Characterization of Metal and Metal Alloy Films as Contact Materials in MEMS Switches

This study presents a basic step toward the selection methodology of electric contact materials for microelectromechanical systems (MEMS) metal contact switches. This involves the interrelationship between two important parameters, resistivity and hardness, since they provide the guidelines and assessment of contact resistance, wear, deformation and adhesion characteristics of MEMS switches. For this purpose, thin film alloys of three noble metals, platinum (Pt), rhodium (Rh) and ruthenium (Ru) with gold (Au), were investigated. The interrelationship between resistivity and hardness was established for three levels of alloying of these metals with gold. Thin films of gold (Au), platinum (Pt), ruthenium (Rh) and rhodium (Ru) were also characterized to obtain their baseline data for comparison. All films were deposited on silicon substrates. When Ru, Rh and Pt are alloyed with Au, their hardness generally decreases but resistivity increases. This decrease or increase was, in general, dependent upon the amount of alloying

Nanoindentation Technique for Characterizing Cantilever Beam Style RF Microelectromechanical Systems (MEMS) Switches

A nanoindentation technique was used to mechanically actuate a radio frequency micro-switch along with the measurement of contact resistance to investigate its applicability to characterize deflection and contact resistance behaviors of micro-sized cantilever beam switches. The resulting load–displacement relationship showed a discontinuity in slope when the micro-switch closed. The measured spring constants reasonably agreed with theoretical values obtained from the simple beam models. The change in contact resistance during test clearly indicated micro-switch closure but it did not coincide exactly with the physical contact between two electric contacts due to a resistive contaminated film

Thermal Transport Properties of Dry Spun Carbon Nanotube Sheets

The thermal properties of carbon nanotube- (CNT-) sheet were explored and compared to copper in this study. The CNT-sheet was made from dry spinning CNTs into a nonwoven sheet. This nonwoven CNT-sheet has anisotropic properties in in-plane and out-of-plane directions. The in-plane direction has much higher thermal conductivity than the out-of-plane direction. The in-plane thermal conductivity was found by thermal flash analysis, and the out-of-plane thermal conductivity was found by a hot disk method. The thermal irradiative properties were examined and compared to thermal transport theory. The CNT-sheet was heated in the vacuum and the temperature was measured with an IR Camera. The heat flux of CNT-sheet was compared to that of copper, and it was found that the CNT-sheet has significantly higher specific heat transfer properties compared to those of copper. CNT-sheet is a potential candidate to replace copper in thermal transport applications where weight is a primary concern such as in the automobile, aircraft, and space industries

Functionalization of Carbon Nanotube Yarn by Acid Treatment

Carbon nanotube (CNT) yarn was functionalized using sulfuric and nitric acid solutions in 3:1 volumetric ratio. Successful functionalization of CNT yarn with carboxyl and hydroxyl groups (e.g., COOH, COO–, OH, etc.) was confirmed by attenuated total reflectance spectroscopy. X-ray diffraction revealed no significant change to the atomic in-plane alignment in the CNTs; however, the coherent length along the diameter was significantly reduced during functionalization. A morphology change of wavy extensions protruding from the surface was observed after the functionalization treatment. The force required to fracture the yarn remained the same after the functionalization process; however, the linear density was increased (310%). The increase in linear density after functionalization reduced the tenacity. However, the resistivity density product of the CNT yarn was reduced significantly (234%) after functionalization

High-gradient operators in perturbed Wess-Zumino-Witten field theories in two dimensions

Many classes of non-linear sigma models (NLSMs) are known to contain composite operators with an arbitrary number 2s of derivatives ("high-gradient operators") which appear to become strongly relevant within RG calculations at one (or fixed higher) loop order, when the number 2s of derivatives becomes large. This occurs at many conventional fixed points of NLSMs which are perturbatively accessible within the usual epsilon-expansion in d=2+\epsilon dimensions. Since such operators are not prohibited from occurring in the action, they appear to threaten the very existence of such fixed points. At the same time, for NLSMs describing metal-insulator transitions of Anderson localization in electronic conductors, the strong RG-relevance of these operators has been previously related to statistical properties of the conductance of samples of large finite size ("conductance fluctuations"). In this paper, we analyze this question, not for perturbative RG treatments of NLSMs, but for 2d Wess-Zumino-Witten (WZW) models at level k, perturbatively in the current-current interaction of the Noether current. WZW models are special ("Principal Chiral") NLSMs on a Lie Group G with a WZW term at level k. In these models the role of high-gradient operators is played by homogeneous polynomials of order 2s in the Noether currents, whose scaling dimensions we analyze. For the Lie Supergroup G=GL(2N|2N) and k=1, this corresponds to time-reversal invariant problems of Anderson localization in the so-called chiral symmetry classes, and the strength of the current-current interaction, a measure of the strength of disorder, is known to be completely marginal (for any k). We find that all high-gradient (polynomial) operators are, to one loop order, irrelevant or relevant depending on the sign of that interaction.Comment: 22 page

Serosurveillance for Japanese encephalitis virus infection among equines in India

The seroprevalence of Japanese encephalitis virus (JEV) among equines was evaluated from January 2006 to December 2009 in 13 different states of India by hemagglutination inhibition (HI) test and virus neutralization test (VNT). Antibodies against JEV were detected in 327 out of 3,286 (10%) equines with a maximum prevalence reported in the state of Manipur (91.7%) followed by Gujarat (18.5%), Madhya Pradesh (14.4%), and Uttar Pradesh (11.6%). Evidence of JEV infection was observed in equines in Indore (Madhya Pradesh) where a 4-fold or higher rise in antibody titer was observed in 21 out of 34 horses in November 2007 to October 2006. In March 2008, seven of these horses had a subsequent 4-fold rise in JEV antibody titers while this titer decreased in nine animals. JEV-positive horse sera had a JEV/WNV (West Nile virus) ratio over 2.0 according to the HI and/or VNT. These results indicated that JEV is endemic among equines in India

Black Hole Mass Estimates Based on CIV are Consistent with Those Based on the Balmer Lines

Using a sample of high-redshift lensed quasars from the CASTLES project with observed-frame ultraviolet or optical and near-infrared spectra, we have searched for possible biases between supermassive black hole (BH) mass estimates based on the CIV, Halpha and Hbeta broad emission lines. Our sample is based upon that of Greene, Peng & Ludwig, expanded with new near-IR spectroscopic observations, consistently analyzed high S/N optical spectra, and consistent continuum luminosity estimates at 5100A. We find that BH mass estimates based on the FWHM of CIV show a systematic offset with respect to those obtained from the line dispersion, sigma_l, of the same emission line, but not with those obtained from the FWHM of Halpha and Hbeta. The magnitude of the offset depends on the treatment of the HeII and FeII emission blended with CIV, but there is little scatter for any fixed measurement prescription. While we otherwise find no systematic offsets between CIV and Balmer line mass estimates, we do find that the residuals between them are strongly correlated with the ratio of the UV and optical continuum luminosities. Removing this dependency reduces the scatter between the UV- and optical-based BH mass estimates by a factor of approximately 2, from roughly 0.35 to 0.18 dex. The dispersion is smallest when comparing the CIV sigma_l mass estimate, after removing the offset from the FWHM estimates, and either Balmer line mass estimate. The correlation with the continuum slope is likely due to a combination of reddening, host contamination and object-dependent SED shapes. When we add additional heterogeneous measurements from the literature, the results are unchanged.Comment: Accepted for publication in The Astrophysical Journal. 37 text pages + 8 tables + 23 figures. Updated with comments by the referee and with a expanded discussion on literature data including new observation

Elective cancer surgery in COVID-19-free surgical pathways during the SARS-CoV-2 pandemic: An international, multicenter, comparative cohort study

PURPOSE As cancer surgery restarts after the first COVID-19 wave, health care providers urgently require data to determine where elective surgery is best performed. This study aimed to determine whether COVID-19–free surgical pathways were associated with lower postoperative pulmonary complication rates compared with hospitals with no defined pathway. PATIENTS AND METHODS This international, multicenter cohort study included patients who underwent elective surgery for 10 solid cancer types without preoperative suspicion of SARS-CoV-2. Participating hospitals included patients from local emergence of SARS-CoV-2 until April 19, 2020. At the time of surgery, hospitals were defined as having a COVID-19–free surgical pathway (complete segregation of the operating theater, critical care, and inpatient ward areas) or no defined pathway (incomplete or no segregation, areas shared with patients with COVID-19). The primary outcome was 30-day postoperative pulmonary complications (pneumonia, acute respiratory distress syndrome, unexpected ventilation). RESULTS Of 9,171 patients from 447 hospitals in 55 countries, 2,481 were operated on in COVID-19–free surgical pathways. Patients who underwent surgery within COVID-19–free surgical pathways were younger with fewer comorbidities than those in hospitals with no defined pathway but with similar proportions of major surgery. After adjustment, pulmonary complication rates were lower with COVID-19–free surgical pathways (2.2% v 4.9%; adjusted odds ratio [aOR], 0.62; 95% CI, 0.44 to 0.86). This was consistent in sensitivity analyses for low-risk patients (American Society of Anesthesiologists grade 1/2), propensity score–matched models, and patients with negative SARS-CoV-2 preoperative tests. The postoperative SARS-CoV-2 infection rate was also lower in COVID-19–free surgical pathways (2.1% v 3.6%; aOR, 0.53; 95% CI, 0.36 to 0.76). CONCLUSION Within available resources, dedicated COVID-19–free surgical pathways should be established to provide safe elective cancer surgery during current and before future SARS-CoV-2 outbreaks

Elective Cancer Surgery in COVID-19-Free Surgical Pathways During the SARS-CoV-2 Pandemic: An International, Multicenter, Comparative Cohort Study.

PURPOSE: As cancer surgery restarts after the first COVID-19 wave, health care providers urgently require data to determine where elective surgery is best performed. This study aimed to determine whether COVID-19-free surgical pathways were associated with lower postoperative pulmonary complication rates compared with hospitals with no defined pathway. PATIENTS AND METHODS: This international, multicenter cohort study included patients who underwent elective surgery for 10 solid cancer types without preoperative suspicion of SARS-CoV-2. Participating hospitals included patients from local emergence of SARS-CoV-2 until April 19, 2020. At the time of surgery, hospitals were defined as having a COVID-19-free surgical pathway (complete segregation of the operating theater, critical care, and inpatient ward areas) or no defined pathway (incomplete or no segregation, areas shared with patients with COVID-19). The primary outcome was 30-day postoperative pulmonary complications (pneumonia, acute respiratory distress syndrome, unexpected ventilation). RESULTS: Of 9,171 patients from 447 hospitals in 55 countries, 2,481 were operated on in COVID-19-free surgical pathways. Patients who underwent surgery within COVID-19-free surgical pathways were younger with fewer comorbidities than those in hospitals with no defined pathway but with similar proportions of major surgery. After adjustment, pulmonary complication rates were lower with COVID-19-free surgical pathways (2.2% v 4.9%; adjusted odds ratio [aOR], 0.62; 95% CI, 0.44 to 0.86). This was consistent in sensitivity analyses for low-risk patients (American Society of Anesthesiologists grade 1/2), propensity score-matched models, and patients with negative SARS-CoV-2 preoperative tests. The postoperative SARS-CoV-2 infection rate was also lower in COVID-19-free surgical pathways (2.1% v 3.6%; aOR, 0.53; 95% CI, 0.36 to 0.76). CONCLUSION: Within available resources, dedicated COVID-19-free surgical pathways should be established to provide safe elective cancer surgery during current and before future SARS-CoV-2 outbreaks

Variational solution for a cracked mosaic model of woven fabric composites

A variational solution for a cracked mosaic laminate model of woven fabric composites is presented using the principle of minimum complementary energy. The solution is derived for the woven laminate in either the plane strain or the plane stress state, with the warp/fill yarn materials being either orthotropic or transversely isotropic, unlike other existing solutions in the literature of laminate elasticity. The stress components are given in closed-form expressions in terms of a perturbation function, which is governed by two (uncoupled) fourth-order inhomogeneous ordinary differential equations (i.e., Euler-Lagrange equations) when the thermal effects are included. All possible expressions of this perturbation function are obtained in closed forms. Young\u27s modulus of the cracked laminate is calculated using the determined minimum complementary energy. The present closed-form solution can account for different yarn materials, applied loads (crack densities), geometrical dimensions, or their combinations. To demonstrate the solution, a total of 60 sample cases are analyzed using three different composite systems (i.e., glass fiber/epoxy, graphite fiber/ epoxy and ceramic fiber/ceramic) and ten different crack densities. The obtained numerical results are also compared to two existing elasticity solutions for cross-ply laminates. © 2001 Elsevier Science Ltd. All rights reserved