Computer Simulation of Chute Flows of Granular Materials

The purpose of the present paper is to present results from computer simulations of the flow of granular materials down inclined chutes or channels and to compare the results of these calculations with existing experimental measurements of velocity, solid fraction and mass flow rate profiles

Blood flow dynamics in patient specific arterial network in head and neck

This paper shows a steady simulation of blood flow in the major head and neck arteries as if they had rigid walls, using patient specific geometry and CFD software FLUENT R . The Artery geometry is obtained by CT–scan segmentation with the commercial software ScanIPTM. A cause and effect study with various Reynolds numbers, viscous models and blood fluid models is provided. Mesh independence is achieved through wall y+ and pressure gradient adaption. It was found, that a Newtonian fluid model is not appropriate for all geometry parts, therefore the non–Newtonian properties of blood are required for small vessel diameters and low Reynolds numbers. The k–! turbulence model is suitable for the whole Reynolds numbe

Gene-knockdown in the honey bee mite Varroa destructor by a non-invasive approach : studies on a glutathione S-transferase

Peer reviewedPublisher PD

Transcriptome analysis of the synganglion from the honey bee mite, Varroa destructor and RNAi knockdown of neural peptide targets

Acknowledgements This work was funded by BBSRC-LINK grant # BB/J01009X/1 and Vita Europe Ltd. We are grateful to the Scottish Beekeepers Association, especially Mr Phil McAnespie in supporting this work at its inception. We acknowledge partial funding from a Genesis Faraday SPARK Award, part of a Scottish Government SEEKIT project for the early part of this work. We are grateful to Prof David Evans for his advice on Varroa destructor viruses.Peer reviewedPostprin

Revisiting the 1954 Suspension Experiments of R. A.Bagnold

In 1954 R. A. Bagnold published his seminal findings on the rheological properties of a liquid-solid suspension. Although this work has been cited extensively over the last fifty years, there has not been a critical review of the experiments. The purpose of this study is to examine the work and to suggest an alternative reason for the experimental findings. The concentric cylinder rheometer was designed to measure simultaneously the shear and normal forces for a wide range of solid concentrations, fluid viscosities and shear rates. As presented by Bagnold, the analysis and experiments demonstrated that the shear and normal forces depended linearly on the shear rate in the 'macroviscous' regime; as the grain-to-grain interactions increased in the 'grain-inertia' regime, the stresses depended on the square of the shear rate and were independent of the fluid viscosity. These results, however, appear to be dictated by the design of the experimental facility. In Bagnold's experiments, the height (h) of the rheometer was relatively short compared to the spacing (t) between the rotating outer and stationary inner cylinder (h/t=4.6). Since the top and bottom end plates rotated with the outer cylinder, the flow contained two axisymmetric counter-rotating cells in which flow moved outward along the end plates and inward through the central region of the annulus. At higher Reynolds numbers, these cells contributed significantly to the measured torque, as demonstrated by comparing Bagnold's pure-fluid measurements with studies on laminar-to-turbulent transitions that pre-date the 1954 study. By accounting for the torque along the end walls, Bagnold's shear stress measurements can be estimated by modelling the liquid-solid mixture as a Newtonian fluid with a corrected viscosity that depends on the solids concentration. An analysis of the normal stress measurements was problematic because the gross measurements were not reported and could not be obtained

Three field tests of a gas filter correlation radiometer

Test flights to remotely measure nonurban carbon monoxide (CO) concentrations by gas filter correlation radiometry are discussed. The inferred CO concentrations obtained through use of the Gas Filter Correlation Radiometer (GFCR) agreed with independent measurements obtained by gas chromatography air sample bottle analysis to within 20 percent. The equipment flown on board the aircraft, the flight test procedure, the gas chromatograph direct air sampling procedure, and the GFCR data analysis procedure are reported