Metallic impurities in the Cu-fraction of Ni targets prepared from NiCl2 solutions

Introduction Copper-64 is an emerging radionuclide with applications in PET molecular imaging and/or internal therapy and it is typically produced by proton irradiation of isotopically enriched 64Ni electrodeposited on a suitable backing substrate. We recently reported a simple and efficient method for the preparation of nickel targets from electrolytic solutions of nickel chloride and boric acid [1]. Herein we report our recent research work on the analysis of metallic impurities in the copper-fraction of the radiochemical separation process. Material and Methods Nickel targets were prepared and processed as previously reported [1]. Briefly, the bath solution was composed of a mixture of natural NiCl2. 6H2O (135 mg/ml) and H3BO3 (15 mg/ml) and Ni was electrodeposited using a gold disk as cathode and a platinum wire as anode. The plating process was carried out at room temperature using 2 ml of bath solution (pH = 3.7) and a constant current density of 60 mA/cm2 for 1 hour. The unirradiated Ni targets were dissolved in 1–2 ml of concentrated (10M) HCl at 90 oC. After complete dissolution of the Ni layer, water was added to dilute the acid to 6M, and the solution was transferred onto a chromatographic column containing AG 1-X8 resin equilibrated with 6M HCl. The Ni , Co and Cu isotopes were separated by using the well-known chromatography of the chloro-complexes. The sample-fractions containing the Cu isotopes (15 ml, 0.1M HCl) were collected in plastic centrifuge tubes previously soaked in 1M HNO3 and rinsed with Milli-Q water (18 MΩ cm). Impurities of B, Co, Ni, Cu and Zn in these samples were determined by inductively coupled plasma-mass spectroscopy (ICP-MS) at the Department of Geosciences (Laboratory of Isotopic Studies) of the National University. Results and Conclusions The mass of Ni deposited in 1 h was 25.0 ± 1.0 mg (n = 3) and the current efficiency was > 75 % in all cases. The pH of the electrolytic solution tended to decrease along the electrodeposition process (3.71.6). The results of ICP-MS analysis of the Cu-fractions from the cold chromatography separation runs are shown in FIG. 1. We were particularly interested in the boron impurities as H3BO3 is used as buffer for electrodeposition of the Ni targets. Except for the Ni impurities that were deter-mined to be in the range of ppm (mg/l), all other analyzed metallic impurities were found to be in the range of ppb (µg/l), including boron. The Co, Ni, Cu and Zn impurities determined in the Cu-fraction in this work using Ni targets electrode-posited from a NiCl2 acidic solution, are in the same order of magnitude compared with that obtained when using targets prepared from an alkaline solution [2], with the advantage of the simplicity of the electrodeposition method from NiCl2 solutions, as the target material is already recovered in the chemical form of NiCl2, enabling a simpler, one step process to prepare a new plating solution when using enriched 64Ni target material for the production of 64Cu

Application of the sine-cosine algorithm to the optimal design of a closed coil helical spring

This paper proposes the application of the sinecosine algorithm (SCA) to the optimal design of a closed coil helical spring. The optimization problem addressed corresponds to the minimization of total spring volume subject to physical constraints that represents the closed coil helical spring such as maximum working load, shear stress, and minimum diameter requirements, among other. The resulting mathematical formulation is a complex nonlinear and non-convex optimization model that is typically addressed in literature with trial and error methods or heuristic algorithms. To solve this problem efficiently, the SCA is proposed in this research. This optimization algorithm belongs to the family of the metaheuristic optimization techniques, it works with controlled random processes guided by sine and cosine trigonometric functions, that allows exploring and exploiting the solution space in order to find the best solution to the optimization problem. By presenting as main advantage an easy implementation at any programming language using sequential quadratic programming; eliminating the need to uses specialized and costly software. Numerical results demonstrating that the proposes SCA allows reaching lower spring volume values in comparison with literature approaches, such as genetic algorithms, particle swarm optimization methods, among others. All the numerical simulations have been implemented in the MATLAB software

Fractura-luxación posterior de hombro tratada mediante la técnica de McLaughlin

Se presenta un caso de luxación posterior de hombro, con fractura por impactación de la cabeza humeral, ocasionada por crisis convulsivas. Estas lesiones no son fáciles de reconocer en los primeros momentos, y en nuestro caso se precisó de un estudio radiográfico en distintas proyecciones y una TAC. Se realizó tratamiento quirúrgico mediante la técnica original de McLaughlin. A los 7 meses de la intervención el paciente ha recuperado casi totalmente la movilidad en dicho hombro y está libre de dolor.A case of posterior dislocation of the shoulder with locked fracture of the humeral head after a convulsive seizure is reported. At first stages, this type is very difficult to recognize. In our case, a radiographic study in different views and a CT-scan were needed. Surgical treatment were carried out according to McLauglin's original technique. Seven months after surgery the patient had regained almost complete range of shoulder motion and was pain-free

TECHNIQUES FOR THE STUDY OF THE STRUCTURAL PROPERTIES.

The evolution of our understanding of the behavior of oxide nanostructures depends heavily on the structural information obtained from a wide range of physical methods traditionally used in solid state physics, surface science and inorganic chemistry. In this chapter, we describe several techniques that are useful for the characterization of the structural properties of oxide nanostructures: X-ray diffraction (XRD) and scattering, X-ray absorption fine structure (XAFS), Raman spectroscopy, transmission electron microscopy (TEM), scanning tunneling microscopy (STM) and atomic force microscopy (AFM). The ultimate goal is to obtain information about the spatial arrangement of atoms in the nanostructures with precise interatomic distances and bond angles. This may not be possible for complex systems and one may get only partial information about the local geometry or morphology

Reduced salivary oxytocin after an empathic induction task in Intimate Partner Violence perpetrators: Importance of socio-affective functions and its impact on prosocial behavior

Intimate Partner Violence (IPV) has been linked to difficulties in socio-affective functions. Nevertheless, the underlying psychobiological mechanisms that might be responsible for them remain unclear. Oxytocin (OXT) stands out as an important hormone that may favor the salience of social information, due to its relevance in empathy and prosocial behavior. Thus, the study of salivary OXT (sOXT) may provide further information about potential impairments in social cognition in IPV perpetrators. This study analyzed the effects of an empathic induction task, performed through negative emotion-eliciting videos, on endogenous sOXT levels, mood state, and emotional perception in 30 IPV perpetrators compared to 32 controls. Additionally, we explored their performance on prosocial behavior after the empathic induction task, using Hare''s donation procedure. Lower sOXT levels were found in IPV perpetrators after the task compared to controls, along with a general decreasing tendency in their sOXT levels. Additionally, IPV perpetrators exhibited no change in their mood state and perceived others'' emotions as more positive and less intense. Moreover, the mood state response and alexithymia traits, respectively, positively and negatively predicted the sOXT levels after the empathic induction task in the entire sample. Finally, we did not observe a lower appearance of prosocial behaviors in IPV perpetrators; however, higher sOXT levels after the empathic induction task were found in subjects who donated when considering the whole sample. In sum, IPV perpetrators exhibited differences in their sOXT levels when empa-thizing, compared to controls, with alexithymia and the emotional response potentially explaining the sOXT levels after the task. Furthermore, prosocial behavior was more related to these sOXT levels than to IPV. As our knowledge about the emotional processing of IPV perpetrators increases, we will be better able to develop and include coadjutant treatments in current psychotherapeutic programs, in order to focus on their emotional needs, which, in turn, would reduce the future risk of recidivism

Wax worm saliva and the enzymes therein are the key to polyethylene degradation by Galleria mellonella

Plastic degradation by biological systems with re-utilization of the by-products could be a future solution to the global threat of plastic waste accumulation. Here, we report that the saliva of Galleria mellonella larvae (wax worms) is capable of oxidizing and depolymerizing polyethylene (PE), one of the most produced and sturdy polyolefin-derived plastics. This effect is achieved after a few hours’ exposure at room temperature under physiological conditions (neutral pH). The wax worm saliva can overcome the bottleneck step in PE biodegradation, namely the initial oxidation step. Within the saliva, we identify two enzymes, belonging to the phenol oxidase family, that can reproduce the same effect. To the best of our knowledge, these enzymes are the first animal enzymes with this capability, opening the way to potential solutions for plastic waste management through bio-recycling/up-cycling

Abscisic acid mimic-fluorine derivative 4 alleviates water deficit stress by regulating ABA-responsive genes, proline accumulation, CO2 assimilation, water use efficiency and better nutrient uptake in tomato plants

Water deficit represents a serious limitation for agriculture and both genetic and chemical approaches are being used to cope with this stress and maintain plant yield. Next-generation agrochemicals that control stomatal aperture are promising for controlling water use efficiency. For example, chemical control of abscisic acid (ABA) signaling through ABA-receptor agonists is a powerful method to activate plant adaptation to water deficit. Such agonists are molecules able to bind and activate ABA receptors and, although their development has experienced significant advances in the last decade, few translational studies have been performed in crops. Here, we describe protection by the ABA mimic-fluorine derivative 4 (AMF4) agonist of the vegetative growth in tomato plants subjected to water restriction. Photosynthesis in mock-treated plants is markedly impaired under water deficit conditions, whereas AMF4 treatment notably improves CO2 assimilation, the relative plant water content and growth. As expected for an antitranspirant molecule, AMF4 treatment diminishes stomatal conductance and transpiration in the first phase of the experiment; however, when photosynthesis declines in mock-treated plants as stress persists, higher photosynthetic and transpiration parameters are recorded in agonist-treated plants. Additionally, AMF4 increases proline levels over those achieved in mock-treated plants in response to water deficit. Thus water deficit and AMF4 cooperate to upregulate P5CS1 through both ABA-independent and ABA-dependent pathways, and therefore, higher proline levels are produced Finally, analysis of macronutrients reveals higher levels of Ca, K and Mg in AMF4- compared to mock-treated plants subjected to water deficit. Overall, these physiological analyses reveal a protective effect of AMF4 over photosynthesis under water deficit and enhanced water use efficiency after agonist treatment. In summary, AMF4 treatment is a promising approach for farmers to protect the vegetative growth of tomatoes under water deficit stress

Hyperhomocysteinemia in liver cirrhosis: mechanisms and role in vascular and hepatic fibrosis

Numerous clinical and epidemiological studies have identified elevated homocysteine levels in plasma as a risk factor for atherosclerotic vascular disease and thromboembolism. Hyperhomocysteinemia may develop as a consequence of defects in homocysteine-metabolizing genes; nutritional conditions leading to vitamin B(6), B(12), or folate deficiencies; or chronic alcohol consumption. Homocysteine is an intermediate in methionine metabolism, which takes place mainly in the liver. Impaired liver function leads to altered methionine and homocysteine metabolism; however, the molecular basis for such alterations is not completely understood. In addition, the mechanisms behind homocysteine-induced cellular toxicity are not fully defined. In the present work, we have examined the expression of the main enzymes involved in methionine and homocysteine metabolism, along with the plasma levels of methionine and homocysteine, in the liver of 26 cirrhotic patients and 10 control subjects. To gain more insight into the cellular effects of elevated homocysteine levels, we have searched for changes in gene expression induced by this amino acid in cultured human vascular smooth muscle cells. We have observed a marked reduction in the expression of the main genes involved in homocysteine metabolism in liver cirrhosis. In addition, we have identified the tissue inhibitor of metalloproteinases-1 and alpha1(I)procollagen to be upregulated in vascular smooth muscle cells and liver stellate cells exposed to pathological concentrations of homocysteine. Taken together, our observations suggest (1) impaired liver function could be a novel determinant in the development of hyperhomocysteinemia and (2) a role for elevated homocysteine levels in the development of liver fibrosis

Deletion Mutants of VPg Reveal New Cytopathology Determinants in a Picornavirus

BACKGROUND: Success of a viral infection requires that each infected cell delivers a sufficient number of infectious particles to allow new rounds of infection. In picornaviruses, viral replication is initiated by the viral polymerase and a viral-coded protein, termed VPg, that primes RNA synthesis. Foot-and-mouth disease virus (FMDV) is exceptional among picornaviruses in that its genome encodes 3 copies of VPg. Why FMDV encodes three VPgs is unknown. METHODOLOGY AND PRINCIPAL FINDINGS: we have constructed four mutant FMDVS that encode only one VPG: either VPg(1), VPg(3), or two chimeric versions containing part of VPg(1) and VPg(3). All mutants, except that encoding only VPg(1), were replication-competent. Unexpectedly, despite being replication-competent, the mutants did not form plaques on BHK-21 cell monolayers. The one-VPg mutant FMDVs released lower amounts of encapsidated viral RNA to the extracellular environment than wild type FMDV, suggesting that deficient plaque formation was associated with insufficient release of infectious progeny. Mutant FMDVs subjected to serial passages in BHK-21 cells regained plaque-forming capacity without modification of the number of copies of VPg. Substitutions in non-structural proteins 2C, 3A and VPg were associated with restoration of plaque formation. Specifically, replacement R55W in 2C was repeatedly found in several mutant viruses that had regained competence in plaque development. The effect of R55W in 2C was to mediate an increase in the extracellular viral RNA release without a detectable increase of total viral RNA that correlated with an enhanced capacity to alter and detach BHK-21 cells from the monolayer, the first stage of cell killing. CONCLUSIONS: The results link the VPg copies in the FMDV genome with the cytopathology capacity of the virus, and have unveiled yet another function of 2C: modulation of picornavirus cell-to-cell transmission. Implications for picornaviruses pathogenesis are discussed