Fe II lifetimes and transition probabilities

Fe II radiative lifetimes were measured applying the time-resolved nonlinear laser-induced fluoresence technique. We investigated 21 levels of up to 47000 1/cm. The uncertainties are typically 2-3%. The lifetimes provide an improved absolute scale to our branching fractions which were measured with a Fourier transform spectrometer and a high-resolution grating spectrometer and which have been published earlier. We report absolute transition probabilities of 140 Fe II lines in the wavelength range 220-780 nm. The overall uncertainties are estimated to be 6% for the strong and up to 26% for the weak transitions. The results are compared with recent experimental data from the literature. Our large set of accurate data can be used for a reliability check of theoretical data calculated for iron abundances in astrophysical plasmas

Changes in union membership over time : a panel analysis for West Germany

Despite the apparent stability of the wage bargaining institutions in West Germany, aggregate union membership has been declining dramatically since the early 90's. However, aggregate gross membership numbers do not distinguish by employment status and it is impossible to disaggregate these sufficiently. This paper uses four waves of the German Socioeconomic Panel in 1985, 1989, 1993, and 1998 to perform a panel analysis of net union membership among employees. We estimate a correlated random effects probit model suggested in Chamberlain (1984) to take proper account of individual specfic effects. Our results suggest that at the individual level the propensity to be a union member has not changed considerably over time. Thus, the aggregate decline in membership is due to composition effects. We also use the estimates to predict net union density at the industry level based on the IAB employment subsample for the time period 1985 to 1997. JEL - Klassifikation: J

Quantum engineering of squeezed states for quantum communication and metrology

We report the experimental realization of squeezed quantum states of light, tailored for new applications in quantum communication and metrology. Squeezed states in a broad Fourier frequency band down to 1 Hz has been observed for the first time. Nonclassical properties of light in such a low frequency band is required for high efficiency quantum information storage in electromagnetically induced transparency (EIT) media. The states observed also cover the frequency band of ultra-high precision laser interferometers for gravitational wave detection and can be used to reach the regime of quantum non-demolition interferometry. And furthermore, they cover the frequencies of motions of heavily macroscopic objects and might therefore support the attempts to observe entanglement in our macroscopic world.Comment: 12 pages, 3 figure

The Cambrian-Precambrian contact in northwestern Connecticut and west-central Massachusetts

Guidebook for field trips in western Massachusetts, northern Connecticut and adjacent areas of New York: 67th annual meeting October 10, 11, and 12, 1975: Trip B-5; C-

The GEO600 squeezed light source

The next upgrade of the GEO600 gravitational wave detector is scheduled for 2010 and will, in particular, involve the implementation of squeezed light. The required non-classical light source is assembled on a 1.5m^2 breadboard and includes a full coherent control system and a diagnostic balanced homodyne detector. Here, we present the first experimental characterization of this setup as well as a detailed description of its optical layout. A squeezed quantum noise of up to 9dB below the shot-noise level was observed in the detection band between 10Hz and 10kHz. We also present an analysis of the optical loss in our experiment and provide an estimation of the possible non-classical sensitivity improvement of the future squeezed light enhanced GEO600 detector.Comment: 8 pages, 4 figure

High reflectivity grating waveguide coatings for 1064nm

We propose thin single-layer grating waveguide structures to be used as high-reflectivity, but low thermal noise, alternative to conventional coatings for gravitational wave detector test mass mirrors. Grating waveguide (GWG) coatings can show a reflectivity of up to 100% with an overall thickness of less than a wavelength. We theoretically investigate GWG coatings for 1064nm based on tantala (Ta2O5) on a Silica substrate focussing on broad spectral response and low thickness

Simulation of a finishing operation : milling of a turbine blade and influence of damping

Milling is used to create very complex geometries and thin parts, such as turbine blades. Irreversible geometric defects may appear during finishing operations when a high surface quality is expected. Relative vibrations between the tool and the workpiece must be as small as possible, while tool/workpiece interactions can be highly non-linear. A general virtual machining approach is presented and illustrated. It takes into account the relative motion and vibrations of the tool and the workpiece. Both deformations of the tool and the workpiece are taken into account. This allows predictive simulations in the time domain. As an example the effect of damping on the behavior during machining of one of the 56 blades of a turbine disk is analysed in order to illustrate the approach potential

Keck-Nirspec Infrared OH Lines: Oxygen Abundances in Metal-Poor Stars Down to [Fe/H] = -2.9

Infrared OH lines at 1.5 - 1.7 um in the H band were obtained with the NIRSPEC high-resolution spectrograph at the 10m Keck Telescope for a sample of seven metal-poor stars. Detailed analyses have been carried out, based on optical high-resolution data obtained with the FEROS spectrograph at ESO. Stellar parameters were derived by adopting infrared flux method effective temperatures, trigonometric and/or evolutionary gravities and metallicities from FeII lines. We obtain that the sample stars with metallicities [Fe/H] < -2.2 show a mean oxygen abundance [O/Fe] ~ 0.54, for a solar oxygen abundance of epsilon(O) = 8.87, or [O/Fe] ~ 0.64 if epsilon(O) = 8.77 is assumed.Comment: To be published in ApJ 575 (August 10

Beating the Standard Sensitivity-Bandwidth Limit of Cavity-Enhanced Interferometers with Internal Squeezed-Light Generation

The shot-noise limited peak sensitivity of cavity-enhanced interferometric measurement devices, such as gravitational-wave detectors, can be improved by increasing the cavity finesse, even when comparing fixed intracavity light powers. For a fixed light power inside the detector, this comes at the price of a proportional reduction in the detection bandwidth. High sensitivity over a large span of signal frequencies, however, is essential for astronomical observations. It is possible to overcome this standard sensitivity-bandwidth limit using nonclassical correlations in the light field. Here, we investigate the internal squeezing approach, where the parametric amplification process creates a nonclassical correlation directly inside the interferometer cavity. We theoretically analyze the limits of the approach and measure 36% increase in the sensitivity-bandwidth product compared to the classical case. To our knowledge, this is the first experimental demonstration of an improvement in the sensitivity-bandwidth product using internal squeezing, opening the way for a new class of optomechanical force sensing devices

Experimental demonstration of a suspended diffractively coupled optical cavity

All-reflective optical systems are under consideration for future gravitational wave detector topologies. One approach in proposed designs is to use diffraction gratings as input couplers for Fabry–Perot cavities. We present an experimental demonstration of a fully suspended diffractively coupled cavity and investigate the use of conventional Pound–Drever–Hall length sensing and control techniques to maintain the required operating condition