966 research outputs found

    CCD UBV(RI)CUBV(RI)_{C} Photometry of Twenty Open Clusters

    Full text link
    Fundamental astrophysical parameters have been derived for 20 open clusters (O\!Cs) using CCD~U ⁣BV ⁣(RI)CU\!BV\!(RI)_C photometric data observed with the 84~cm telescope at the San Pedro M\'artir National Astronomical Observatory, M\'exico. The interstellar reddenings, metallicities, distances, and ages have been compared to the literature values. Significant differences are usually due to the usage of diverse empirical calibrations and differing assumptions, such as concerning cluster metallicity, as well as distinct isochrones which correspond to differing element-abundance ratios, internal stellar physics, and photometric systems. Different interstellar reddenings, as well as varying reduction and cluster-membership techniques, are also responsible for these kinds of systematic differences and errors. The morphological ages, which are derived from the morphological indices (δV\delta V and δ1\delta 1) in the CM diagrams, are in good agreement with the isochrone ages of 12 O\!Cs, those with good red clump (RC) and red giant (RG) star candidates. No metal abundance gradient is detected for the range 6.82RGC15.376.82 \leq R_{GC} \leq 15.37 kpc, nor any correlation between the cluster ages and metal abundances for these 20 O\!Cs. Young, metal-poor O\!Cs, observed here in the third Galactic quadrant, may be associated with stellar over-densities, such as that in Canis Major (Martin et al.) and the Monoceros Ring (Newberg et al.), or signatures of past accretion events, as discussed by Yong et al. and Carraro et al.Comment: 68 pages, 33 figures, 15 tables. Accepted in New Astronom

    The assembly history of the Galactic inner halo inferred from alpha-patterns

    Full text link
    We explore the origin of the observed decline in [O/Fe] (and [Mg/Fe]) with Galactocentric distance for high-metallicity stars ([Fe/H] > -1.1), based on a sample of halo stars selected within the Apache Point Observatory Galactic Evolution Experiment (APOGEE) fourteenth data release (DR14). We also analyse the characteristics of the [α\alpha/Fe] distributions in the inner-halo regions inferred from two zoom-in Milky Way mass-sized galaxies that are taken as case studies. One of them qualitatively reproduces the observed trend to have higher fraction of α\alpha-rich star for decreasing galactocentric distance; the other exhibits the opposite trend. We find that stars with [Fe/H] > -1.1 located in the range [15 - 30] kpc are consistent with formation in two starbursts, with maxima separated by about ~ 1 Gyr. We explore the contributions of stellar populations with different origin to the [α\alpha/Fe] gradients detected in stars with [Fe/H] > -1.1. Our analysis reveals that the simulated halo that best matches the observed chemical trends is characterised by an accretion history involving low to intermediate-mass satellite galaxies with a short and intense burst of star formation, and contributions from a more massive satellite with dynamical masses about ~ 1010^{10}M_{\odot}, distributing low-[α\alpha/Fe] stars at intermediate radius.Comment: 13 pages, 8 figures. Accepted for publication in MNRA

    Observational signatures for depletion in the Spite plateau: solving the cosmological Li discrepancy?

    Full text link
    We present Li abundances for 73 stars in the metallicity range -3.5 < [Fe/H] < -1.0 using improved IRFM temperatures (Casagrande et al. 2010) with precise E(B-V) values obtained mostly from interstellar NaI D lines, and high-quality equivalent widths (errors ~ 3%). At all metallicities we uncover a fine-structure in the Li abundances of Spite plateau stars, which we trace to Li depletion that depends on both metallicity and mass. Models including atomic diffusion and turbulent mixing seem to reproduce the observed Li depletion assuming a primordial Li abundance ALi = 2.64 dex (MARCS models) or 2.72 (Kurucz overshooting models), in good agreement with current predictions (ALi = 2.72) from standard BBN. We are currently expanding our sample to have a better coverage of different evolutionary stages at the high and low metallicity ends, in order to verify our findings.Comment: In press, Light elements in the Universe, Proceedings IAU Symposium No. 268, 2010. C. Charbonnel, M. Tosi, F. Primas & C. Chiappini, ed

    Infrared Observations of the Helix Planetary Nebula

    Get PDF
    We have mapped the Helix (NGC 7293) planetary nebula (PN) with the IRAC instrument on the Spitzer Space Telescope. The Helix is one of the closest bright PNs and therefore provides an opportunity to resolve the small-scale structure in the nebula. The emission from this PN in the 5.8 and 8 μm IRAC bands is dominated by the pure rotational lines of molecular hydrogen, with a smaller contribution from forbidden line emission such as [Ar III] in the ionized region. The IRAC images resolve the "cometary knots," which have been previously studied in this PN. The "tails" of the knots and the radial rays extending into the outer regions of the PN are seen in emission in the IRAC bands. IRS spectra on the main ring and the emission in the IRAC bands are consistent with shock-excited H_2 models, with a small (~10%) component from photodissociation regions. In the northeast arc, the H_2 emission is located in a shell outside the Hα emission

    Time-Accurate Unsteady Pressure Loads Simulated for the Space Launch System at Wind Tunnel Conditions

    Get PDF
    A transonic flow field about a Space Launch System (SLS) configuration was simulated with the Fully Unstructured Three-Dimensional (FUN3D) computational fluid dynamics (CFD) code at wind tunnel conditions. Unsteady, time-accurate computations were performed using second-order Delayed Detached Eddy Simulation (DDES) for up to 1.5 physical seconds. The surface pressure time history was collected at 619 locations, 169 of which matched locations on a 2.5 percent wind tunnel model that was tested in the 11 ft. x 11 ft. test section of the NASA Ames Research Center's Unitary Plan Wind Tunnel. Comparisons between computation and experiment showed that the peak surface pressure RMS level occurs behind the forward attach hardware, and good agreement for frequency and power was obtained in this region. Computational domain, grid resolution, and time step sensitivity studies were performed. These included an investigation of pseudo-time sub-iteration convergence. Using these sensitivity studies and experimental data comparisons, a set of best practices to date have been established for FUN3D simulations for SLS launch vehicle analysis. To the author's knowledge, this is the first time DDES has been used in a systematic approach and establish simulation time needed, to analyze unsteady pressure loads on a space launch vehicle such as the NASA SLS

    Towards More Precise Survey Photometry for PanSTARRS and LSST: Measuring Directly the Optical Transmission Spectrum of the Atmosphere

    Full text link
    Motivated by the recognition that variation in the optical transmission of the atmosphere is probably the main limitation to the precision of ground-based CCD measurements of celestial fluxes, we review the physical processes that attenuate the passage of light through the Earth's atmosphere. The next generation of astronomical surveys, such as PanSTARRS and LSST, will greatly benefit from dedicated apparatus to obtain atmospheric transmission data that can be associated with each survey image. We review and compare various approaches to this measurement problem, including photometry, spectroscopy, and LIDAR. In conjunction with careful measurements of instrumental throughput, atmospheric transmission measurements should allow next-generation imaging surveys to produce photometry of unprecedented precision. Our primary concerns are the real-time determination of aerosol scattering and absorption by water along the line of sight, both of which can vary over the course of a night's observations.Comment: 41 pages, 14 figures. Accepted PAS

    Offshore Radiation Observations for Climate Research at the CERES Ocean Validation Experiment

    Get PDF
    When radiometers on a satellite are pointed towards the planet with the goal of understanding a phenomenon quantitatively, rather than just creating a pleasing image, the task at hand is often problematic. The signal at the detector can be affected by scattering, absorption, and emission; and these can be due to atmospheric constituents (gases, clouds, and aerosols), the earth's surface, and subsurface features. When targeting surface phenomena, the remote sensing algorithm needs to account for the radiation associated with the atmospheric constituents. Likewise, one needs to correct for the radiation leaving the surface, when atmospheric phenomena are of interest. Rigorous validation of such remote sensing products is a real challenge. In visible and near infrared wavelengths, the jumble of effects on atmospheric radiation are best accomplished over dark surfaces with fairly uniform reflective properties (spatial homogeneity) in the satellite instrument's field of view (FOV). The ocean's surface meets this criteria; land surfaces - which are brighter, more spatially inhomogeneous, and more changeable with time - generally do not. NASA's Clouds and the Earth's Radiant Energy System (CERES) project has used this backdrop to establish a radiation monitoring site in Virginia's coastal Atlantic Ocean. The project, called the CERES Ocean Validation Experiment (COVE), is located on a rigid ocean platform allowing the accurate measurement of radiation parameters that require precise leveling and pointing unavailable from ships or buoys. The COVE site is an optimal location for verifying radiative transfer models and remote sensing algorithms used in climate research; because of the platform's small size, there are no island wake effects; and suites of sensors can be simultaneously trained both on the sky and directly on ocean itself. This paper describes the site, the types of measurements made, multiple years of atmospheric and ocean surface radiation observations, and satellite validation results

    The Galactic Disk-Halo transition - Evidence from Stellar Abundances

    Full text link
    New information on the relations between the Galactic disks, the halo, and satellite galaxies is being obtained from elemental abundances of stars having metallicities in the range -1.5 < [Fe/H] < -0.5. The first results for a sample of 26 halo stars and 13 thick-disk stars observed with the ESO VLT/UVES spectrograph are presented. The halo stars fall in two distinct groups: One group (9 stars) has [alpha/Fe]= 0.30 +-0.03 like the thick-disk stars. The other group (17 stars) shows a clearly deviating trend ranging from [alpha/Fe]= 0.20 at [Fe/H]= -1.3 to [alpha/Fe]= 0.08 at [Fe/H]= -0.8. The kinematics of the stars are discussed and the abundance ratios Na/Fe, Ni/Fe, Cu/Fe and Ba/Y are applied to see if the low-alpha stars are connected to the thin disk or to Milky Way satellite galaxies. Furthermore, we compare our data with simulations of chemical abundance distributions in hierarchically formed stellar halos in a LambdaCDM Universe.Comment: 6 pages, 6 figures. To appear in proceedings of the IAU Symposium No. 254 "The Galaxy Disk in Cosmological Context", Copenhagen 9-13 June 2008, Eds. J. Andersen, J.Bland-Hawthorn & B. Nordstrom, Cambridge University Pres
    corecore