279 research outputs found
Acceptance corrections to net baryon and net charge cumulants
We show that the effect of finite acceptance drastically influences the
net-baryon and net-charge cumulants, which are believed to be sensitive probes
of the QCD phase diagram. We derive the general formulae that relate the true
cumulants K_{n} which reflect the full dynamics of the system with the actually
measured cumulants c_{n} for a given acceptance, modeled by a binomial
probability parameter p. We find that this relation involves additional moments
which cannot be expressed by cumulants and should be measured in order to
extract any potential information about the QCD critical point. We demonstrate
that for a wide range of the true cumulant ratios K_{n}/K_{m} the measured
ratios c_{n}/c_{m} quickly converge if p < 1/2, which makes the interpretation
of the data very challenging, especially in case of the net-proton cumulants.
Our study further suggests that the measurement of net-charge cumulants may be
more advantageous for the investigation of the QCD phase diagram.Comment: 10 pages, 4 figures, added comments and references, to be published
in Phys. Rev.
Culture’s consequences for purchasing:comparing purchasing job ad requirements from different European countries with cultural models
Constraints on hadron resonance gas interactions via first-principles Lattice QCD susceptibilities
We investigate extensions of the Hadron Resonance Gas (HRG) Model beyond the
ideal case by incorporating both attractive and repulsive interactions into the
model. When considering additional states exceeding those measured with high
confidence by the Particle Data Group, attractive corrections to the overall
pressure in the HRG model are imposed. On the other hand, we also apply
excluded-volume corrections, which ensure there is no overlap of baryons by
turning on repulsive (anti)baryon-(anti)baryon interactions. We emphasize the
complementary nature of these two extensions and identify combinations of
conserved charge susceptibilities that allow us to constrain them separately.
In particular, we find interesting ratios of susceptibilities that are
sensitive to one correction and not the other. This allows us to constrain the
excluded volume and particle spectrum effects separately. Analysis of the
available lattice results suggests the presence of both the extra states in the
baryon-strangeness sector and the repulsive baryonic interaction, with
indications that hyperons have a smaller repulsive core than non-strange
baryons. We note that these results are interesting for heavy-ion-collision
systems at both the LHC and RHIC.Comment: Contribution to the 20th International Conference on Strangeness in
Quark Matter (SQM2022
On the temperature dependence of correlation functions in the space like direction in hot QCD
We study the temperature dependence of quark antiquark correlations in the
space like direction. In particular, we predict the temperature dependence of
space like Bethe-Salpeter amplitudes using recent Lattice gauge data for the
space like string potential. We also investigate the effect of the space like
string potential on the screening mass and discuss possible corrections which
may arise when working with point sources.Comment: 15 pages 8 figures (not included, will be sent on request),
(SUNY-NTG-94-3
FeetBack – Redirecting touch sensation from a prosthetic hand to the human foot
Introduction: Adding sensory feedback to myoelectric prosthetic hands was shown to enhance the user experience in terms of controllability and device embodiment. Often this is realized non-invasively by adding devices, such as actuators or electrodes, within the prosthetic shaft to deliver the desired feedback. However, adding a feedback system in the socket adds more weight, steals valuable space, and may interfere with myoelectric signals. To circumvent said drawbacks we tested for the first time if force feedback from
a prosthetic hand could be redirected to another similarly sensitive part of the
body: the foot.
Methods: We developed a vibrotactile insole that vibrates depending on the sensed force on the prosthetic fingers. This self-controlled clinical pilot trial included four experienced users of myoelectric prostheses. The participants solved two types of tasks with the artificial hands: 1) sorting objects depending on their plasticity with the feedback insole but without audio-visual feedback, and 2) manipulating fragile, heavy, and delicate objects with and without the feedback insole. The sorting task was evaluated with Goodman-Kruskal’s gamma for ranked correlation. The manipulation tasks were assessed by the
success rate.
Results: The results from the sorting task with vibrotactile feedback showed a substantial positive effect. The success rates for manipulation tasks with fragile and heavy objects were high under both conditions (feedback on or off, respectively). The manipulation task with delicate objects revealed inferior success with feedback in three of four participants.
Conclusion: We introduced a novel approach to touch sensation in myoelectric prostheses. The results for the sorting task and the manipulation tasks diverged. This is likely linked to the availability of various feedback sources. Our results for redirected feedback to the feet fall in line with previous similar studies that applied feedback to the residual arm
Minimal Required Resolution to Capture the 3D Shape of the Human Back: A Practical Approach
Adolescent idiopathic scoliosis (AIS) is a prevalent musculoskeletal disorder that causes abnormal spinal deformities. The early screening of children and adolescents is crucial to identify and prevent the further progression of AIS. In clinical examinations, scoliometers are often used to noninvasively estimate the primary Cobb angle, and optical 3D scanning systems have also emerged as alternative noninvasive approaches for this purpose. The recent advances in low-cost 3D scanners have led to their use in several studies to estimate the primary Cobb angle or even internal spinal alignment. However, none of these studies demonstrate whether such a low-cost scanner satisfies the minimal requirements for capturing the relevant deformities of the human back. To practically quantify the minimal required spatial resolution and camera resolution to capture the geometry and shape of the deformities of the human back, we used multiple 3D scanning methodologies and systems. The results from an evaluation of 30 captures of AIS patients and 76 captures of healthy subjects showed that the minimal required spatial resolution is between 2 mm and 5 mm, depending on the chosen error tolerance. Therefore, a minimal camera resolution of 640 Ă— 480 pixels is recommended for use in future studies
Selective retina therapy enhanced with optical coherence tomography for dosimetry control and monitoring: a proof of concept study
Impaired endotoxin-induced interleukin-1β secretion, not total production, of mononuclear cells from ESRD patients
Impaired endotoxin-induced interleukin-1β secretion, not total production, of mononuclear cells from ESRD patients. Lipopolysaccharide (LPS)-induced interleukin-1 beta (IL-1β) and tumor necrosis factor alpha (TNFα) production and secretion from peripheral blood mononuclear cells (PBMC) were determined in a longitudinal study with repeated measurements in PBMC from patients with chronic uremia not on hemodialysis (N = 8), end-stage renal disease (ESRD) patients (N = 8), and healthy controls (N = 7). ESRD patients were studied while using low-flux Cuprophan dialyzers and again using high-flux AN 69 dialyzers. Total (cell-associated plus secreted) LPS-induced IL-1β production was enhanced in uremic patients, but similar to controls in ESRD patients on Cuprophan. In contrast, LPS-induced IL-1β secretion (secreted amounts in % of total production) was similar to controls in uremic patients, but significantly reduced in ESRD patients on Cuprophan (P < 0.01). During AN 69 hemodialysis, LPS-induced total IL-1β production remained unchanged but IL-1β secretion increased significantly (P < 0.05) compared to Cuprophan dialysis. Increased IL-1β secretion coincided with a suppression in PGE2 synthesis (P < 0.02). Similarly, blockade of endogenous PGE2 by indomethacin increased LPS-induced IL-1β secretion (P < 0.01) but did not enhance total IL-1β production in PBMC from controls and patients on Cuprophan hemodialysis. Neither total production nor secretion of TNFα was different comparing the three study groups. We conclude that LPS-induced IL-1β secretion, but not total production, is impaired in PBMC from ESRD patients on long-term Cuprophan hemodialysis. This functional change in the PBMC response is specific for IL-1β, not due to uremia per se but hemodialysis-dependent and reversible. Hemodialysis with AN 69 suppresses endogenous PGE2 synthesis in PBMC which is associated with increased LPS-induced IL-1β secretion in the presence of unchanged total IL-1β production. We speculate that PGE2 could inactivate the IL-1β converting enzyme which is essential for processing and secretion of mature IL-1β
Automatic hand phantom map generation and detection using decomposition support vector machines
Background: There is a need for providing sensory feedback for myoelectric prosthesis users. Providing tactile feedback can improve object manipulation abilities, enhance the perceptual embodiment of myoelectric prostheses and help reduce phantom limb pain. Many amputees have referred sensation from their missing hand on their residual limbs (phantom maps). This skin area can serve as a target for providing amputees with non-invasive tactile sensory feedback. One of the challenges of providing sensory feedback on the phantom map is to define the accurate boundary of each phantom digit because the phantom map distribution varies from person to person. Methods: In this paper, automatic phantom map detection methods based on four decomposition support vector machine algorithms and three sampling methods are proposed, complemented by fuzzy logic and active learning strategies. The algorithms and methods are tested on two databases: the first one includes 400 generated phantom maps, whereby the phantom map generation algorithm was based on our observation of the phantom maps to ensure smooth phantom digit edges, variety, and representativeness. The second database includes five reported phantom map images and transformations thereof. The accuracy and training/ classification time of each algorithm using a dense stimulation array (with 100 Ă— 100 actuators) and two coarse stimulation arrays (with 3 Ă— 5 and 4 Ă— 6 actuators) are presented and compared. Results: Both generated and reported phantom map images share the same trends. Majority-pooling sampling effectively increases the training size, albeit introducing some noise, and thus produces the smallest error rates among the three proposed sampling methods. For different decomposition architectures, one-vs-one reduces unclassified regions and in general has higher classification accuracy than the other architectures. By introducing fuzzy logic to bias the penalty parameter, the influence of pooling-induced noise is reduced. Moreover, active learning with different strategies was also tested and shown to improve the accuracy by introducing more representative training samples. Overall, dense arrays employing one-vs-one fuzzy support vector machines with majority-pooling sampling have the smallest average absolute error rate (8.78% for generated phantom maps and 11.5% for reported and transformed phantom map images). The detection accuracy of coarse arrays was found to be significantly lower than for dense array. Conclusions: The results demonstrate the effectiveness of support vector machines using a dense array in detecting refined phantom map shapes, whereas coarse arrays are unsuitable for this task. We therefore propose a two-step approach, using first a non-wearable dense array to detect an accurate phantom map shape, then to apply a wearable coarse stimulation array customized according to the detection results. The proposed methodology can be used as a tool for helping haptic feedback designers and for tracking the evolvement of phantom maps
A Miniature Multimodal Actuator for Effective Tactile Feedback: Design and Characterization
We designed a miniature multimodal actuator by combining servomotors and vibrators. The actuator is mainly designed to non-invasively deliver tactile information to human skin by high-frequency vibration and low-frequency pressures simultaneously. By utilizing two modalities at the same time, the actuator stimulates different types of mechanoreceptors and thus has the potential to increase the band width to transfer tactile information. The designed actuator possess the advantage of light weight, compact size, low power consumption, short response time, large ranges of pressure and vibration, and non-back-drivable mechanism. Multimodal actuators provide new tools and possibilities to display tactile information on human skin efficiently and intuitively. (C) 2016 The Authors. Published by Elsevier Ltd
- …