653 research outputs found

    CO2 Conversion in Nonuniform Discharges: Disentangling Dissociation and Recombination Mechanisms

    Get PDF
    Motivated by environmental applications such as synthetic fuel synthesis, plasma-driven conversion shows promise for efficient and scalable gas conversion of CO2 to CO. Both discharge contraction and turbulent transport have a significant impact on the plasma processing conditions, but are, nevertheless, poorly understood. This work combines experiments and modeling to investigate how these aspects influence the CO production and destruction mechanisms in the vortex-stabilized CO2 microwave plasma reactor. For this, a two-dimensional axisymmetric tubular chemical kinetics model of the reactor is developed, with careful consideration of the nonuniform nature of the plasma and the vortex-induced radial turbulent transport. Energy efficiency and conversion of the dissociation process show a good agreement with the numerical results over a broad pressure range from 80 to 600 mbar. The occurrence of an energy efficiency peak between 100 and 200 mbar is associated with a discharge mode transition. The net CO production rate is inhibited at low pressure by the plasma temperature, whereas recombination of CO to CO2 dominates at high pressure. Turbulence-induced cooling and dilution of plasma products limit the extent of the latter. The maxima in energy efficiency observed experimentally around 40% are related to limits imposed by production and recombination processes. Based on these insights, feasible approaches for optimization of the plasma dissociation process are discussed.</p

    Insight into contraction dynamics of microwave plasmas for CO2 conversion from plasma chemistry modelling

    Get PDF
    This work addresses plasma chemistry in the core of a vortex-stabilized microwave discharge for CO2 conversion numerically, focusing on the pressure-dependent contraction dynamics of this plasma. A zero-dimensional model is presented for experimental conditions in a pressure range between 60 and 300 mbar and a temperature range between 3000 and 6500 K. Monte Carlo Flux simulations, which describe electron kinetics, are self-consistently coupled to the plasma chemistry model. The simulation results show that an increase in pressure is accompanied by a transition in neutral composition in the plasma core: from a significant amount of CO2 and O2 at low pressures to a O/CO/C mixture at high pressures, the composition being determined mostly by thermal equilibrium and by transport processes. The change of temperature and composition with pressure lead to higher ionisation coefficient and more atomic ion composition in the plasma core. These changes result in an increase in ionisation degree in the plasma core from 10-5 to 10-4. These factors are shown to be fundamental to drive contraction in the CO2 microwave discharge.</p

    Characterization of the CO2 microwave plasma based on the phenomenon of skin-depth-limited contraction

    Get PDF
    The subatmospheric CO2 microwave plasma is known to contract to a narrow filament with rising pressure as result of a mode transition. This changing state of contraction is investigated in relation to its dielectric properties, in order to directly relate the discharge parameters to the discharge radius. The electron density and gas temperature are measured, respectively, by 168 GHz microwave interferometry and Doppler broadening of the 777 nm oxygen emission lines. The plasma is operated in steady state with 1400 W at 2.45 GHz, between 100 mbar and 400 mbar. Electron density values in the central region range from 1018 to 1020 m−3 between the discharge modes, while the gas temperature increases from 3000 K to 6500 K, in good agreement with previously reported values. Based on the dielectric properties of the discharge in relation to the plasma radius, it is found that the discharge column constitutes a radius of a single skin depth. Implications of these insights on the conditions of previously reported CO2 dissociation experiments are discussed.</p

    Numerical model for the determination of the reduced electric field in a CO2 microwave plasma derived by the principle of impedance matching

    Get PDF
    Three dimensional electromagnetic modelling of a free-standing CO2 microwave plasma has been performed, by describing the plasma as a dielectric medium. The relative permittivity and conductivity of the medium are parametrised. The waveguide geometry from experiment, including the tuner, is put into the model, knowing that this corresponds to maximum power transfer of the microwave generator to the plasma under plasma impedance matching conditions. Two CO2 plasma discharge regimes, differing mainly in pressure, input power and temperature, have been studied. The model\u27s validity has been checked through study of materials of known conductivity. From measurements of the neutral gas temperature and the plasma electron density profile, the reduced electric field is determined. From the parametrisation of the dielectric properties, a range for the effective electron-neutral collision frequency for momentum transfer is estimated. The results for the reduced electric field and the range of the electron neutral collision frequency obtained, are consistent as verified by simulations using BOLSIG+. In addition, from this comparison it is possible to narrow down the range of the collision frequencies, and to estimate the electron temperature. The reduced electric field lies between 80 and 180 Td for the relatively low pressure, low input power, the so-called \u27diffuse\u27 regime. For the relatively high pressure, high input power (\u27contracted\u27) regime it lies between 10 and 60 Td. The normalised collision frequency lies between 1.6 and 2.3 for the diffuse regime, while for the contracted regime it lies between 2 and 3. The electron temperature ranges from 2 to 3 eV for the diffuse regime, and from 0.5 to 1 eV for the contracted regime. Related content: 10.1088/1361-6595/ab1ca1</p

    Efficient reabsorption of transintestinally excreted cholesterol is a strong determinant for cholesterol disposal in mice[S]

    Get PDF
    Transintestinal cholesterol excretion (TICE) is a major route for eliminating cholesterol from the body and a potential therapeutic target for hypercholesterolemia. The underlying mechanism, however, is largely unclear, and its contribution to cholesterol disposal from the body is obscured by the counteracting process of intestinal cholesterol reabsorption. To determine the quantity of TICE independent from its reabsorption, we studied two models of decreased intestinal cholesterol absorption. Cholesterol absorption was inhibited either by ezetimibe or, indirectly, by the genetic inactivation of the intestinal apical sodium-dependent bile acid transporter (ASBT; SLC10A2). Both ezetimibe treatment and Asbt inactivation virtually abrogated fractional cholesterol absorption (from 46% to 4% and 6%, respectively). In both models, fecal neutral sterol excretion and net intestinal cholesterol balance were considerably higher than in control mice (5- and 7-fold, respectively), suggesting that, under physiological conditions, TICE is largely reabsorbed. In addition, the net intestinal cholesterol balance was increased to a similar extent but was not further increased when the models were combined, suggesting that the effect on cholesterol reabsorption was already maximal under either condition alone. On the basis of these findings, we hypothesize that the inhibition of cholesterol (re)absorption combined with stimulating TICE will be most effective in increasing cholesterol disposal

    Coronary calcium mass scores measured by identical 64-slice MDCT scanners are comparable: a cardiac phantom study

    Get PDF
    To assess whether absolute mass scores are comparable or differ between identical 64-slice MDCT scanners of the same manufacturer and to compare absolute mass scores to the physical mass and between scan modes using a calcified phantom. A non-moving anthropomorphic phantom with nine calcifications of three sizes and three densities was scanned 30 times on three 64-slice MDCT scanners of manufacturer A and on three 64-slice MDCT scanners of manufacturer B in both sequential and spiral scan mode. The mean mass scores and mass score variabilities of seven calcifications were determined for all scanners; two non-detectable calcifications were omitted. It was analyzed whether identical scanners yielded similar or significantly different mass scores. Furthermore mass scores were compared to the physical mass and mass scores were compared between scan modes. The mass score calibration factor was determined for all scanners. Mass scores obtained on identical scanners were similar for almost all calcifications. Overall, mass score differences between the scanners were small ranging from 1.5 to 3.4% for the total mass scores, and most differences between scanners were observed for high density calcifications. Mass scores were significantly different from the physical mass for almost all calcifications and all scanners. In sequential mode the total physical mass (167.8 mg) was significantly overestimated (+2.3%) for 4 out of 6 scanners. In spiral mode a significant overestimation (+2.5%) was found for system B and a significant underestimation (−1.8%) for two scanners of system A. Mass scores were dependent on the scan mode, for manufacturer A scores were higher in sequential mode and for manufacturer B in spiral mode. For system A using spiral scan mode no differences were found between identical scanners, whereas a few differences were found using sequential mode. For system B the scan mode did not affect the number of different mass scores between identical scanners. Mass scores obtained in the same scan mode are comparable between identical 64-slice CT scanners and identical 64-slice CT scanners on different sites can be used in follow-up studies. Furthermore, for all systems significant differences were found between mass scores and the physical calcium mass; however, the differences were relatively small and consistent

    Activity of high-dose epirubicin combined with gemcitabine in advanced non-small-cell lung cancer: a multicenter phase I and II study

    Get PDF
    The aim of the study was to evaluate efficacy and tolerance of epirubicin and gemcitabine as first-line chemotherapy in patients with advanced non-small-cell lung cancer. A phase I study was performed with the combination of escalating doses of epirubicin intravenously on day 1 and a fixed dose of gemcitabine on days 1 and 8 of a 21-day cycle. Eighteen patients were included in the phase I part of the study before the maximum tolerated dose was found. Dose-limiting toxicity was febrile neutropenia. The phase II part of the study was continued with epirubicin 100 mg m−2on day 1 and gemcitabine 1125 mg m−2on days 1 and 8 of a 21-day cycle. Forty-three chemotherapy-naive patients were included. The median age of the patients was 60 years (range 26–75). Most patients (74%) were in stage IV. Granulocytopenia CTC grade 4 occurred in 32.5% and thrombocytopenia grade 4 in 11.6% of cycles. Febrile neutropenia occurred in six patients. Non-haematological toxicity was mainly mucositis CTC grade 2 and 3 in 35% of patients. The tumour response rate was 49% (95% confidence interval (CI) 35–63%). The median survival time for the patients was 42 weeks (95% CI 13–69). © 2000 Cancer Research Campaig

    First-line gemcitabine with cisplatin or epirubicin in advanced non-small-cell lung cancer: a phase III trial

    Get PDF
    The purpose of our study was to compare progression-free survival and quality of life (QOL) after cisplatin-gemcitabine (CG) or epirubicin-gemcitabine (EG) in chemotherapy-naive patients with unresectable non-small-cell lung cancer. Patients (n = 240) were randomised to receive gemcitabine 1125 mg m(-2) (days 1 and 8) plus either cisplatin 80 mg m(-2) (day 2) or epirubicin 100 mg m(-2) (day 1) every 3 weeks for a maximum of five cycles. Eligible patients had normal organ functions and Eastern Cooperative Oncology Group performance status less than or equal to2. QOL was measured with European Organisation for Research and Treatment of Cancer QLQ-C30 and LC13 questionnaires. There were no significant differences in median progression-free survival (CG 26 weeks, EG 23 weeks), median overall survival (CG 43 weeks, EG 36 weeks), or tumour response rates (CG 46%, EG 36%). Toxicity was mainly haematologic. In the EG arm granulocytopenia occurred more frequently, leading to more febrile neutropenia. Also, elevation of serum transaminases, mucositis, fever, and decline in LVEF were more common in the EG arm. In the CG arm, more patients experienced elevated serum creatinine levels, sensory neuropathy, nausea, and vomiting. Global QOL was not different in both arms. Progression-free survival, overall survival, response rate, and QOL were not different between both arms; however, overall toxicity was more severe in the EG arm
    corecore