Structural differences between mesophilic, moderately thermophilic and extremely thermophilic protein subunits: results of a comprehensive survey

AbstractBackground: Proteins from thermophilic organisms usually show high intrinsic thermal stability but have structures that are very similar to their mesophilic homologues. From prevous studies it is difficult to draw general conclusions about the structural features underlying the increased thermal stability of thermophilic proteins.Results: In order to reveal the general evolutionary strategy for changing the heat stability of proteins, a non-redundant data set was compiled comprising all high-quality structures of thermophilic proteins and their mesophilic homologues from the Protein Data Bank. The selection (quality) criteria were met by 64 mesophilic and 29 thermophilic protein subunits, representing 25 protein families. From the atomic coordinates, 13 structural parameters were calculated, compared and evaluated using statistical methods. This study is distinguished from earlier ones by the strict quality control of the structures used and the size of the data set.Conclusions: Different protein families adapt to higher temperatures by different sets of structural devices. Regarding the structural parameters, the only generally observed rule is an increase in the number of ion pairs with increasing growth temperature. Other parameters show just a trend, whereas the number of hydrogen bonds and the polarity of buried surfaces exhibit no clear-cut tendency to change with growth temperature. Proteins from extreme thermophiles are stabilized in different ways to moderately thermophilic ones. The preferences of these two groups are different with regards to the number of ion pairs, the number of cavities, the polarity of exposed surface and the secondary structural composition

Dielectronic Recombination of Ground-State and Metastable Li+ Ions

Dielectronic recombination has been investigated for Delta-n = 1 resonances of ground-state Li+(1s^2) and for Delta-n = 0 resonances of metastable Li+(1s2s ^3S). The ground-state spectrum shows three prominent transitions between 53 and 64 eV, while the metastable spectrum exhibits many transitions with energies < 3.2 eV. Reasonably good agreement of R-matrix, LS coupling calculations with the measured recombination rate coefficient is obtained. The time dependence of the recombination rate yields a radiative lifetime of 52.2 +- 5.0 s for the 2 ^3S level of Li+.Comment: Submitted to Phys. Rev. A; REVTeX, 4 pages, 3 figure

Cleavage of Kininogen and Subsequent Bradykinin Release by the Complement Component: Mannose-Binding Lectin-Associated Serine Protease (MASP)-1

Bradykinin (BK), generated from high-molecular-weight kininogen (HK) is the major mediator of swelling attacks in hereditary angioedema (HAE), a disease associated with C1-inhibitor deficiency. Plasma kallikrein, activated by factor XIIa, is responsible for most of HK cleavage. However other proteases, which activate during episodes of angioedema, might also contribute to BK production. The lectin pathway of the complement system activates after infection and oxidative stress on endothelial cells generating active serine proteases: MASP-1 and MASP-2. Our aim was to study whether activated MASPs are able to digest HK to release BK. Initially we were trying to find potential new substrates of MASP-1 in human plasma by differential gel electrophoresis, and we identified kininogen cleavage products by this proteomic approach. As a control, MASP-2 was included in the study in addition to MASP-1 and kallikrein. The proteolytic cleavage of HK by MASPs was followed by SDS-PAGE, and BK release was detected by HPLC. We showed that MASP-1 was able to cleave HK resulting in BK production. MASP-2 could also cleave HK but could not release BK. The cleavage pattern of MASPs is similar but not strictly identical to that of kallikrein. The catalytic efficiency of HK cleavage by a recombinant version of MASP-1 and MASP-2 was about 4.0×102 and 2.7×102 M−1s−1, respectively. C1-inhibitor, the major inhibitor of factor XIIa and kallikrein, also prevented the cleavage of HK by MASPs. In all, a new factor XII- and kallikrein-independent mechanism of bradykinin production by MASP-1 was demonstrated, which may contribute to the pro-inflammatory effect of the lectin pathway of complement and to the elevated bradykinin levels in HAE patients

New type of interaction between the SARAH domain of the tumour suppressor RASSF1A and its mitotic kinase Aurora A

Abstract The tumour suppressor protein RASSF1A is phosphorylated by Aurora A kinase, thereby impairing its tumour suppressor function. Consequently, inhibiting the interaction between Aurora A and RASSF1A may be used for anti-tumour therapy. We used recombinant variants of RASSF1A to map the sites of interaction with Aurora A. The phosphorylation kinetics of three truncated RASSF1A variants has been analysed. Compared to the RASSF1A form lacking the 120 residue long N-terminal part, the K m value of the phosphorylation is increased from 10 to 45 μM upon additional deletion of the C-terminal SARAH domain. On the other hand, deletion of the flexible loop (Δ177–197) that precedes the phosphorylation site/s (T202/S203) results in a reduction of the k cat value from about 40 to 7 min−1. Direct physical interaction between the isolated SARAH domain and Aurora A was revealed by SPR. These data demonstrate that the SARAH domain of RASSF1A is involved in the binding to Aurora A kinase. Structural modelling confirms that a novel complex is feasible between the SARAH domain and the kinase domain of Aurora A. In addition, a regulatory role of the loop in the catalytic phosphorylation reaction has been demonstrated both experimentally and by structural modelling

Towards the virtual artery: a multiscale model for vascular physiology at the physics–chemistry–biology interface

This discussion paper introduces the concept of the Virtual Artery as a multiscale model for arterial physiology and pathologies at the physics–chemistry–biology (PCB) interface. The cellular level is identified as the mesoscopic level, and we argue that by coupling cell-based models with other relevant models on the macro- and microscale, a versatile model of arterial health and disease can be composed. We review the necessary ingredients, both models of arteries at many different scales, as well as generic methods to compose multiscale models. Next, we discuss how this can be combined into the virtual artery. Finally, we argue that the concept of models at the PCB interface could or perhaps should become a powerful paradigm, not only as in our case for studying physiology, but also for many other systems that have such PCB interfaces

Loss of α4A- and β1-tubulins leads to severe platelet spherocytosis and strongly impairs hemostasis in mice

Native circulating blood platelets present with a discoid flat morphology maintained by a submembranous peripheral ring of microtubules, named marginal band. The functional importance of this particular shape is still debated, but it was initially hypothesized to facilitate platelet interaction with the injured vessel wall and to contribute to hemostasis. The importance of the platelet discoid morphology has since been questioned on the absence of clear bleeding tendency in mice lacking the platelet-specific β1-tubulin isotype, which exhibits platelets with a thinner marginal band and an ovoid shape. Here, we generated a mouse model inactivated for β1-tubulin and α4A-tubulin, an α-tubulin isotype strongly enriched in platelets. These mice present with fully spherical platelets completely devoid of a marginal band. In contrast to the single knockouts, the double deletion resulted in a severe bleeding defect in a tail-clipping assay, which was not corrected by increasing the platelet count to normal values by the thrombopoietin-analog romiplostim. In vivo, thrombus formation was almost abolished in a ferric chloride–injury model, with only a thin layer of loosely packed platelets, and mice were protected against death in a model of thromboembolism. In vitro, platelets adhered less efficiently and formed smaller-sized and loosely assembled aggregates when perfused over von Willebrand factor and collagen matrices. In conclusion, this study shows that blood platelets require 2 unique α- and β-tubulin isotypes to acquire their characteristic discoid morphology. Lack of these 2 isotypes has a deleterious effect on flow-dependent aggregate formation and stability, leading to a severe bleeding disorder