports for the three traditional SES measures (parental education, parental occupation and household income) varied with parent-reported household financial stress and relative standard of living.</p> <p>Methods</p> <p>2,593 adolescents with a mean age of 13 years, and one of their corresponding parents from the Taiwan Longitudinal Youth Project conducted in 2000 were analyzed. Consistency of adolescents' and parents' reports on parental educational attainment, parental occupation and household income were examined by parent-reported household financial stress and relative standard of living.</p> <p>Results</p> <p>Parent-reported SES variables are closely associated with family financial stress. For all levels of household financial stress, the degree of concordance between adolescent's and parent's reports are highest for parental education (κ ranging from 0.87 to 0.71) followed by parental occupation (κ ranging from 0.50 to 0.34) and household income (κ ranging from 0.43 to 0.31). Concordance for father's education and parental occupation decreases with higher parent-reported financial stress. This phenomenon was less significant for parent-reported relative standard of living.</p> <p>Conclusions</p> <p>Though the agreement between adolescents' and parents' reports on the three SES measures is generally judged to be good in most cases, using adolescents reports for family SES may still be biased if analysis is not stratified by family financial stress.</p

    Data-precoded algorithm for multiple-relay-assisted systems

    Get PDF
    A data-precoded relay-assisted (RA) scheme is proposed for a system cooperating with multiple relay nodes (RNs), each equipped with either a single-antenna or a two-antenna array. The classical RA systems using distributed space-time/frequency coding algorithms, because of the half-duplex constraint at the relays, require the use of a higher order constellation than in the case of a continuous link transmission from the base station to the user terminal. This implies a penalty in the power efficiency. The proposed precoding algorithm exploits the relation between QPSK and 4 L -QAM, by alternately transmitting through L relays, achieving full diversity, while significantly reducing power penalty. This algorithm explores the situations where a direct path (DP) is not available or has poor quality, and it is a promising solution to extend coverage or increase system capacity. We present the analytical derivation of the gain obtained with the data-precoded algorithm in comparison with distributed space-frequency block code (SFBC) ones. Furthermore, analysis of the pairwise error probability of the proposed algorithm is derived and confirmed with numerical results. We evaluate the performance of the proposed scheme and compare it relatively to the equivalent distributed SFBC scheme employing 16-QAM and non-cooperative schemes, for several link quality scenarios and scheme configurations, highlighting the advantages of the proposed scheme

    Vacancy-Mediated Magnetism in Pure Copper Oxide Nanoparticles

    Get PDF
    Room temperature ferromagnetism (RTF) is observed in pure copper oxide (CuO) nanoparticles which were prepared by precipitation method with the post-annealing in air without any ferromagnetic dopant. X-ray photoelectron spectroscopy (XPS) result indicates that the mixture valence states of Cu1+ and Cu2+ ions exist at the surface of the particles. Vacuum annealing enhances the ferromagnetism (FM) of CuO nanoparticles, while oxygen atmosphere annealing reduces it. The origin of FM is suggested to the oxygen vacancies at the surface/or interface of the particles. Such a ferromagnet without the presence of any transition metal could be a very good option for a class of spintronics
    corecore