Association Between Air Pollution and Low Birth Weight: A Community-Based Study

The relationship between maternal exposure to air pollution during periods of pregnancy (entire and specific periods) and birth weight was investigated in a well-defined cohort. Between 1988 and 1991, all pregnant women living in four residential areas of Beijing were registered and followed from early pregnancy until delivery. Information on individual mothers and infants was collected. Daily air pollution data were obtained independently. The sample for analysis included 74,671 first-parity live births were gestational age 37-44 weeks. Multiple linear regression and logistic regression were used to estimate the effects of air pollution on birth weight and low birth weight (< 2,500 g), adjusting for gestational age, residence, year of birth, maternal age, and infant gender. There was a significant exposure-response relationship between maternal exposures to sulfur dioxide (SO2) and total suspended particles (TSP) during the third trimester of pregnancy and infant birth weight. The adjusted odds ratio for low birth weight was 1.11 (95% CI, 1.06-1.16) for each 100 micrograms/m3 increase in SO2 and 1.10 (95% CI, 1.05-1.14) for each 100 micrograms/m3 increase in TSP. The estimated reduction in birth weight was 7.3 g and 6.9 g for each 100 micrograms/m3 increase in SO2 and in TSP, respectively. The birth weight distribution of the high-exposure group was more skewed toward the left tail (i.e., with higher proportion of births < 2,500 g) than that of the low-exposure group. Although the effects of other unmeasured risk factors cannot be excluded with certainty, our data suggests that TSP and SO2, or a more complex pollution mixture associated with these pollutants, contribute to an excess risk of low birth weight in the Beijing population.National Institute of Environmental Health Sciences (ES05947, ES08337); National Institute of Child Health & Human Development (R01 HD32505); Department of Health and Human Services (MCJ-259501, HRSA 5 T32 PE10014

Anomalous Tail Effect on Resistivity Transition and Weak-link Behavior of Iron Based Superconductor

Temperature dependent resistivity of the iron-based superconductor NdFeAsO0.88F0.12 was measured under different applied fields and excitation currents. Arrhenius plot shows an anomalous tail effect, which contains obvious two resistivity dropping stages. The first is caused by the normal superconducting transition, and the second is supposed to be related to the weak-link between the grains. A model for the resistivity dropping related to the weak-link behavior is proposed, which is based on the Josephson junctions formed by the impurities in grain boundaries like FeAs, Sm2O3 and cracks together with the adjacent grains. These Josephson junctions can be easily broken by the applied fields and the excitations currents, leading to the anomalous resistivity tail in many polycrystalline iron-based superconductors. The calculated resistivity dropping agrees well with the experimental data, which manifests the correctness of the explanation of the obtained anomalous tail effect.Comment: 9 pages, 4 figure

Modeling Magnetic Field Structure of a Solar Active Region Corona using Nonlinear Force-Free Fields in Spherical Geometry

We test a nonlinear force-free field (NLFFF) optimization code in spherical geometry using an analytical solution from Low and Lou. Several tests are run, ranging from idealized cases where exact vector field data are provided on all boundaries, to cases where noisy vector data are provided on only the lower boundary (approximating the solar problem). Analytical tests also show that the NLFFF code in the spherical geometry performs better than that in the Cartesian one when the field of view of the bottom boundary is large, say, $20^\circ \times 20^\circ$. Additionally, We apply the NLFFF model to an active region observed by the Helioseismic and Magnetic Imager (HMI) on board the Solar Dynamics Observatory (SDO) both before and after an M8.7 flare. For each observation time, we initialize the models using potential field source surface (PFSS) extrapolations based on either a synoptic chart or a flux-dispersal model, and compare the resulting NLFFF models. The results show that NLFFF extrapolations using the flux-dispersal model as the boundary condition have slightly lower, therefore better, force-free and divergence-free metrics, and contain larger free magnetic energy. By comparing the extrapolated magnetic field lines with the extreme ultraviolet (EUV) observations by the Atmospheric Imaging Assembly (AIA) on board SDO, we find that the NLFFF performs better than the PFSS not only for the core field of the flare productive region, but also for large EUV loops higher than 50 Mm.Comment: 34 pages, 8 figures, accepted for publication in Ap

Fire responses and resistance of concrete-filled steel tubular frame structures

This paper presents the results of dynamic responses and fire resistance of concretefilled steel tubular (CFST) frame structures in fire conditions by using non-linear finite element method. Both strength and stability criteria are considered in the collapse analysis. The frame structures are constructed with circular CFST columns and steel beams of I-sections. In order to validate the finite element solutions, the numerical results are compared with those from a fire resistance test on CFST columns. The finite element model is then adopted to simulate the behaviour of frame structures in fire. The structural responses of the frames, including critical temperature and fire-resisting limit time, are obtained for the ISO-834 standard fire. Parametric studies are carried out to show their influence on the load capacity of the frame structures in fire. Suggestions and recommendations are presented for possible adoption in future construction and design of these structures