Investigation of input and output energy for wheat production : a comprehensive study for Tehsil Mailsi (Pakistan)

The global increasing food demand can be met by efficient energy utilization in mechanized agricultural productions. In this study, input–output energy flow along with CO2 emissions for different wheat production cases (C-I to C-V) were investigated to identify the one that is most energy-efficient and environment-friendly case. Data and information about input and output sources were collected from farmers through questionnaires and face-to-face interviews. Input and output sources were converted into energy units by energy equivalents while CO2 emissions were calculated by emission equivalents. Data envelopment analysis (DEA) was conducted to compare technical efficiencies of the developed cases for optimization of inputs in inefficient cases. Results revealed that case C-Ⅴ (higher inputs, larger fields, the tendency of higher fertilizer application and tillage operations) has the highest energy inputs and outputs than the rest of the cases. Moreover, it possesses the lowest energy use efficiency and energy productivity. The highest CO2 emissions (1548 kg-CO2/ha) referred to C-Ⅴ while lowest emissions per ton of grain yield were determined in C-Ⅳ (higher electricity water pumping, moderate energy input). The grain yield increases directly with input energy in most of the cases, but it does not guarantee the highest values for energy indices. C-Ⅲ (moderate irrigations, educated farmers, various fertilizer applications) was found as an optimum case because of higher energy indices like energy use efficiency of 4.4 and energy productivity of 153.94 kg/GJ. Optimum input and better management practices may enhance energy proficiency and limit the traditionally uncontrolled CO2 emissions from wheat production. Therefore, the agricultural practices performed in C-Ⅲ are recommended for efficient cultivation of wheat in the studied area.The global increasing food demand can be met by efficient energy utilization in mechanized agricultural productions. In this study, input–output energy flow along with CO2 emissions for different wheat production cases (C-I to C-V) were investigated to identify the one that is most energy-efficient and environment-friendly case. Data and information about input and output sources were collected from farmers through questionnaires and face-to-face interviews. Input and output sources were converted into energy units by energy equivalents while CO2 emissions were calculated by emission equivalents. Data envelopment analysis (DEA) was conducted to compare technical efficiencies of the developed cases for optimization of inputs in inefficient cases. Results revealed that case C-Ⅴ (higher inputs, larger fields, the tendency of higher fertilizer application and tillage operations) has the highest energy inputs and outputs than the rest of the cases. Moreover, it possesses the lowest energy use efficiency and energy productivity. The highest CO2 emissions (1548 kg-CO2/ha) referred to C-Ⅴ while lowest emissions per ton of grain yield were determined in C-Ⅳ (higher electricity water pumping, moderate energy input). The grain yield increases directly with input energy in most of the cases, but it does not guarantee the highest values for energy indices. C-Ⅲ (moderate irrigations, educated farmers, various fertilizer applications) was found as an optimum case because of higher energy indices like energy use efficiency of 4.4 and energy productivity of 153.94 kg/GJ. Optimum input and better management practices may enhance energy proficiency and limit the traditionally uncontrolled CO2 emissions from wheat production. Therefore, the agricultural practices performed in C-Ⅲ are recommended for efficient cultivation of wheat in the studied area.King Saud University, Riyadh, Saudi Arabi

Technical Change, Efficiency, and Capital-labour Substitution in Pakistan's Large-scale Manufacturing Sector

Pakistan's manufacturing sector is characterised by relatively high capital intensity and the level of absorption of labour in industry is low. This paper estimates the elasticities of substitution in Pakistan's large-scale manufacturing sector to determine the potential for switching to relatively more labour-intensive production techniques. Data for the years 1960 to 1986 have been used and a total of seventeen industry groups have been analysed. This involved the aggregation of data from the Census of Manufacturing Industries (CMI). Industry groups were aggregated while keeping in mind the structural and economic similarities within the groups. The functional form used for the estimation is the CES production function and direct estimation procedures have been used. Industries in Pakistan are generally considered to be characterised by low substitution between capital and labour, near-constant returns to scale, high capital intensity, and low exogenous technical change. The results of this study bear this out with a few exceptions and the policy implications are interesting. The level of capital intensity in the manufacturing sector is not commensurate with the relative factor endowments, and there is a need to redirect the industries towards greater use of labour-intensive technology. In the short term, there appears to be little scope for altering the capital-labour ratios in the manufacturing sector. In the long run, however, measures aimed at the gradual replacement of capital with labour in production techniques may come to fruition.

Previously described sequence variant in CDK5RAP2 gene in a Pakistani family with autosomal recessive primary microcephaly

<p>Abstract</p> <p>Background</p> <p>Autosomal Recessive Primary Microcephaly (MCPH) is a disorder of neurogenic mitosis. MCPH leads to reduced cerebral cortical volume and hence, reduced head circumference associated with mental retardation of variable degree. Genetic heterogeneity is well documented in patients with MCPH with six loci known, while pathogenic sequence variants in four respective genes have been identified so far. Mutations in <it>CDK5RAP2 </it>gene at MCPH3 locus have been least involved in causing MCPH phenotype.</p> <p>Methods</p> <p>All coding exons and exon/intron splice junctions of <it>CDK5RAP2 </it>gene were sequenced in affected and normal individuals of Pakistani MCPH family of Kashmiri origin, which showed linkage to MCPH3 locus on chromosome 9q33.2.</p> <p>Results</p> <p>A previously described nonsense mutation [243 T>A (S81X)] in exon 4 of <it>CDK5RAP2 </it>gene has been identified in the Pakistani family, presented here, with MCPH Phenotype. Genomic and cDNA sequence comparison revealed that the exact nomenclature for this mutation is 246 T>A (Y82X).</p> <p>Conclusion</p> <p>Recurrent observation of Y82X mutation in <it>CDK5RAP2 </it>gene in this Pakistani family may be a sign of confinement of a rare ancestral haplotype carrying this pathogenic variant within Northern Pakistani population, as this has not been reported in any other population.</p

Improved accessibility of emergency obstetrics and newborn care (EmONC) services for maternal and newborn health: a community based project

Background: Every year an estimated three million neonates die globally and two hundred thousand of these deaths occur in Pakistan. Majority of these neonates die in rural areas of underdeveloped countries from preventable causes (infections, complications related to low birth weight and prematurity). Similarly about three hundred thousand mother died in 2010 and Pakistan is among ten countries where sixty percent burden of these deaths is concentrated. Maternal and neonatal mortality remain to be unacceptably high in Pakistan especially in rural areas where more than half of births occur. Method/Design: This community based cluster randomized controlled trial will evaluate the impact of an Emergency Obstetric and Newborn Care (EmONC) package in the intervention arm compared to standard of care in control arm. Perinatal and neonatal mortality are primary outcome measure for this trial. The trial will be implemented in 20 clusters (Union councils) of District Rahimyar Khan, Pakistan. The EmONC package consists of provision of maternal and neonatal health pack (clean delivery kit, emollient, chlorhexidine) for safe motherhood and newborn wellbeing and training of community level and facility based health care providers with emphasis on referral of complicated cases to nearest public health facilities and community mobilization. Discussion: Even though there is substantial evidence in support of effectiveness of various health interventions for improving maternal, neonatal and child health. Reduction in perinatal and neonatal mortality remains a big challenge in resource constrained and diverse countries like Pakistan and achieving MDG 4 and 5 appears to be a distant reality. A comprehensive package of community based low cost interventions along the continuum of care tailored according to the socio cultural environment coupled with existing health force capacity building may result in improving the maternal and neonatal outcomes. The findings of this proposed community based trial will provide sufficient evidence on feasibility, acceptability and effectiveness to the policy makers for replicating and scaling up the interventions within the health syste

Delay in diagnosis of tuberculosis in Rawalpindi, Pakistan

<p>Abstract</p> <p>Background</p> <p>Delay in diagnosis and treatment of tuberculosis (TB) may enhance the chances of morbidity and mortality and play a key role in continuous transmission of the bacilli. The objective of this study was to describe health care seeking behavior of suspected TB patients and initial diagnostic work up prior to consultation and diagnosis at National TB Center (NTC).</p> <p>Findings</p> <p>Interviews of 252 sputum smear positive patients were taken from NTC, Rawalpindi. The duration between on-set of symptoms and start of treatment was considered as the total delay and correlated with general characteristics of TB patients. The proportion of males and females were 49.6% and 50.4% with median age of 25 and 24 years respectively. A median delay of 56 days (8 weeks) was observed which was significantly associated with age, cough and fever. More than 50% of the current patients had a history of contact with previously diagnosed TB patients. The majority of patients (63%) visited health care providers within three weeks of appearance of symptoms but only thirty five percent were investigated for TB diagnosis.</p> <p>Conclusion</p> <p>Cough and fever are being ignored as likely symptoms of TB by patients as well as health care providers resulting in delay. Engaging private practitioners through public private mix (PPM) approach for expansion of TB diagnosis and increasing public awareness could be more beneficial to reduce delay.</p

Evaluation of internet access and utilization by medical students in Lahore, Pakistan

<p>Abstract</p> <p>Background</p> <p>The internet is increasingly being used worldwide in imparting medical education and improving its delivery. It has become an important tool for healthcare professionals training but the data on its use by medical students in developing countries is lacking with no study on the subject from Pakistan. This study was, therefore, carried out with an aim to evaluate the pattern of internet access and utilization by medical students in Pakistan.</p> <p>Methods</p> <p>A structured pre-tested questionnaire was administered to a group of 750 medical students in clinical years studying at various public and private medical colleges in Lahore. The questions were related to patterns of internet access, purpose of use and self reported confidence in performing various internet related tasks, use of health related websites to supplement learning and the problems faced by students in using internet at the institution.</p> <p>Results</p> <p>A total of 532 medical students (70.9%) returned the questionnaire. The mean age of study participants was 21.04 years (SD 1.96 years). Majority of the respondents (84.0%) reported experience with internet use. About half of the students (42.1%) were using internet occasionally with 23.1%, 20.9% and 13.9% doing so frequently, regularly and rarely respectively. About two third of the students (61.0%) stated that they use internet for both academic and professional activities. Most of the participants preferred to use internet at home (70.5%). Self reported ability to search for required article from PubMed and PakMedinet was reported by only 34.0% of the entire sample. Students were moderately confident in performing various internet related tasks including downloading medical books from internet, searching internet for classification of diseases and downloading full text article. Health related websites were being accessed by 55.1% students to supplement their learning process. Lack of time, inadequate number of available computers and lack of support from staff were cited as the most common problems faced by students while accessing internet in the institution premises. There were significant differences among male and female students with respect to the place of internet use (p = 0.001) and the ability to search online databases for required articles (p = 0.014).</p> <p>Conclusions</p> <p>Majority of the medical students in this study had access to internet and were using it for both academic and personal reasons. Nevertheless, it was seen that there is under utilization of the potential of internet resources to augment learning. Increase in awareness, availability of requisite facilities and training in computing skills are required to enable better utilization of digital resources of digital resources by medical students.</p

Constraints on the χ_(c1) versus χ_(c2) polarizations in proton-proton collisions at √s = 8 TeV

The polarizations of promptly produced χ_(c1) and χ_(c2) mesons are studied using data collected by the CMS experiment at the LHC, in proton-proton collisions at √s=8  TeV. The χ_c states are reconstructed via their radiative decays χ_c → J/ψγ, with the photons being measured through conversions to e⁺e⁻, which allows the two states to be well resolved. The polarizations are measured in the helicity frame, through the analysis of the χ_(c2) to χ_(c1) yield ratio as a function of the polar or azimuthal angle of the positive muon emitted in the J/ψ → μ⁺μ⁻ decay, in three bins of J/ψ transverse momentum. While no differences are seen between the two states in terms of azimuthal decay angle distributions, they are observed to have significantly different polar anisotropies. The measurement favors a scenario where at least one of the two states is strongly polarized along the helicity quantization axis, in agreement with nonrelativistic quantum chromodynamics predictions. This is the first measurement of significantly polarized quarkonia produced at high transverse momentum